Skip to main content
SpringerLink
Log in

Study of the Elemental Composition and Wear Resistance of Coatings Obtained by Plasma Electrolytic Oxidation

  • Published:
Steel in Translation Aims and scope

Abstract

The results of studies of the elemental composition and wear resistance of coatings formed by plasma-electrolytic oxidation on aluminum alloys are presented. As a result of X-ray spectral analysis, the distribution of chemical elements was revealed, which makes it possible, to a certain extent, to judge the influence of the electrolyte used and the chemical composition of the oxidized alloy on the elemental composition of the oxide-ceramic coating. It was established that the wear rate of coatings is 4.3–4.8 times lower than that of aluminum alloys without coatings. Electrolyte composition for plasma-electrolytic oxidation of aluminum alloys was recommended.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.
Fig. 7.
Fig. 8.
Fig. 9.
Fig. 10.

REFERENCES

  1. Siluminov, I.V., Epel’fel’d, A.V., Lyudin, V.B., et al., Mikrodugovoe oksidirovanie (teoriya, tekhnologiya, oborudovanie) (Microarc Oxidation: Theory, Technology, Equipment), Moscow: Ekomet, 2005.

  2. Dehnavi, V., Liu, X.Ya., Luan, B.L., Rohani, S., and Shoesmith, D.W., Effect of heating cycles on phase transformation in ceramic coatings produced by plasma electrolytic oxidation of Al6061 alloy, Int. Conf. on Materials Heat Treatment (ICMH 2012), Isfahan, Iran: 2012.

  3. Kolomeichenko, A.V., Tekhnologiya vosstanovleniya i uprochneniya detalei sel’skokhozyaistvennoi tekhniki mikrodugovym oksidirovaniem (Technology of Restoration and Hardening of Agricultural Machinery by Microarc Oxidation), Orel: OrelGAU, 2013.

  4. Chen, P.-Yu., Wu, Ch.-Ch., Fan, Ya.-T., and Lin, Sh.-D., Nano-scale oxide layer prepared by plasma oxidation on single-crystalline aluminum film,, 2016, pp. 809–811. https://doi.org/10.1109/NANO.2016.7751449

  5. Xiang, N., Song, R.-G., Zhuang, J.-J., Song, R.-X., Lu, X.-Ya., and Su, X.-P., Effects of current density on microstructure and properties of plasma electrolytic oxidation ceramic coatings formed on 6063 aluminum alloy, Trans. Nonferrous Met. Soc. China, 2016, vol. 26, no. 3, pp. 806–813. https://doi.org/10.1016/s1003-6326(16)64171-7

    Article  CAS  Google Scholar 

  6. Kolomeichenko, A.V., Sharifullin, S.N., Kuznetsov, Yu.A., Logachev, V.N., and Titov, N.V., Increase of the resource of machine parts working by combined methods using plasma electrolytic oxidation, J. Phys.: Conf. Ser., 2018, vol. 1058, p. 012074. https://doi.org/10.1088/1742-6596/1058/1/012074

    Article  CAS  Google Scholar 

  7. Kuznetsov, Yu.A., Combined technology of production of ceramic coatings, Weld. international, 2005, vol. 19, no. 11, pp. 894–896. https://doi.org/10.1533/wint.2005.3553

  8. Ponomarev, I.S. and Krivonosova, E.A., Microarc oxidation of aluminum alloys for operation with typical industrial power supplies, Sovrem. Probl. Nauki Obraz., 2014, no. 6. http://science-education.ru/ru/article/view?id=16037. Cited April 10, 2017.

  9. Kuznetsov, Yu.A., Kravchenko, I.N., Goncharenko, V.V., and Glinskii, M.A., Machining of the ceramic oxide coating formed by plasma electrolytic oxidation, Russ. Metall., 2018, vol. 2018, pp. 1268–1272. https://doi.org/10.1134/S003602951813013X

    Article  ADS  Google Scholar 

  10. Kuznetsov, Yu.A., Kolomeichenko, A.V., Goncharenko, V.V., and Kravchenko, I.N., Investigation of internal stresses in thin layer oxide coatings on aluminum alloys, Mater. Sci. Forum, 2019, vol. 968, pp. 153–160. https://doi.org/10.4028/www.scientific.net/msf.968.153

  11. Tihonenko, V.V. and Shkilko, A.M., Method of micro-arc oxidation, East Eur. J. Adv. Technol., 2012, vol. 2, no. 13, pp. 13–18.

    Google Scholar 

  12. Wen, L., Wang, Ya., Jin, Yi., Liu, B., Zhou, Yu., and Sun, D., Microarc oxidation of 2024 Al alloy using spraying polar and its influence on microstructure and corrosion behavior, Surf. Coat. Technol., 2013, vol. 228, pp. 92–99. https://doi.org/10.1016/j.surfcoat.2013.04.013

    Article  CAS  Google Scholar 

  13. Krivonosova, Ye.A., Gorchakov, A.I., and Scherbakov, Yu.V., Structure and properties of coatings in microarc oxidation, Weld. Int., 2014, vol. 28, no. 10, pp. 816–819. https://doi.org/10.1080/09507116.2013.868099

