Abstract
Combustion during self-propagating high-temperature synthesis of Ti + 1.7B reaction tapes obtained by rolling from a powder mixture is experimentally investigated. Dependences between the combustion wave propagation velocity in the reaction tapes and the applied pressure are revealed. It is shown that the burning rate of the tapes weakly depends on the compression pressure within 0.001–4 MPa. At a compression pressure above 0.5 MPa, unreacted regions appear during the combustion of the tapes. The limiting pressure at which the combustion stops is determined as 12 MPa.
Similar content being viewed by others
REFERENCES
T. I. Serebryakova, V. A. Neronov, and P. D. Peshev, High-Temperature Borides (Metallurgiya, Moscow, 1991; Cambridge Inter. Sci. Publ., 2003).
B. Basu, G. B. Raju, and A. K. Suri, “Processing and Properties of Monolithic TiB2 Based Materials," Int. Mater. Rev. 51 (6), 352–374 (2006); DOI: 10.1179/174328006X102529.
A. G. Korotkikh, V. A. Arkhipov, K. V. Slyusarsky, and I. V. Sorokin, “Study of Ignition of High-Energy Materials with Boron and Aluminum and Titanium Diborides," Fiz. Goreniya Vzryva 54 (3), 109–115 (2018) [Combust., Expl., Shock Waves 54 (3), 350–356 (2018); 10.1134/S0010508218030127].
S. P. Koundinyan, J. B. Bdzil, M. Matalon, and D. S. Stewart, “Diffusion Flames in Condensed-Phase Energetic Materials: Application to Titanium–Boron Combustion," Combust. Flame 162 (12), 4486–4496 (2015); DOI: 10.1016/j.combustflame.2015.08.023.
C. J. Zhang, F. Kong, S. L. Xiao, et al., “Evolution of Microstructural Characteristic and Tensile Properties during Preparation of TiB/Ti Composite Sheet," Mater. Des. 36, 505–510 (2012); DOI: 10.1016/j.matdes.2011.11.060.
M. Cirakoglu, S. Bhaduri, and S. B. Bhaduri, “Combustion Synthesis Processing of Functionally Graded Materials in the Ti–B Binary System," J. Alloys Compd. 347 (1/2), 259–265 (2002); DOI: 10.1016/S0925-8388(02)00499-1.
Q. An, L. J. Huang, Y. Jiao, et al., “Intergrowth Microstructure and Superior Wear Resistance of (TiB + TiC)/Ti64 Hybrid Coatings by Gas Tungsten Arc Cladding," Mater. Des. 162, 34–44 (2019); DOI: 10.1016/j.matdes.2018.11.039.
A. J. Horlock, D. G. McCartney, P. H. Shipway, and J. V. Wood, “Thermally Sprayed Ni(Cr)–TiB2 Coatings Using Powder Produced by Self-Propagating High Temperature Synthesis: Microstructure and Abrasive Wear Behavior," Mater. Sci. Eng. A 336 (1/2), 88–98 (2002); DOI: 10.1016/S0921-5093(01)01918-9.
Y. Taneoka, O. Odawara, and Y. Kaieda, “Combustion Synthesis of the Titanium–Aluminum–Boron System," J. Am. Ceram. Soc. 72 (6), 1047–1049 (1989); DOI: 10.1111/j.1151-2916.1989.tb06268.x.
H. Yokokawa, “Tables of Thermodynamic Properties of Inorganic Compounds," J. Nat. Chem. Lab. Ind. 83, 27–121 (1988).
G. K. Moiseev and A. L. Ivanovskii, “Standard Enthalpies of Formation of Related Compounds in Metal–Boron Systems," Izv. Chelyabinsk. Nauch. Ts. Ural. Otd. Ross. Akad. Nauk 29 (3), 5–9 (2005).
A. G. Merzhanov and I. P. Borovinskaya, “Self-Propagating High-Temperature Synthesis of Refractory Inorganic Materials," Dokl. Akad. Nauk SSSR 204 (2), 366–369 (1972).
S. G. Vadchenko, I. P. Borovinskaya, and A. G. Merzhanov, “Solid-Flame Combustion of Thin Films," Dokl. Akad. Nauk 408 (2), 211–213 (2006).
S. G. Vadchenko, I. P. Borovinskaya, and A. G. Merzhanov, “SHS in Thin Films. Possibilities of Engineering Application," Izv. Vyssh. Uchebn. Zaved. Tsvet. Metallurg., No. 5, 36–43 (2006).
