Abstract
Attention focuses on improvements in the calculation of the basic roller-groove parameters and the selection of an optimal configuration in converting the strip into pipe. The basic characteristics of pipe-electrowelding systems are presented. The influence of the shaping system and the configuration of the equipment on the energy parameters of pipe rolling is investigated. To reduce the number of driven shaping cells in the mill from 8–10 to four, recommendations are made regarding the grooving system and the mill composition. To this end, shaping along the descending trajectory of the lower generatrix is also recommended.
Similar content being viewed by others
References
Khalamez, E.M., Matveev, Yu.M., Zelenyi, N.I., et al., Energosilovye parametry nepreryvnykh truboformovochnykh stanov (Energy Parameters of Continuous Pipe-Shaping Mills), Chelyabinsk: Yuzhno-Ural’skoe Knizhnoe Izdatel’stvo, 1967.
Chekmarev, A.P. and Vatkin, Ya.L., Osnovy prokatki trub v kruglykh kalibrakh (Principles of Pipe Rolling in Round Grooves), Moscow: Metallurgiya, 1962.
Suvorov, V.I., Rymov, V.A., Tsykalov, V.F., et al., Analytical Determination of the Longitudinal Deformation and Shape of the Monotonic Deformation Source for a Pipe Blank, Proizvodstvo svarnykh trub (Welded-Pipe Production), Moscow: Metallurgiya, 1974, no. 3, pp. 55–65.
Suvorov, V.I., Ivantsov, V.Ya., Rymov, V.A., and Finagin, P.M., USSR Inventor’s Certificate, Byull. Izobret., 1977, no. 38.
Author information
Authors and Affiliations
Additional information
Original Russian Text © V.I. Suvorov, M.N. Mozzhegorov, V.L. Pyatkov, N.S. Pluzhnikov, 2011, published in “Stal’,” 2011, No. 2, pp. 40–44.
About this article
Cite this article
Suvorov, V.I., Mozzhegorov, M.N., Pyatkov, V.L. et al. Optimizing the continuous production of electrowelded pipe. Steel Transl. 41, 135–139 (2011). https://doi.org/10.3103/S0967091211020173
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0967091211020173