Abstract
Three-dimensional Reynolds equations are used to calculate a turbulent flow in an S-shaped rectangular channel, which was experimentally investigated by Bruns et al. [1]. It is the main objective of these calculations to estimate the accuracy provided by the most popular linear models of turbulent viscosity in application to complex three-dimensional flows. In particular, two models of this type are treated, namely, the Menter model [2] and the Spalart-Allmaras model [3]. In addition, in order to estimate the possibility of improving the accuracy of simulation owing to the inclusion of the effect of curvature of the stream lines and of anisotropy of the Reynolds stress tensor, calculations are also performed using the appropriate modifications of the Spalart-Allmaras model [3], as suggested in [4, 5]. It is demonstrated that all of the treated models produce similar results, qualitatively correctly describe the experimentally observed tendencies, and, by and large, provide for an adequate qualitative agreement between the prediction and experimental data over the averaged characteristics of flow. Some differences are observed only downstream of the inflection point of the S-shaped walls, where a velocity profile with two-way downwash is realized. In calculating the Reynolds stresses, the nonlinear model of [5] is clearly advantageous over other models.
Similar content being viewed by others
REFERENCES
Bruns, J.M., Fernholz, H.H., and Monkewitz, P.A., J. Fluid Mech., 1999, vol. 393, p. 175.
Menter, F.R., Zonal Two-Equation k-Turbulence Models for Aerodynamic Flows, AIAA Paper, 1993, AIAA-93-2906.
Spalart, P.R. and Allmaras, S.R., A One-Equation Turbulence Model for Aerodynamic Flows, AIAA Paper, 1992, AIAA-92-0439.
Spalart, P.R. and Shur, M.L., Aerosp. Sci. Technol., 1997, vol. 1, no. 5, p. 297.
Spalart, P.R., Int. J. Heat Fluid Flow, 2000, vol. 21, p. 252.
Coles, D.E. and Hirst, E.A., Computation of Turbulent Boundary Layers-1968, AFOSR-IFP Stanford Conf., Stanford Univ. Press, Palo Alto, CA, 1969, vol. II.
European Computational Aerodynamics Research Project: Validation of CFD Codes and Assessment of Turbulence Models, Haase, W., Chaput, E., Elsholz, E., et al., Eds., Notes on Numerical Fluid Mechanics (NNFM), 1997, vol. 58.
Garbaruk, A.V., Current Semi-Empirical Models of Turbulence for Wall Flows: Testing and Comparison, Cand. Sci. (Phys.-Math.) Dissertation, St. Petersburg: St. Petersburg State Univ., 1999.
Garbaruk, A.V., Lapin, Yu.V., and Strelets, M.Kh., Teplofiz. Vys. Temp., 1998, vol. 36, no. 4, p. 607 (High Temp. (Engl. transl.), vol. 36, no. 4, p. 583).
Rogers, S.E. and Kwak, D., An Upwind Differencing Scheme for the Time-Accurate Incompressible Navier-Stokes Equations, AIAA Paper, 1988, AIAA-88-2583-CP. u'w'
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Garbaruk, A.V., Strelets, M.K. & Shur, M.L. Analysis of Three-Dimensional Turbulent Flow in an S-Shaped Rectangular Channel. High Temperature 41, 49–56 (2003). https://doi.org/10.1023/A:1022324620760
Issue Date:
DOI: https://doi.org/10.1023/A:1022324620760