Abstract
Preventive maintenance (PM) is very important for the safe, efficient, and reliable operation of mechanical systems. This paper focuses on one of the most challenging tasks for PM: PM scheduling. Two basic principles are integrated to support the PM scheduling of mechanical systems: (1) the cost principle, and (2) the reliability principle. These two PM scheduling principles are regarded as conflicting objectives, and the improved strength Pareto evolutionary algorithm is used to find the Pareto-optimal set within which the best compromise solution can be obtained according to fuzzy set theory. Both conceptual and mathematical models of the proposed multi-principle PM scheduling method are explained, and a case study is provided to illustrate the practical application of the new method.
概要
研究目的
为复杂机械产品提供满足整机可靠性指标和维护成本指标的预防性维护方案多准则规划方法。
创新要点
1. 分析了检查、 维修、 更换等对复杂机械产品零部件工作寿命变化的作用机理; 2. 提出了复杂机械产品预防性维护多准则规划方法。
研究方法
1. 基于非完美维修理论, 建立不同模式下零件间工作寿命模型, 定义维修效能因子, 表征检查、 维修、 更换对零件寿命的影响; 2. 通过求解获得复杂机械产品指定时间区间的预防性维护方案, 根据零部件工作寿命, 采取维修和更换等预防性维护措施, 减少零部件故障的发生。
重要结论
零部件的预防性维护次数与其故障因子相关; 机械产品尤其是复杂机械产品实施定期预防性维护能够减少或消除故障的发生。
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Abido, M.A., 2006. Multiobjective evolutionary algorithms for electric power dispatch problem. Evolutionary Computation, IEEE Transactions on, 10(3):315–329. [doi:10.1109/TEVC.2005.857073]
Ahmad, R., Kamaruddin, S., 2012. An overview of time-based and condition-based maintenance in industrial application. Computers & Industrial Engineering, 63(1):135–149. [doi:10.1016/j.cie.2012.02.002]
Alardhi, M., Hannam, R.G., Labib, A.W., 2007. Preventive maintenance scheduling for multi-cogeneration plants with production constraints. Journal of Quality in Maintenance Engineering, 13(3):276–292. [doi:10.1108/13552510710780294]
Andersson, J., 2001. Multi-objective Optimization in Engineering Design: Applications to Fluid Power Systems. PhD Thesis, Division of Fluid and Mechanical Engineering Systems, Department of Mechanical Engineering, Linkopings University, Sweden.
Bartholomew-Biggs, M., Christianson, B., Zuo, M., 2006. Optimizing preventive maintenance models. Computational Optimization and Applications, 35(2):261–279. [doi:10.1007/s10589-006-6449-x]
Cassady, C.R., Kutanoglu, E., 2005. Integrating preventive maintenance planning and production scheduling for a single machine. Reliability, IEEE Transactions on, 54(2): 304–309. [doi:10.1109/TR.2005.845967]
Chakraborty, I., Kumar, V., Nair, S.B., et al., 2003. Rolling element bearing design through genetic algorithms. Engineering Optimization, 35(6):649–659. [doi:10.1080/03052150310001624403]
Chung, S.H., Lau, H.C., Ho, G.T., et al., 2009. Optimization of system reliability in multi-factory production networks by maintenance approach. Expert Systems with Applications, 36(6):10188–10196. [doi:10.1016/j.eswa.2008.12.014]
Ebrahimipour, V., Najjarbashi, A., Sheikhalishahi, M., 2013. Multi-objective modeling for preventive maintenance scheduling in a multiple production line. Journal of Intelligent Manufacturing, p.1–12. [doi:10.1007/s10845-013-0766-6]
El-Ferik, S., Ben-Daya, M., 2006. Age-based hybrid model for imperfect preventive maintenance. IIE Transactions, 38(4):365–375. [doi:10.1080/07408170500232545]
Harrou, F., Tassadit, A., Bouyeddou, B., et al., 2010. Efficient optimization algorithm for preventive-maintenance in transmission systems. Journal of Modelling & Simulation of Systems, 1(1).
Jayabalan, V., Chaudhuri, D., 1992. Cost optimization of maintenance scheduling for a system with assured reliability. Reliability, IEEE Transactions on, 41(1):21–25. [doi:10.1109/24.126665]
Kim, M., Hiroyasu, T., Miki, M., et al., 2004. SPEA2+: improving the performance of the strength Pareto evolutionary algorithm 2. In Parallel problem solving from nature-PPSN VIII, Springer Berlin Heidelberg, p.742–751.
Levitin, G., Lisnianski, A., 2000. Short communication optimal replacement scheduling in multi-state series-parallel systems. Quality and Reliability Engineering International, 16(2):157–162. [doi:10.1002/(SICI)1099-1638(200003/04)16:2〈157::AID-QRE311〉3.0.CO;2-J]
Liao, W., Pan, E., Xi, L., 2010. Preventive maintenance scheduling for repairable system with deterioration. Journal of Intelligent Manufacturing, 21(6):875–884. [doi:10.1007/s10845-009-0264-z]
Lim, J.H., Park, D.H., 2007. Optimal periodic preventive maintenance schedules with improvement factors depending on number of preventive maintenances. Asia-Pacific Journal of Operational Research, 24(01): 111–124.
