Abstract
An experimental stand for investigating and testing lightning protection devices for aerial power lines is described. The stand is composed of an oscillation circuit modeling a power line with an industrial frequency of 50 Hz, a voltage of up to 10 kV, and a current amplitude in the circuit as high as 10 kA; a generator of short single current pulses with a voltage of up to 25 kV and a current amplitude of up to 30 kA, modeling a lightning discharge; and commutation, control, and diagnostic systems. The stand is used to investigate elements of multi-chamber arrester systems for protecting high-voltage overhead lines.
Similar content being viewed by others
References
Bazelyan, E.M. and Raizer, Yu.P., Fizika molnii i molniezashchity (Lighting Physics and Lighting Protection), Moscow: Fizmatlit, 2001; Bristol: IOP, 2000.
Aleksandrov, G.N., Molniya i molniezashchita (Lighting and Lighting Protection), Moscow: Nauka, 2006.
http://www.streamer.ru/
Podporkin, G.V., En’kin, E.Yu., and Pil’shchikov, V.E., Russ. Electr. Eng., 2013, vol. 84, no. 1, p. 1.
Podporkin, G.V., En’kin, E.Yu., and Pil’shchikov, V.E., Elektrichestvo, 2013, no. 1, p. 26.
Kaplan, V.V. and Nashatyr’, V.M., Sinteticheskie ispytaniya vysokovol’tnykh vyklyuchatelei (Synthetic Testing of High Voltage Switches), Leningrad: Energiya, 1980.
GOST (State Standard) R 52565-2006. Alternating Current Circuit Breakers for Voltage from 3 to 750 kV, Moscow: Standartinform, 2006.
GOST (State Standard) 16357-83. Valve-type Arresters of Alternating Current for Nominal Voltage from 3.8 to 600 kV, Moscow: Standartinform, 1983.
Emelin, P.F., Rutberg, Ph.G., and Fridman, B.E., Instrum. Exp. Tech., 1993, vol. 36, no. 5, p. 730.
Fridman, B.E., Doctoral (Tech.) Dissertation, St. Petersburg: Inst. of Problems of Electrophysics, Russ. Acad. Sci., 1999.
Avrutskii, V.A., Kuzhekin, I.P., and Chernov, E.N., Ispytatel’nye i elektrofizicheskie ustanovki. Tekhnika eksperimenta (Testing and Electrophysical Installations: Technique of Experiment), Moscow: MEI, 1983.
Kuzhenkin, I.P., Ispytatel’nye ustanovki i izmereniya na vysokom napryazhenii (Testing Installations and Measurements at High Tension), Moscow: Energiya, 1978.
Pinchuk, M.E., Bogomaz, A.A., Budin, A.V., and Rutberg, P.G., IEEE Trans. Plasma Sci., 2014, vol. 42, no. 10, p. 2434. doi 10.1109/TPS.2014.2316064
Pinchuk, M.E., Kolikov, V.A., Rutberg, Ph.G., Leks, A.G., Dolinovskaya, R.V., Snetov, V.N., and Stogov, A.Yu., J. Phys.: Conf. Ser., 2012, vol. 406, p. 012034 doi 10.1088/1742-6596/406/1/012034.
Kolikov, V.A., Pinchuk, M.E., Leks, A.G., and Rutber., Ph.G., Proc. SPIE-Int. Soc. Opt. Eng., 2007, vol. 6279, paper 192, p. 62795C-1. doi 10.1117/12.725381
Rutberg, Ph.G., Bogomaz, A.A., Pinchuk, M.E., Budin, A.V., Leks, A.G., and Pozubenkov, A.A., Physics Plasmas, 2011, vol. 18, no. 12, p. 122702. doi 10.1063/1.3662053
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.V. Budin, M.E. Pinchuk, V.E. Pilschikov, A.G. Leks, V.V. Leont’ev, 2016, published in Pribory i Tekhnika Eksperimenta, 2016, No. 5, pp. 55–59.
Rights and permissions
About this article
Cite this article
Budin, A.V., Pinchuk, M.E., Pilschikov, V.E. et al. An experimental stand for investigating protective devices for high-voltage overhead lines. Instrum Exp Tech 59, 673–677 (2016). https://doi.org/10.1134/S0020441216040163
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0020441216040163