Abstract
Long multiturn coiled reinforcement may be produced by drawing without torsion. It offers several benefits over existing Vr-1 reinforcement. The influence of the roller inclination and the number of helical turns on the drawing force is studied. The mechanical properties of a four-turn helical profile are compared with those of Vr-1 reinforcement (diameter 4 mm).
Similar content being viewed by others
REFERENCES
Kharitonov, V.A., Current trends in the development of reinforcing mills for non-stressed reinforced concrete: Europe–Russia, Stroimetall, 2011, no. 2, pp. 8–20.
Fastykovskii, A.R., Chinokalov, E.V., Milovanov, A.G., Myskova, N.V., and Shumkin, A.A., Cold-drawn reinforcing wire with screw profile, Metallurgist, 2014, vol. 58, nos. 5–6, pp. 540–544.
Fastykovskii, A.R., Chinokalov, E.V., Amelin, A.V., et al., RF Patent 2553728, Byull. Izobret., 2015, no. 17.
Fastykovskii, A.R., Chinokalov, E.V., Kadykov, V.N., Chinokalov, V.Ya., RF Patent 143099, Byull. Izobret., 2014, no. 19.
Fastykovskii, A.R., Chinokalov, E.V., Leboshkin, B.M., and Efimov, O.Yu., Power consumption reduction during drawing of long screw profiles, Proizvod. Prokata, 2013, no. 10, pp. 40–42.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Fastykovskii, A.R., Chinokalov, E.V. Long Coiled Reinforcement Produced by Drawing. Steel Transl. 49, 481–483 (2019). https://doi.org/10.3103/S0967091219070052
Received:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091219070052