Abstract
The interfacial reaction between eutectic Sn-9 wt% Zn solder and two different kinds of ball-grid-array substrates (Cu and Au/Ni electroplated Cu) during aging at 150 °C and the shear strength of the resulting joints were investigated. In the Sn-9Zn/Cu joints, only Cu5Zn8 intermetallic compound (IMC) was observed between the solder and Cu layer during the first 100 h of aging. After aging for 1000 h, the layer-type Cu5Zn8 IMC layer was disrupted at the interface, causing it to act as a channel for the diffusion of Sn. As a result, Cu6Sn5 and Cu3Sn IMCs were formed underneath the Cu5Zn8 IMC layer. This interfacial reaction significantly degraded the joint strength. In the case of the Au/Ni/Cu substrate, an AuZn3 IMC layer formed at the interface because of the fast reaction between Au and Zn. In addition, the AuZn3 IMC layer became detached from the interface during reflow. The detachment of the AuZn3 IMC layer is presumably from the mismatch in the coefficients of thermal expansion and weak adhesion between the AuZn3 IMC layer and Ni layer caused by the depletion of the Au layer. When the aging time was extended to 100 h, Ni5Zn21 IMC was observed on the Ni substrate. The shear strength of the aged Sn-9Zn/Au/Ni/Cu joint was significantly related to the detachment of the AuZn3 IMC layer. After aging at 150 °C, fracturing occurred on the detached AuZn3 IMC layer. To ensure the reliability of the Sn-Zn/Au/Ni/Cu joint, the detachment of the AuZn3 IMC needs to be prevented.
Similar content being viewed by others
References
M. Abtew, G. Selvaduray: Lead-free solders in microelectronics. Mater. Sci. Eng. R R27, 95 (2000).
K. Zeng, K.N. Tu: Six cases of reliability study of Pb-free solder joints in electronic packaging technology. Mater. Sci. Eng. R 38, 55 (2002).
M.N. Islam, Y.C. Chan, A. Sharif: Interfacial reactions of Sn-Cu and Sn-Pb-Ag solder with Au/Ni during extended time reflow in ball grid array packages. J. Mater. Res. 19, 2897 (2004).
Y.H. Liu, C.M. Chuang, K.L. Lin: Failure behavior upon shear test of 5Sn-95Pb solder bump after high temperature reliability test. J. Mater. Res. 19, 2471 (2004).
M.O. Alam, Y.C. Chan, K.N. Tu: Effect of reaction time and P content on mechanical strength of the interface formed between eutectic Sn-Ag solder and Au/electroless Ni(P)/Cu bond pad. J. Appl. Phys. 94, 4108 (2003).
W.T. Chen, C.E. Ho, C.R. Kao: Effect of Cu concentration on the interfacial reactions between Ni and Sn-Cu solders. J. Mater. Res. 17, 263 (2002).
J.W. Yoon, S.W. Kim, J.M. Koo, D.G. Kim, S.B. Jung: Reliability investigation and interfacial reaction of ball-grid-array packages using the lead-free Sn-Cu solder. J. Electron Mater. 33, 1190 (2004).
C.W. Hwang, K. Suganuma, M. Kiso, S. Hashimoto: Interface microstructures between Ni-P alloy plating and Sn-Ag-(Cu) lead-free solders. J. Mater. Res. 18, 2540 (2003).
Y.C. Sohn, J. Yu, S.K. Kang, D.Y. Shih, T.Y. Lee: Spalling of intermetallic compounds during the reaction between lead-free solders and electroless Ni-P metallization. J. Mater. Res. 19, 2428 (2004).
Z. Chen, M. He, G. Qi: Morphology and kinetic study of the interfacial reaction between the Sn-3.5Ag solder and electroless Ni-P metallization. J. Electron Mater. 33, 1465 (2004).
K.N. Tu, A.M. Gusak, M. Li: Physics and materials challenges for lead-free solders. J. Appl. Phys. 93, 1335 (2003).
J.W. Yoon, C.B. Lee, S.B. Jung: Growth of an intermetallic compound layer with Sn-3.5Ag-5Bi on Cu and Ni-P/Cu during aging treatment. J. Electron Mater. 32, 1195 (2003).
J.W. Jang, D.R. Frear, T.Y. Lee, K.N. Tu: Morphology of interfacial reaction between lead-free solders and electroless Ni-P under bump metallization. J. Appl. Phys. 88, 6359 (2000).
K. Suganuma, T. Murata, H. Noguchi, Y. Toyoda: Heat resistance of Sn-9Zn solder/Cu interface with or without coating. J. Mater. Res. 15, 884 (2000).
K.S. Kim, K.W. Ryu, C.H. Yu, J.M. Kim: The formation and growth of intermetallic compounds and shear strength at Sn-Zn solder/Au-Ni-Cu interfaces. Microelectron Reliab. 45, 647 (2005).
M. Date, K.N. Tu, T. Shoji, M. Fujiyoshi, K. Sato: Interfacial reactions and impact reliability of Sn-Zn solder joints on Cu or electroless Au/Ni(P) bond-pads. J. Mater. Res. 19, 2887 (2004).
Y. Sogo, T. Hojo, H. Iwanishi, A. Hirose, K.F. Kobayashi, A. Yamaguch, A. Furusawa, K. Nishida: Influence of the interfacial reaction layer on reliability of CSP joints using Sn-8Zn-3Bi solder and Ni/Au plating. Mater. Trans. 45, 734 (2004).
C.W. Huang, K.L. Lin: Interfacial reactions of lead-free Sn-Zn based solders on Cu and Cu plated electroless Ni-P/Au layer under aging at 150 °C. J. Mater. Res. 19, 3560 (2004).
S. Vaynman, G. Ghosh, M.E. Fine: Some fundamental issues in the use of Zn-containing lead-free solders for electronic packaging. Mater. Trans. 45, 630 (2004).
A. Hirose, H. Yanagawa, E. Ide, K.F. Kobayashi: Joint strength and interfacial microstructure between Sn-Ag-Cu and Sn-Zn-Bi solders and Cu substrate. Sci. Technol. Adv. Mater. 5, 267 (2004).
S.P. Yu, M.H. Hon, M.C. Wang: The adhesion strength of a lead-free solder hot-dipped on copper substrate. J. Electron Mater. 29, 237 (2000).
C.B. Lee, S.B. Jung, Y.E. Shin, C.C. Shur: Effect of isothermal aging on ball shear strength in BGA joints with Sn-3.5Ag-0.75Cu solder. Mater. Trans. 43, 1858 (2002).
C.W. Hwang, K.S. Kim, K. Suganuma: Interfaces in lead-free soldering. J. Electron Mater. 32, 1249 (2003).
T.B. Massalski: Binary Alloy Phase Diagrams 2nd ed. (ASM, New York, NY, 1987), p. 2887.
J.W. Yoon, H.S. Chun, S.B. Jung: Interfacial reaction and mechanical characterization of eutectic Sn-Zn/ENIG solder joints during reflow and aging. Mater. Trans. 46, 2386 (2005).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yoon, JW., Jung, SB. Interfacial reactions and shear strength on Cu and electrolytic Au/Ni metallization with Sn-Zn solder. Journal of Materials Research 21, 1590–1599 (2006). https://doi.org/10.1557/jmr.2006.0198
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/jmr.2006.0198