Abstract
The lateral surface distortion of a cylindrical blank during upsetting with contact friction is analyzed. Formulas explicitly describing the change in the convex lateral surface during deformation are obtained for the first time. The accuracy of the formulas is confirmed by comparison with experimental data.
Similar content being viewed by others
References
Tarnovskii, I.Ya., Pozdeev, A.A., Ganago, O.A., et al., Teoriya obrabotki metallov davleniem (Theory of the Pressure Treatment of Metals), Moscow: Metallurgizdat, 1963.
Stepanovskii, L.G., Raschety protsessov obrabotki metallov davleniem (Calculation of the Pressure Treatment of Metals), Moscow: Mashinostroenie, 1979.
Shevchenko, K.N., Osnovy matematicheskikh metodov v teorii obrabotki metallov davleniem (Mathematical Principles in the Theory of the Pressure Treatment of Metals), Moscow: Vysshaya Shkola, 1970.
Kolmogorov, V.L., Golomidov, A.I., Karpov, S.V., and Fedotov, V.P., Mathematical Simulation of Free Forging (Upsetting) on the Basis of the Variational Problem for an Unconditional Extremum, Izv. Vyssh. Uchebn. Zaved., Chern. Metall., 1981, no. 12, pp. 94–97.
Vorontsov, A.L., Teoriya malootkhodnoi shtampovki (Theory of Low-Waste Stamping), Moscow: Mashinostroenie, 2005.
Vorontsov, A.L., Teoriya shtampovki vydavlivaniem (Theory of Pressure Stamping), Moscow: Mashinostroenie, 2004.
Okhrimenko, Ya.M. and Tyurin, V.A., Teoriya protsessov kovki (Theory of Forging Processes), Moscow: Vysshaya Shkola, 1977.
Golovin, V.A., Dmitriev, A.M., and Vorontsov, A.L., Tekhnologiya kovki i ob’emnoi shtampovki. Ch. 2. Malootkhodnaya ob’emnaya shtampovka. Uchebnik dlya vuzov (Forging and Bulk Stamping, Vol. 2: Low-Waste Bulk Stamping: A University Textbook) Moscow: Mashinostroenie, 2004.
Storozhev, M.V. and Popov, E.A., Teoriya obrabotki metallov davleniem (Theory of the Pressure Treatment of Metals), Moscow: Mashinostroenie, 1977.
Author information
Authors and Affiliations
Additional information
Original Russian Text © A.L. Vorontsov, 2009, published in Vestnik Mashinostroeniya, 2009, No. 7, pp. 68–75.
About this article
Cite this article
Vorontsov, A.L. Change in geometry of a cylindrical blank in upsetting with contact friction. Russ. Engin. Res. 29, 705–713 (2009). https://doi.org/10.3103/S1068798X09070144
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X09070144