Abstract
The diameter of the air tuyeres on the blast furnace must be selected not based on the change in the kinetic energy of the fuel-enriched blast flow, but in order to not lose the blast flow rate, especially with weak blowing compressors, to ensure its growth. In this case, it is imperative to keep the optimal total mechanical energies of the fuel-enriched blast and tuyere gas flows on the furnace, which determine the change in the size of the combustion zones and the penetration depth of the gas flow to the hearth center of the blast furnace. Optimum energy values are set by calculation during periods of high-performance furnace operation with low coke consumption. The diameter choice of the tuyeres in terms of kinetic energy leads to errors in the distribution of the gas flow “from the top”, especially when switching from the technology of natural gas injection to the technology of injection of pulverized coal. Attempts to regulate the gas flow “from the bottom” when the pulverized coal is injected by the “top” control methods do not always give a positive result.
Similar content being viewed by others
REFERENCES
Pinchuk, D.V., Otorvin, P.I., Romanchuk, A.V., et al., The technology of blowing pulverized coal into the 5000 m3-volume blast furnace, Trudy Vseukrinskogo nauchno-tekhnicheskoi konferentsii posvyashchennoi 100-letiyu so dnya rozhdeniya G.G. Efimenko, 4–5 aprelya 2017 g. (Proc. All-Ukr. Sci.-Tech. Conf. Dedicated to 100th Anniversary of G.G. Efimenko, April 4–5, 2017), Dnepr: Nats. Metall. Akad. Ukr., 2017, pp. 122–128.
Lyalyuk, V.P., Tarakanov, A.K., Kassim, D.A., et al., Pulverized-coal injection in a 5000-m3 blast furnace, Steel Transl., 2017, vol. 47, no. 10, pp. 675–681.
Lyalyuk, V.P., Sovremennye problemy tekhnologii domennoi plavki (Modern Problems of Technology of the Blast Furnace Fusion), Dnepropetrovsk: Porogi, 1999.
Lyalyuk, V.P., Kamenev, R.D., and Zusmanovskii, A.Ya., The total energy of the blast flow and gas, Stal’, 1999, no. 6, pp. 13–18.
Lyalyuk, V.P. and Tovarovskii, I.G., Selection of the blast furnace conditions on the combined blast with analysis of the parameters of the tuyere zone, Chern. Met., 2003, no. 11, pp. 13–16.
Lyalyuk, V.P., Tarakanov, A.K., Kassim, D.A., and Kucher, I.I., Possibilities for normalization of the gas dynamic mode of blast melting with pulverized coal injection, Steel Transl., 2020, vol. 50, no. 7, pp. 467–472.
Lyalyuk, V.P., The operation of 5000-m3 blast furnace on tuyeres with different diameters and the total mechanical energies of the combined blast and furnace gas flows, Chern. Metall., Byull. Nauchno-Tekh. Ekon. Inf., 2020, no. 7, pp. 691–699.
Lyalyuk, V.P., Tarakanov, A.K., Kassim, D.A., et al., Determining the gas trajectory in blast-furnace injection of pulverized coal, Steel Transl., 2017, vol. 47, no. 4, pp. 257–262.
Moskalina, F.N., Khomich, I.T., Zhembus, M.D., and Ul’yanov, A.G., Operation of 5000-m3 blast furnace, in Opyt ekspluatatsii domennykh pechei ob”emom 3000 m 3 i bol’she (Operation of Blast Furnaces of 3000 m3 Volume and More), Moscow: Metallurgiya, 1982, pp. 5–14.
Shuliko, S.T. and Gerashchenko, V.E., Temperature distribution along the radius of the hearth of the 5000 m3-volume blast furnace, in Voprosy teorii i praktiki proizvodstva chuguna (Theory and Practice of Cast Iron Production), Moscow: Metallurgiya, 1983, pp. 45–50.
Buzoverya, M.T., Moskalina, F.N., and Taranovskii, V.V., The composition of the gas phase and temperature in a blast furnace shaft with a volume of 5000 m3, in Voprosy teorii i praktiki proizvodstva chuguna (Theory and Practice of Cast Iron Production), Moscow: Metallurgiya, 1983, pp. 34–45.
