Abstract
All the enterprises of metallurgical industry produce and use crushed materials obtained by crushing. The share of produced energy spent on crushing is more than 5% in the global energy balance. In this paper, we consider the schematics of a crushing machine with stops on the roll, the design of which forms a complex stress state in the crushed piece under the simultaneous action of normal and shear stresses. It is shown that when generating the complex stress state in the crushed piece of brittle material, the energy consumption is 30–40% less than that when the linear normal stress acts in the piece. The technique has been developed to determine the power of the electric motor drive of an energy-saving crushing machine with stops on a roll at the design stage.
Similar content being viewed by others
REFERENCES
De la Vergne, J.N., Hard Rock Miner’s Handbook, Edmonton, Canada: Stantec Consulting, 2008.
Legendre, D., Numerical and Experimental Optimization Analysis of a Jaw Crusher and a Bubble Column Reactor, Turku, Finland: Åbo Akademi Univ., 2019.
Tselikov, A.I., Polukhin, P.I., Grebenik, V.M., et al., Mashiny i aggregaty metallurgicheskikh zavodov (Machines and Aggregates of Metallurgical Plants), vol. 1: Mashiny i aggregaty domennykh tsekhov (Machines and Aggregates of Blast Furnace Shops), Moscow: Metallurgiya, 1987.
Egbe, E.A.P. and Olugboji, O.A., Design, fabrication and testing of a double roll crusher, Int. J. Eng. Trends Technol., 2016, vol. 35, no. 11, pp. 511–515. https://doi.org/10.14445/22315381/IJETT-V35P303
Evertsson, M., Output prediction of cone crushers, Miner. Eng., 1998, vol. 11, no. 3, pp. 215–231. https://doi.org/10.1016/S0892-6875(98)00001-6
Maslennikov, V.A., Compression crushers, Izv. Vyssh. Uchebn. Zaved. Gornyi Zh., 1996, nos. 10–11, pp. 124–138.
Meriam, J.L. and Kraige, L.G., Engineering Mechanics, Hoboken, N.J., John Wiley and Sons, 2012.
Nikitin, A.G., Lyulenkov, V.I., Laktionov, S.A., Kuznetsov, M.A., and Matekhina, A.N., A method for crushing in a roller crusher, RF Patent 2524536, 2014.
Nikitin, A.G., Epifantsev, Yu.A., Medvedeva, K.S., and Gerike, P.B., Power analysis of the process of brittle materials destruction in universal crushing machine with roll locker, Izv. Ferrous Metall., 2019, vol. 62, no. 4, pp. 303–307. https://doi.org/10.17073/0368-0797-2019-4-303-307
Pytel, A. and Kiusalaas, J., Engineering Mechanics: Statics, Stamford, Conn.: Cengage Learning, 2010.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by M. Astrov
About this article
Cite this article
Nikitin, A.G., Shabunov, M.E. & Gerike, P.B. Capacity Calculations of the Crasher with Stops on a Roll. Steel Transl. 52, 165–166 (2022). https://doi.org/10.3103/S0967091222020140
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091222020140