Abstract
Steam condensation plays a critical role as an accidental safety measure in the passive containment cooling system of a nuclear power plant. Zinc-silicate epoxy-coated mild steel plate is widely used for steel containment or as liner material for steel lined concrete containment of nuclear reactor. The purpose of the coating is mainly to increase the corrosion resistance of mild steel liner. However, high condensation rate is of utmost importance to prevent large pressure and temperature buildups within the nuclear reactor in case of a loss of coolant accident (LOCA) and maintain necessary safety margin. In this work, the effect of the epoxy coating on mild steel liner during vapor condensation in humid air environment has been investigated. Both as-purchased, uncoated (bare) and epoxy-coated mild steel plates have been used as condenser surfaces. A wide range of heat fluxes are realized by carrying out condensation experiments both under natural and forced convection scenarios. It is found that the epoxy-coated condenser plates show lower contact-angle hysteresis and hence promote better droplet mobility and condensate drainage from the surface. However, measurements reveal that the overall condensation rate on the epoxy-coated surfaces is less than that on uncoated mild steel plate. Our study shows that the lower nucleation density coupled with the additional thermal resistance due to the coating thickness causes lower condensation rates on the epoxy-coated mild steel surface. Results of the study are relevant for benchmarking reactor thermal hydraulics codes for realistic simulations of containment pressure under accident scenarios.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Abbreviations
- T s :
-
Substrate temperature (K)
- \(m_{{\text{c}}}\) :
-
Total condensate collection (gm)
- T dew :
-
Dew point temperature (K)
- \(\dot{m}^{\prime\prime}_{{\text{c}}}\) :
-
Condensate collection rate (kg/m2 s)
- T a :
-
Ambient temperature (K)
- A p :
-
Condenser surface area (m2)
- ∆T :
-
Degree of subcooling (K)
- τ :
-
Condensation time (h)
- h fg :
-
Latent heat of evaporation (J/kg)
- φ :
-
Relative humidity (%)
- CHTC :
-
Condensation heat transfer coefficient (W/m2 K)
- h :
-
Convective heat transfer coefficient (W/m2 K)
References
Adera S, Naworski L, Davitt A, Mandsberg NK, Shneidman AV, Alvarenga J, Aizenberg J (2021) Enhanced condensation heat transfer using porous silica inverse opal coatings on copper tubes. Sci Rep 11:10675. https://doi.org/10.1038/s41598-021-90015-x
Budakli M, Salem TK, Arik M, Donmez B, Menceloglu Y (2020) Effect of polymer coating on vapor condensation heat transfer. ASME J Heat Transf 142(4):041602. https://doi.org/10.1115/1.4046300
Cummins WE, Wright RF, Schulz TL (2001) AP1000 status overview. In: 9th international conference on nuclear engineering, France
Das C, Gupta R, Halder S, Datta A, Ganguly R (2021) Filmwise condensation from humid air on a vertical superhydrophilic surface: explicit roles of the humidity ratio difference and the degree of subcooling. ASME J Heat Transf 143(6):061601. https://doi.org/10.1115/1.4050412
Garrett KW, Rosenberg HM (1974) The thermal conductivity of epoxy resin/powder composite materials. J Phys D Appl Phys 7:1247–1258. https://doi.org/10.1088/0022-3727/7/9/311
Goswami A, Pillai SC, McGranaghan G (2021) Surface modifications to enhance dropwise condensation. Surf Interfaces 25:101143. https://doi.org/10.1016/j.surfin.2021.101143
Guruviah S, Sundaram M, Chandrasekaran V, Jayakrishnan P, Raghupathy K, Sarma VG (1986) Protective coatings system for nuclear power plant and corrosive environments. Bull Electrochem 2(4):345–347
Holden KM, Wanniarachchi AS, Marto PJ, Boone DH, Rose JW (1987) The use of organic coatings to promote dropwise condensation of steam. ASME J Heat Transf 109(3):768–774. https://doi.org/10.1115/1.3248156