Donskov, E.G., Lyalyuk, V.P., and Donskov, A.D., Gas behavior in blast furnaces, Steel Transl., 2014, vol. 44, no. 3, pp. 209–214.
Lukashov, G.G., Savelov, N.I., and Pliskanovskii, S.T., Operation of blast furnaces with air tuyeres of various diameters, Stal’, 1963, no. 3, pp. 198–201.
Dolmatov, V.A., Glovatskii, A.B., and Khavkin, V.I., Selection of the optimal kinetic energy of blast and elimination of combustion of air tuyeres at the Karaganda Metallurgical Plant, Stal’, 1964, no. 3, pp. 207–210.
Malyshev, A.A., Operation of blast-furnaces with air tuyeres of increased diameter, Metallurgist, 1964, vol. 8, no. 7, pp. 338–340.
Pushkash, I.I., Lazarev, B.L., and Tatsienko, I.A., Forcing the pace of blast-furnaces with increase in the diameter of the air tuyeres, Metallurgist, 1964, vol. 8, no. 7, pp. 341–343.
Varnavskii, I., Rysyukov, N., and Zhuravlev, S., Blast furnace operation on lances of various diameters, Stal’, 1964, no. 10, p. 946.
Sen’ko, G.E. and Starshinov, B.N., Dynamics of kinetic energy of the blast and adjustment of diameter of the air tuyeres using natural gas, Stal’, 1970, no. 2, pp. 107–110.
Zherebkin, B.N., Mishin, P.P., Paren’kov, A.E., et al., Improvement of blast-furnace smelting technology at the Karaganda Metallurgical Plant, Stal’, 1974, no. 12, pp. 1068–1073.
Lyalyuk, V.P., Tarakanov, A.K., Otorvin, P.I., and Kassim, D.A., Blast furnace smelting on tuyeres of different diameters, Chern. Metall., Byull. Nauchno-Tekh. Ekon. Inf., 2012, no. 1, pp. 27–38.
Kryachko, G.Yu. and Avdeev, R.V., The impact of tuyeres with reduced diameter and increased protrusion on the operation of a blast furnace, Chern. Metall., Byull. Nauchno-Tekh. Ekon. Inf., 2005, no. 7, pp. 31–35.
Kotov, K.I., Effect of tuyere diameter and blast kinetic energy on operation of blast furnace, Stal’, 1967, no. 11, pp. 994–996.
Zherebkin, B.N., Minkin, V.M., Nikulinskii, I.D., et al., Effect of some factors on the area of oxidative zone, Stal’, 1956, no. 5, pp. 391–395.
Ostroukhov, M.Ya., Combustion of coke in a blast furnace, Stal’, 1962, no. 7, pp. 598–603.
Bondarenko, A.I. and Ostroukhov, M.Ya., Regulation of gas flow in blast furnace by changing the parameters of air tuyere, Stal’, 1972, no. 7, pp. 587–589.
Lyalyuk, V.P., Fuel combustion at blast-furnace tuyeres, Steel Transl., 2019, vol. 49, no. 1, pp. 39–44.
Lyalyuk, V.P., Tarakanov, A.K., and Kassim, D.A., Total energy of the hearth gas in pulverized-coal injection, Steel Transl., 2017, vol. 47, no. 3, pp. 190–197.
Tarakanov, A.K., Lyalyuk, V.P., Kassim, D.A., et al., Coordination of the batch distribution at the blast-furnace mouth and the gas-flux distribution in the hearth, Steel Transl., 2018, vol. 48, no. 6, pp. 372–375.
Lyalyuk, V.P., Tarakanov, A.K., and Kassim, D.A., UA Patent 103280, Byull. Izobret., 2015, no. 23.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The author declares that he has no conflicts of interest.
Additional information
Translated by S. Avodkova
About this article
Cite this article
Lyalyuk, V.P. Diameter Selection of Blast Furnace Tuyeres Based on the Rate and Energy of the Fuel-Enriched Blast and Tuyere Gas Flows with the Injection of the Pulverized Coal. Steel Transl. 51, 627–639 (2021). https://doi.org/10.3103/S0967091221090072
Received:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091221090072