Lin, T.W., Wang, C.H., 2012. A hybrid genetic algorithm to minimize the periodic preventive maintenance cost in a series-parallel system. Journal of Intelligent Manufacturing, 23(4):1225–1236. [doi:10.1007/s10845-010-0406-3]
Martorell, S., Sánchez, A., Carlos, S., et al., 2002. Comparing effectiveness and efficiency in technical specifications and maintenance optimization. Reliability Engineering & System Safety, 77(3):281–289. [doi:10.1016/S0951-8320(02)00061-3]
Moghaddam, K.S., Usher, J.S., 2011. Preventive maintenance and replacement scheduling for repairable and maintainable systems using dynamic programming. Computers & Industrial Engineering, 60(4):654–665. [doi:10.1016/j.cie.2010.12.021]
Qiu, J., Wang, X., Dai, G., 2014. Improving the indoor localization accuracy for CPS by reorganizing the fingerprint signatures. International Journal of Distributed Sensor Networks, Article No. 415710. [doi:10.1155/2014/415710]
Schutz, J., Rezg, N., Léger, J.B., 2011. Periodic and sequential preventive maintenance policies over a finite planning horizon with a dynamic failure law. Journal of Intelligent Manufacturing, 22(4):523–532. [doi:10.1007/s10845-009-0313-7]
Shirmohammadi, A.H., Zhang, Z.G., Love, E., 2007. A computational model for determining the optimal preventive maintenance policy with random breakdowns and imperfect repairs. Reliability, IEEE Transactions on, 56(2): 332–339. [doi:10.1109/TR.2007.896747]
Tam, A.S.B., Chan, W.M., Price, J.W.H., 2006. Optimal maintenance intervals for a multi-component system. Production Planning and Control, 17(8):769–779. [doi:10.1080/09537280600834452]
Tsai, Y.T., Wang, K.S., Tsai, L.C., 2004. A study of availability-centered preventive maintenance for multi-component systems. Reliability Engineering & System Safety, 84(3): 261–270. [doi:10.1016/j.ress.2003.11.011]
Usher, J.S., Kamal, A.H., Syed, W.H., 1998. Cost optimal preventive maintenance and replacement scheduling. IIE Transactions, 30(12):1121–1128. [doi:10.1023/A:1007 524100829]
Wang, C.H., Lin, T.W., 2011. Improved particle swarm optimization to minimize periodic preventive maintenance cost for series-parallel systems. Expert Systems with Applications, 38(7):8963–8969. [doi:10.1016/j.eswa.2011.01.113]
Wang, C.H., Tsai, S.W., 2014. Optimizing bi-objective imperfect preventive maintenance model for series-parallel system using established hybrid genetic algorithm. Journal of Intelligent Manufacturing, 25(3):603–616. [doi:10.1007/s10845-012-0708-8]
Wang, K.S., Chang, S.T., Shen, Y.C., 1996. Dynamic reliability models for fatigue crack growth problem. Engineering Fracture Mechanics, 54(4):543–556. [doi:10.1016/0013-7944(95)00186-7]
Wang, K.S., Chen, C.S., Huang, J.J., 1997. Dynamic reliability behavior for sliding wear of carburized steel. Reliability Engineering & System Safety, 58(1):31–41. [doi:10.1016/S0951-8320(97)00038-0]
Watanabe, S., Hiroyasu, T., Miki, M., 2002. NCGA: Neighborhood Cultivation Genetic Algorithm for Multi-Objective Optimization Problems. GECCO Late Breaking Papers, p.458–465.
Zitzler, E., Laumanns, M., Thiele, L., 2001. SPEA2: Improving the Performance of the Strength Pareto Evolutionary Algorithm. Technical Report 103, Computer Engineering and Communication Networks Lab (TLK), Swiss Federal Institute of Technology (ETH) Zurich.
Author information
Authors and Affiliations
Corresponding author
Additional information
Project supported by the National Natural Science Foundation of China (Nos. 51205347 and 51322506), the Zhejiang Provincial Natural Science Foundation of China (No. LR14E050003), Project of National Science and Technology Plan (No. 2013IM030500), the Fundamental Research Funds for the Central Universities, the Innovation Foundation of the State Key Laboratory of Fluid Power Transmission and Control, and the Zhejiang University K. P. CHAO’s High Technology Development Foundation, China
An erratum to this article is available at http://dx.doi.org/10.1631/jzus.A14e0102.
Rights and permissions
About this article
Cite this article
Gao, Yc., Feng, Yx. & Tan, Jr. Multi-principle preventive maintenance: a design-oriented scheduling study for mechanical systems. J. Zhejiang Univ. Sci. A 15, 862–872 (2014). https://doi.org/10.1631/jzus.A1400102
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1631/jzus.A1400102