    Article  Google Scholar 

  14. Tran, Q.-Ph., Kuo, Yu-Ch., Sun, J.-K., He, J.-L., and Chin, Ts.-Sh., High quality oxide-layers on Al-alloy by micro-arc oxidation using hybrid voltages, Surf. Coat. Technol., 2016, vol. 303, pp. 61–67. https://doi.org/10.1016/j.surfcoat.2016.03.049

    Article  CAS  Google Scholar 

  15. Kuznetsov, Yu.A., Markov, M.A., Krasikov, A.V., Bystrov, R.Yu., Belyakov, A.N., Bykova, A.D., Makarov, A.M., and Fadin, Yu.A., Formation of wear-and corrosion-resistant ceramic coatings by combined technologies of spraying and micro-arc oxidation, Russ. J. Appl. Chem., 2019, vol. 92, no. 7, pp. 875–882. https://doi.org/10.1134/S1070427219070012

    Article  CAS  Google Scholar 

  16. Fedorov, V.A., Development of foundations of application of light alloys as materials of triboengineering purpose due to formation of surface ceramic layer, Cand. (Eng.) Sci. Dissertation, Moscow, 1995.

  17. Yu, K.A., Kravchenko, I.N., Sirotov, A.V., and Chekha, T.A., Investigation of adhesion and wear resistance of coatings deposited with use of combined technology, Remont. Vosstanovlenie. Modernizatsiya, 2018, no. 7, pp. 28–33. https://doi.org/10.31044/1684-2561-2018-0-7-28-33

  18. Kosenko, A., Kolomeichenko, A.V., Kuznetsov, Yu.A., Titov, N.V., Solovyev, R.Yu., and Sharifullin, S.N., Investigation of coating thickness obtained by plasma electrolytic oxidation on aluminium alloys in electrolytes of type “KOH–H3BO3”, J. Phys.: Conf. Ser., 2018, vol. 1058, p. 012065. https://doi.org/10.1088/1742-6596/1058/1/012065

    Article  CAS  Google Scholar 

  19. Snezhko, L.A., Udovichenko, Yu.V., and Tikhaya, L.S., Properties of anode-arc coatings formed on aluminum alloys from alkali electrodes, Fiz. Khim. Obrab. Mater., 1989, no. 3, pp. 93–96.

  20. Suminov, I.V., Epel’fel’d, A.V., Lyudin, V.B., Vladimirov, B.V., Zheltukhin, A.V., and Vinogradov, A.V., Effect of electrolyte temperature on characteristics of microarc oxidation coatings, Pribory, 2010, no. 12, pp. 61–63.

  21. Kolomeichenko, A.V., Logachev, V.N., and Titov, N.V., Increasing the lifetime of machine elements using microarc oxidation, Tekhnol. Mashinostr., 2014, no. 9, pp. 34–38.

  22. Kuznetsov, Yu.A., Hardening of machine elements by microarc oxidation, Remont. Vosstanovlenie. Modernizatsiya, 2005, no. 2, pp. 7–8.

  23. Kuznetsov, Yu.A. and Mityureva, N.V., Grinding of aluminum-alloy elements hardened by microarc oxidation, Uprochnyayushchie Tekhnol. Pokrytiya, 2010, no. 2, pp. 38–40.

  24. Kuznetsov, Yu.A., Kravchenko, I.N., Goncharenko, V.V., and Glinskii, M.A., Machining of the ceramic oxide coating formed by plasma electrolytic oxidation, Russ. Metall., 2018, vol. 2018, no. 13, pp. 1268–1272. https://doi.org/10.1134/S003602951813013X

    Article  ADS  Google Scholar 

  25. Kolomeichenko, A.V. and Kravchenko, I.N., Elemental composition and microhardness of the coatings prepared on faced aluminum alloys by plasma electrolytic oxidation in a silicate–alkaline electrolyte, Russ. Metall., 2019, vol. 2019, no. 13, pp. 1410–1413. https://doi.org/10.1134/S0036029519130147

    Article  ADS  Google Scholar 

Download references

Funding

This work was supported by ongoing institutional funding. No additional grants to carry out or direct this particular research were obtained.

Author information

Authors and Affiliations

  1. FSBEI HE “Orel State Agrarian University named after N.V. Parakhina”, 302019, Orel, Russia

    Yu. A. Kuznetsov

  2. FSBIS Institute of Mechanical Engineering named after A.A. Blagonravov RAS (IMASH RAS), 101990, Moscow, Russia

    I. N. Kravchenko

  3. FSBEI “Russian State Agrarian University—Moscow Agricultural Academy named after K.A. Timiryazev”, 127550, Moscow, Russia

    D. I. Petrovskii

Authors
  1. Yu. A. Kuznetsov
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. I. N. Kravchenko
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. D. I. Petrovskii
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to I. N. Kravchenko.

Ethics declarations

The authors of this work declare that they have no conflicts of interest.

Additional information

Translated by K. Gumerov

Publisher’s Note.

Allerton Press remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Kuznetsov, Y.A., Kravchenko, I.N. & Petrovskii, D.I. Study of the Elemental Composition and Wear Resistance of Coatings Obtained by Plasma Electrolytic Oxidation. Steel Transl. 53, 846–850 (2023). https://doi.org/10.3103/S0967091223100133

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.3103/S0967091223100133

Keywords:

Search

Navigation