Abstract
A cobalt catalyst was manufactured using polyacrylonitrile (PAN)-based carbon fiber as a support. The surface of the fiber was covered with thin layer of alumina before cobalt impregnation. The catalyst was studied by a number of physicochemical methods including low-temperature nitrogen adsorption, TPR, DTG, chromatography, electron microscopy (TEM and SEM) and thermal conductivity measurements. The properties measured were discussed along with data on the activity in Fischer–Tropsch synthesis. It was found that the catalyst after the synthesis becomes significantly different from the starting catalyst, mostly because of the deposition and accumulation of high-molecular products of the Fischer–Tropsch synthesis. At the same time, in the steady-state mode, its catalytic parameters correspond to a high-performance granular catalyst based on graphite, which allows us to use the results obtained as a model for identifying the surface states of a porous catalyst of the new generation gas-to-liquid (GTL) process.
Similar content being viewed by others
REFERENCES
Mordkovich, V.Z., Sineva, L.V., Solomonik, I.G., Ermolaev, V.S., and Mitberg, E.B., Patent WO2011016759, 2011.
Asalieva, E., Sineva, L., Sinichkina, S., Solomonik, I., Gryaznov, K., Pushina, E., Kulchakovskaya, E., Kulnitskiy, B., Ovsyannikov, D., and Mordkovich, V., Appl. Catal., A, 2020, vol. 601, p. 117639. https://doi.org/10.1016/j.apcata.2020.11763
Holmen, A., Venvik, H.J., Myrstad, R., Zhu, J., and Chen, D., Catal. Today, 2013, vol. 216, p. 150. https://doi.org/10.1016/j.cattod.2013.06.006
Zarubova, S., Rane, S., Yang, J., Yu, Y., Zhu, Y., Chen, D., and Holmen, A., ChemSusChem, 2011, vol. 4, p. 935. https://doi.org/10.1002/cssc.201100046
Gerber, I.C. and Serp, P., Chem. Rev., 2020, vol. 120, no. 2, p. 1250. https://doi.org/10.1021/acs.chemrev.9b00209
Ghogia, A.C., Nzihou, A., Serp, P., Soulantica, K., and Pham Minh, D., Appl. Catal., A, 2021, vol. 609, p. 117906.
Chen, Y., Wei, J., Duyar, M.S., Ordomsky, V.V., Khodakov, A.Y., and Liu, J., Chem. Soc. Rev., 2021, vol. 50, p. 2337. https://doi.org/10.1039/d0cs00905a
Chernyak, S.A., Suslova, E.V., Egorov, A.V., Lu, L., Savilov, S.V., and Lunin, V.V., Fuel Process. Technol., 2015, vol. 140, p. 267. https://doi.org/10.1016/j.fuproc.2015.09.012
Chernyak, S., Burtsev, A., Egorov, A., Maslakov, K., Savilov, S., and Lunin, V., Funct. Mater. Lett., 2020, vol. 13, no. 04, p. 2050021. https://doi.org/10.1142/S1793604720500216
PPMS thermal-transport application note. http://www.qdusa.com.
http://specsplav-vdm.ru/fehral-marka-h23yu5t.
GOST (State Standard) 12766.1 90.
PPMS TTO manual B0.
Technical Bulletin of “Kureha Corporation”, https://www.kureha.co.jp/en/business/material/pdf/ KRECA_eng.pdf.
Urvanov, S.A., Modifitsirovanie poverkhnosti uglerodnogo volokna uglerodnymi nanostrukturami (Surface Modification of Carbon Fibers with Carbon Nanostructures) Cand. Sci. (Chem.) Dissertation, Moscow: MSU, 2016.
Balinova, Yu.A., Nepreryvnye polikristallicheskie volokna oksida alyuminiya dlya kompozitsionnykh materialov (Continuous Polycrystalline Alumina Fibers for Composite Materials) Cand. Sci. (Eng.) Dissertation, Moscow: ARSRIAM, 2012.
Solomonik, I.G., Gryaznov, K.O., Skok, V.F., and Mordkovich, V.Z., RSC Adv., 2015, vol. 5, p. 78586. https://doi.org/10.1039/C5RA11853K
Lapidus, A.L., Krylova, A.Yu., Kazanskii, V.B., Borovkov, A.Yu., Zaitsev, A.V., Rathouslj, J., Zukal, A., and Jan Edlkovi, M., Appl. Catal., 1991, vol. 73, p. 65.
Solomonik, I.G., Sineva, L.V., and Mordkovich, V.Z., Abstracts, IX International Conference “Mechanisms of catalytic reactions”, October 22–25, St. Peterburg, 2012, p. 267.
ACKNOWLEDGMENTS
The equipment of the Multiaccess Center of the Technological Institute for Superhard and Novel Carbon Materials was used in this study. We are grateful to E.V. Kul’chakovskaya for determining the catalyst activity.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The authors declare that they have no conflicts of interest.
Additional information
Translated by L. Smolina
Abbreviations and notation: FTS, Fischer–Tropsch synthesis; PAN, polyacrylonitrile; GTL, gas-to-liquids transformation; NCF, nonporous carbon fiber; NCFC, nonporous carbon fiber catalyst; TEG, thermally expanded graphite; TPRH-Н2, temperature-programmed reduction with hydrogen; TGA, thermogravimetric analysis; DTA, differential thermal analysis; DTG, derivative thermogravimetry; TEM, transmission electron microscopy; HR-SEM, high-resolution scanning electron microscopy; EDX, energy-dispersive X-ray spectroscopy; GHSV, gas hourly space velocity; PVA, polyvinyl alcohol.
Rights and permissions
About this article
Cite this article
Solomonik, I.G., Gryaznov, K.O., Pushina, E.A. et al. Creation and Study of a Model Cobalt Catalyst for High-Performance Fischer–Tropsch Synthesis Using Nonporous Carbon Fiber as a Support. Kinet Catal 63, 279–291 (2022). https://doi.org/10.1134/S0023158422030090
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0023158422030090