Abstract
The analysis of flotation tanks and the composition of waste water after hydroabrasive cutting has been carried out. The most optimal design of the treatment unit for waste water treatment of a hydroabrasive machine was been determined. The results of studies aimed at determining the main parameters and the principle of operation of a waste water treatment plant for waste water treatment after the hydroabrasive cutting are presented.
This is a preview of subscription content, log in via an institution to check access.
REFERENCES
Shmanev, V.A., Shulepov, A.P., and Mtsvetkov, A.V., Struinaya gidroabrazivnaya obrabotka Sh71 detalei GTD (Hydraulic Jet Processing of Sh71 Elements of Gas-Turbine Engines), Moscow: 1995.
Ksenofontov, B.S., Ispol’zovanie mnogostadiinoi modeli flotatsii i razrabotka flotokombainov tipa KBS dlya ochistki vody (Use of Multistage Flotation Model and Development of Flotation Combined Machine of KBS Type for Water Purification), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2019.
Proektirovanie sooruzhenii dlya ochistki stochnykh vod (Design of Facilities of Purification of Waste Waters), Moscow: Vsesoyuz. Kompleks. Nauchn.-Issled. Inst. i Kostruktorsko-Tekhnol. Inst. Vodosnabzheniya, Kanalizatsii, Gidrotekh. Sooruzhenii i Inzh. Gidrogeologii, 1990.
SP 32.13330.2018: Sewerage: Outdoor Networks and Facilities, Moscow: FGUP TsPP, 2018.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The author declares that he has no conflicts of interest.
Additional information
Translated by K. Gumerov
About this article
Cite this article
Baurov, A.A. Determination of the Optimal Design of a Wastewater Treatment Plant after Waterjet Cutting. Steel Transl. 53, 745–747 (2023). https://doi.org/10.3103/S0967091223090036
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091223090036