Abstract
Precise control of porosity and microstructure of porous ceramics is essential. This paper describes a method for the preparation of porous ceramics with porosity from 0.0 to 0.4. The ceramics were prepared via hot pressing a powder mixture to a definite dimension, and the porosity was easily adjusted by the powder amount. As examples, porous Si3N4 or SiC ceramics were produced by powder mixtures that contained Si3N4 or SiC and a sintering additive of oxide. It was demonstrated that the present method is advantageous for producing ceramics with controllable porosity and microstructure.
Similar content being viewed by others
References
Y. Shigegaki, M.E. Brito, K. Hirao, M. Toriyama, and S. Kanzaki, J. Am. Ceram. Soc. 80, 495 (1997).
Y. Inagaki, T. Ohji, S. Kanzaki, and Y. Shigegaki, J. Am. Ceram. Soc. 83, 1807 (2000).
N. Kondo, Y. Suzuki, and T. Ohji, J. Mater. Res. 16, 32 (2001).
S.F. Corbin and P.S. Apté, J. Am. Ceram. Soc. 82, 1693 (1999).
D. Hardy and D.J. Green, J. Eur. Ceram. Soc. 15, 769 (1995).
D.C.C. Lam, F.F. Lange, and A.G. Evans, J. Am. Ceram. Soc. 77, 2113 (1994).
K. Ishizaki, S. Komarneni, and M. Nanko, Porous Materials (Kluwer Academic Publishers, Dordrecht, The Netherlands, 1998), pp. 46, 51.
K. Suganuma, G. Sasaki, T. Fujita, M. Okumura, and K. Niihara, J. Mater. Sci. 28, 1175 (1993).
W.D. Kingery, J. Appl. Phys. 30, 301 (1959).
J.F. Yang, Z.Y. Deng, and T. Ohji, J. Am. Ceram. Soc. (in review).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Yang, JF., Zhang, GJ. & Ohji, T. Porosity and microstructure control of porous ceramics by partial hot pressing. Journal of Materials Research 16, 1916–1918 (2001). https://doi.org/10.1557/JMR.2001.0262
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.2001.0262