Abstract
Rolling of tall hot strip supplied in an end-to-end sequence to the deformation source is simulated by the finite-element method (on the basis of Deform-3D software). This rolling system hinders nonuniform longitudinal motion of the metal end sections, so that reduced metal losses in trimming by the flying cutters may be expected. In addition, strip capture is less frequent, and hence there are fewer impact loads in the primary line within the mill.
Similar content being viewed by others
References
Khloponin, V.N., Afanas’ev, S.A., and Tinigin, A.N., Improving the Productivity of Continuous Broad-Strip Hot-Rolling Mills and Enhancing Strip Quality, Stal’, 2009, no. 4, pp. 39–42.
Zheleznov, Yu.D., Prokatka rovnykh listov i polos (Rolling of Uniform Sheet and Strip), Moscow: Metallurgiya, 1971.
Ginzburg, V.B., Width Control in Hot Strip Mills, Iron Steel Eng., 1991, June, pp. 25–39.
Tselikov, A.I., Nikitin, G.S., and Rokotyan, S.E., Teoriya prodol’noi prokatki (Theory of Longitudinal Rolling), Moscow: Metallurgiya, 1980.
Pawelski, O. and Piber, V., Possibility and Limits of Deformation in Hot Flat Rolling, Stahl Eisen, 1980, vol. 100, no. 8, pp. 937–949.
Meerovich, I.M., Gertsev, A.I., Babitskii, M.S., et al., Inventor’s Certificate, Byull. Izobret., 1966, no. 20.
Gertsev, A.I., Klassen, E.Ya., Meerovich, I.M., et al., Improving the Shape of Sheet Produced on Thick-Sheet Mills, Tr. VNIImetmash, 1972, vol. 33, pp. 40–53.
Borean, J.-L., Transverse Thermal Profile Mastering on the HSM, Rev. Metall.-CIT, 2006, no. 11, pp. 500–506.
Polukhin, P.I., Gun, G.Ya., and Galkin, A.M. Soprotivlenie plasticheskoi deformatsii metallov i splavov (Resistance of Metals and Alloys to Plastic Deformation), Moscow: Metallurgiya, 1976.
Polukhin, I.P. et al., Rolling Kinematics on a Blooming Mill, Trudy MISiS. Plasticheskaya deformatsiya metallov i splavov (Proceedings of the Moscow Institute of Steel and Alloys: Plastic Deformation of Metals and Alloys), Moscow: Metallurgiya, 1970, pp. 40–48.
Muzalevskii, O.G., Strain-Rate Distribution in the Reduction Zone during Rolling, Stal’, 1962, no. 7, pp. 628–632.
Author information
Authors and Affiliations
Additional information
Original Russian Text © A.N. Tinigin, 2012, published in “Stal’,” 2012, No. 7, pp. 31–35.
About this article
Cite this article
Tinigin, A.N. Rolling of tall hot strip supplied sequentially to the deformation source. Steel Transl. 42, 587–590 (2012). https://doi.org/10.3103/S096709121207011X
Published:
Issue Date:
DOI: https://doi.org/10.3103/S096709121207011X