Hoshyargar F, Sherafati SA, Hashemi MM (2009) A new study on binder performance and formulation modification of anti-corrosive primer based on ethyl silicate resin. Prog Org Coat 65(3):410–413. https://doi.org/10.1016/j.porgcoat.2009.02.006
Incropera FP, Lavine AS, Bergman TL, DeWitt DP (2007) Fundamentals of heat and mass transfer. Wiley, New York
Khan SA, Tahir F, Baloch AAB, Koc M (2019) Review of micro-nanoscale surface coatings application for sustaining dropwise condensation. Coatings 9:117. https://doi.org/10.3390/coatings9020117
Kulkarni MD, Puthani PL, Patil AT (2015) Study of dropwise condensation on teflon coated surface. Int Adv Res J Sci Eng Technol 2(9):26–29. https://doi.org/10.17148/IARJSET.2015.2906
Lawrence MG (2005) The relationship between relative humidity and the dewpoint temperature in moist air: a simple conversion and applications. Bull Am Meteorol Soc 86(2):225–234. https://doi.org/10.1175/BAMS-86-2-225
Lee H, Neville K (1982) Handbook of epoxy resins. McGraw Hill, New York
Lee J-R, Soo-Jin P, Min-Kang S, Yong-Kwan B, Sang-Kook L (2006) A study on physicochemical properties of epoxy coating system for nuclear power plants. Nucl Eng Design 236(9):931–937
Lin C, Chen S (2018) Atmospheric corrosion behavior of mild steel in the initial stage under different relative humidity. Int J Georesour Environ 4(2):33–39. https://doi.org/10.15273/ijge.2018.02.006
Newby BJ, Rohde KL, Jordan WT (1969) Development of testing procedures for protective coatings to be used in nuclear reactor containment structures. U.S. Atomic Energy Commission Research and Development Report, IN-1253, National Reactor Testing Station, Idaho Nuclear Corporation, Idaho
Othmer DF (1929) The condensation of steam. Ind Eng Chem 21(6):577–583. https://doi.org/10.1021/ie50234a018
Pandis PK, Papaioannou S, Siaperas V, Terzopoulos A, Stathopoulos VN (2020) Evaluation of Zn-and Fe-rich organic coatings for corrosion protection and condensation performance on waste heat recovery surfaces. Int J Thermofluids 3:100025. https://doi.org/10.1016/j.ijft.2020.100025
Parashar G, Srivastava D, Kumar P (2001) Ethyl silicate binders for high performance coatings. Prog Org Coat 42(1–2):1–14. https://doi.org/10.1016/S0300-9440(01)00128-X
Public Report on the Generic Design Assessment of New Nuclear Reactor Designs Westinghouse Electric Company LLC (2023) AP1000 Nuclear Reactor Conclusions of the Fundamental Safety Overview of the AP1000 Nuclear Reactor (Step 2 of the Generic Design Assessment Process)
Rausch MH, Fröba AP, Leipertz A (2008) Dropwise condensation heat transfer on ion implanted aluminum surfaces. Int J Heat Mass Transf 51(5–6):1061–1070. https://doi.org/10.1016/j.ijheatmasstransfer.2006.05.047
Rausch MH, Leipertz A, Fröba AP (2010) Dropwise condensation of steam on ion implanted titanium surfaces. Int J Heat Mass Transf 53(1–3):423–430. https://doi.org/10.1016/j.ijheatmasstransfer.2009.09.01
Yan W (2013) Preliminary study for the passive containment cooling system analysis of the advanced PWR. Energy Proc 39:240–247. https://doi.org/10.1016/j.egypro.2013.07.210
Zheng Y, Chen CH, Pearlman H, Flannery M, Bonner R (2015) Effect of porous coating on condensation heat transfer. In: Proceedings of the 9th international conference on boiling and condensation heat transfer, Boulder, 26–30 April 2015, pp 1–9. https://doi.org/10.13140/RG.2.1.3000.6800
Acknowledgements
The work has been supported by Department of Atomic Energy–Board of Nuclear Sciences (DAE-BRNS), India through Project No. 36(1)/14/24/2016-BRNS. The authors gratefully acknowledge the support received from DAE-BRNS, India.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of Interest
The authors hereby declare that there is no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Das, C., Das, A., Halder, S. et al. Vapor Condensation from Humid Air on Zinc-Silicate Epoxy-Coated Mild Steel Plate Used in Containment Liners of Nuclear Power Plants. Trans Indian Natl. Acad. Eng. 9, 117–128 (2024). https://doi.org/10.1007/s41403-023-00432-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s41403-023-00432-9