A. S. Dudyrev, D. B. Dem’yanenko, and V. V. Efanov, “The New Pyroautomatic Machinery for Securing Small Spacecraft Operation," Izv. St.-Peterburg. Gos. Tekhnol. Inst. (Tekhn. Univ.), No. 1 (27), 5–9 (2007).
V. O. Popov, “Prospects for the Development of Fast-Burning Low-Gas Pyrotechnic Compositions," Yuzhno-Sib. Nauch. Vestn. 24 (4), 236–241 (2018).
S. Chen, Q. Meng, N. Zhang, et al., “In Situ Synthesis and Bonding of Ti–TiAl–TiC/Ni Functionally Graded Materials by Field-Activated Pressure-Assisted Synthesis Process," Mater. Sci. Eng. A 538, 103–109 (2012); DOI: 10.1016/j.msea.2012.01.020.
R. E. Ferguson and E. Shafirovich, “Aluminum–Nickel Combustion for Joining Lunar Regolith Ceramic Tiles," Combust. Flame 197, 22–29 (2018); DOI: 10.1016/j.combustflame.2018.06.032.
A. S. Mukasyan and J. D. E. White, “Combustion Joining of Refractory Materials," Int. J. Self-Propag. High-Temp. Synth. 16 (3), 154–168 (2007); DOI: 10.3103/S1061386207030089.
A. Maznoy, A. Kirdyashkin, V. Kitler, and A. Solovyev, “Combustion Synthesis and Characterization of Porous Ni–Al Materials for Metal-Supported Solid Oxide Fuel Cells Application," J. Alloys Compd. 697, 114–123 (2017); DOI: 10.1016/j.jallcom.2016.11.350.
O. K. Kamynina, S. G. Vadchenko, and A. S. Shchukin, “SHS-Aided Joining of Ceramic Materials with the Ta Substrate," Izv. Vyssh. Uchebn. Zaved. Poroshk. Metallurg. Funkts. Pokr., No. 3, 41–45 (2018); DOI: 10.17073/1997-308X-2018-3-41-45 [Russian J. Non-Ferrous Metals 60, 422–425 (2019)].
O. K. Kamynina, S. G. Vadchenko, N. F. Shkodich, and E. V. Petrov, “Multilayer Ti–Ta–Ni–TiC–TiB Composite by Combustion-Aided Joining," Int. J. Self-Propag. High-Teemp. Synth. 29 (4), 220–224 (2020); DOI: 10.3103/S1061386220040032.
S. G. Vadchenko and A. S. Rogachev, “Method for Obtaining Multilayer Energy-Releasing Films for Permanent Joining of Materials," Patent RU 2479382 C1, Publ. April 20, 2013; Bul. No. 11.
S. G. Vadchenko, A. S. Rogachev, O. D. Boyarchenko, and Yu. A. Kulagin, “Method for Obtaining a Multilayer Tape for a Fuel Element," Patent RU 2499907 C1, Publ. November 27, 2013.
S. G. Vadchenko, “Dependence of the Burning Rates of Tapes of Ti + \(x\)B Mixtures on Boron Concentration," Fiz. Goreniya Vzryva 55 (2), 61–67 (2019) [Combust., Expl., Shock Waves 55 (2), 177–183 (2019)].
A. A. Shiryaev, “Thermodynamics of SHS Processes: An Advanced Approach," J. Self-Propag. High-Temp. Synth. 4 (4), 351–362 (1995).
R. V. Reeves, M. A. Rodriguez, E. D. Jones, and D. P. Adams, “Condensed-Phase and Oxidation Reaction Behavior of Ti/2B Foils in Varied Gaseous Environments," J. Phys. Chem. C. 116 (33), 17904–17912 (2012); DOI: 10.1021/jp303785r.
A. A. Zenin, A. G. Merzhanov, and G. A. Nersisyan, “Thermal Wave Structure in SHS Processes," Fiz. Goreniya Vzryva 17 (1), 79–90 (1981) [Combust., Expl., Shock Waves 17 (1), 63–71 (1981)].
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Fizika Goreniya i Vzryva, 2021, Vol. 57, No. 6, pp. 42-47.https://doi.org/10.15372/FGV20210605.
Rights and permissions
About this article
Cite this article
Vadchenko, S.G., Suvorov, D.S., Kamynina, O.K. et al. Effect of Compression Pressure on Combustion of Tapes Obtained by Rolling a Ti + 1.7B Powder Mixture. Combust Explos Shock Waves 57, 672–677 (2021). https://doi.org/10.1134/S0010508221060058
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0010508221060058