Abstract
The effect of thermal cycling and sintering temperature on the chemical and thermodynamic stability of the bulk multiferroic xLa0.7Pb0.3MnO3–(1 – x)PbTiO3 quasi-ceramic and ceramic composites has been experimentally investigated. It is shown that the limiting temperature of the long-term sample firing should not exceed 1070 K. It has been found that sintering at this temperature and/or short-term exposure of the samples at higher temperatures (up to 1220 K) significantly increase the sample compactness, stabilize the thermal expansion, and enhance the quality of the composites. It has been established that the component grain integrity is violated by shrinkage of the samples and a sharp change in their volume during the phase transition of a ferroelectric component.
Similar content being viewed by others
REFERENCES
H. Schmid, Ferroelectrics 162, 317 (1994).
C.-W. Nan, L. Liu, N. Cai, J. Zhai, Y. Ye, Y. H. Lin, L. J. Dong, and C. X. Xiong, Appl. Phys. Lett. 81, 3831 (2002).
S. A. Gridnev, Yu. E. Kalinin, A. V. Kalgin, and E. S. Grigor’ev, Phys. Solid State 57, 1372 (2015).
W. Eerenstein, N. D. Mathur, and J. F. Scott, Nature (London, U.K.) 442, 759 (2006).
K. Zvezdin and A. P. Pyatakov, Phys. Usp. 47, 416 (2004).
M. I. Bichurin and V. M. Petrov, Low Temp. Phys. 36, 544 (2010).
H. S. Bhattia, S. T. Hussaina, F. A. Khanb, and Sh. Hussain, Appl. Surf. Sci. 367, 291 (2016).
J. F. Scott and R. Blinc, J. Phys.: Condens. Matter 23, 113202 (2011).
N. Aparnadevi, K. S. Kumar, M. Manikandan, P. Joseph, and C. Venkateswaran, J. Appl. Phys. 120, 034101 (2016).
A. V. Kalgin, S. A. Gridnev, and A. A. Amirov, Phys. Solid State 60, 1239 (2018).
M. M. Vopson, Solid State Commun. 152, 2067 (2012).
I. N. Flerov, Izv. SPb. Univ. Nizkotemp. Pishchev. Tekhnol., No. 1, 41 (2008).
E. Mikhaleva, I. Flerov, A. Kartashev, M. Gorev, A. Cherepakhin, K. Sablina, N. Mikhashenok, N. Vol-kov, and A. Shabanov, J. Mater. Res. 28, 3322 (2013).
E. Mikhaleva, I. Flerov, M. Gorev, M. Molokeev, A. Cherepakhin, A. Kartashev, N. Mikhashenok, and K. Sablina, Phys. Solid State 54, 1832 (2012).
A. V. Kartashev, E. A. Mikhaleva, M. V. Gorev, E. V. Bog-danov, A. V. Cherepakhin, K. A. Sablina, N. V. Mi-khashonok, I. N. Flerov, and N. V. Volkov, J. Appl. Phys. 113, 073901 (2013).
ACKNOWLEDGMENTS
This study was supported by the Russian Foundation for Basic Research, the Government of the Krasnoyarsk Territory, and the Krasnoyarsk Territorial Foundation for Support of the Scientific and R&D Activity, project no. 17-42-240076 “Complex Approach to Searching and Development of Promising Solid-State Ferroic Cooling Agents Based on the Single- and Multicaloric Effects.”
The authors thank M.S. Molokeev for structural characterization of the composites.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by E. Bondareva
Rights and permissions
About this article
Cite this article
Mikhaleva, E.A., Flerov, I.N., Gorev, M.V. et al. Effect of Sequential Heat Impacts on the Formation of a Stable State of the xLPM–(1 – x)PT Multiferroic Composites. Phys. Solid State 60, 2524–2531 (2018). https://doi.org/10.1134/S1063783419010189
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1063783419010189