Influence of Silicon and Aluminum Additions on the Oxidation Resistance of a Lean-Chromium Stainless Steel

Abstract

The effect of Si and Al additions on the oxidation of austenitic stainless steels with a baseline composition of Fe–16Cr–16Ni–2Mn–1Mo (wt.%) has been studied. The combined Si and Al content of the alloys did not exceed 5 wt.%. Cyclic-oxidation tests were carried out in air at 700 and 800°C for a duration of 1000 hr. For comparison, conventional 18Cr–8Ni type-304 stainless steel specimens were also tested. The results showed that at 700°C, alloys containing Al and Si, and alloys with only Si additions showed weight gains about one half that of the conventional type-304 alloy. At 800°C, alloys that contained both Al and Si additions showed weight gains approximately two times greater than the type-304 alloy. However, alloys containing only Si additions showed weight gains four times less than the 304 stainless. Further, alloys with only Si additions preoxidized at 800°C, showed zero weight gain in subsequent testing for 1000 hr at 700°C. Clearly, the oxide-scale formation and rate-controlling mechanisms in the alloys with combined Si and Al additions at 800°C were different than the alloys with Si only. ESCA, SEM, and a bromide-etching technique were used to analyze the chemistry of the oxide films and the oxide–base-metal interface, in order to study the different oxide film-formation mechanisms in these alloys.