Skip to main content
SpringerLink
Log in

Diesel Particulate Filter Cleaning Effectiveness: Estimated Ash Loading, Quantified Particulate Removal, and Post-cleaning Filter Pressure Drop

  • Published:
Emission Control Science and Technology Aims and scope Submit manuscript

Abstract

Diesel particulate filters (DPFs) are porous ceramic wall-flow devices utilized in diesel exhaust systems to capture particulate matter. DPFs require intermittent on-board regeneration to combust the soot component of particulate matter in order to lower engine back pressure. In addition, proper DPF maintenance requires removal from the vehicle every 100,000–200,000 miles for off-board cleaning to remove the accumulated inorganic ash component of particulate matter. In this study, the capability to quantify off-board DPF cleaning effectiveness was assessed by measuring particulate removal effectiveness and back pressure relief. DPFs were selected from vehicles with the same DPF manufacturer so as to eliminate DPF sizing as a variable. A total of 34 DPFs were removed from on-road heavy-duty diesel vehicles with mostly highway miles with low idle time and were cleaned using pneumatic air cleaning, thermal calcination, and wet cleaning processes. The cleaning processes were used alone, and in series. DPF cleaning effectiveness was evaluated by quantifying particulate removal by weight loss and by measuring DPF back pressure both before and after each process step. The estimated ash exposure values for DPFs in the study were compared with total particulate matter removed from cleaning. The results indicate that back pressure does not provide a complete quantification for off-board cleaning effectiveness, as back pressure may be decreased while DPFs may still retain significant levels of ash.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2
Fig. 3
Fig. 4
Fig. 5

Similar content being viewed by others

References

  1. U.S. Department of transportation. National transportation statistics. Table 1-49: U.S. Ton miles of freight.

  2. U.S. environmental protection agency. Technical bulletin: diesel particulate filter general information. EPA-420-F-10-029, May 2010.

  3. U.S. Department of Transportation, Federal Highway Administration, Office of Highway Policy information highway statistics series. Highway statistics 2012: truck and truck tractor registrations. 2012, Table MV-9.

  4. Code of Federal Regulations, Title 40: Protection of environment, Parts 69, 80 and 86.

  5. Frost, Rodney I., and Max R. Montierth. Diesel particulate filters for use with smaller diesel engines. U.S. Patent No.: US4415344. 1983.

  6. Walsh, M.: Global trends in diesel particulate control-A 1995 Update. Diesel Engine. 2010, 08–05 (1995)

    Google Scholar 

  7. U.S. Environmental Protection Agency (2018). National emissions inventory (NEI). Air pollution emissions trends data and estimation procedures. 1970-2017 average annual emissions all criteria pollutants in MS Excel. https://www.epa.gov/air-emissions-inventories/air-pollutant-emissions-trends-data

  8. U.S. environmental protection agency (2009). Final report: integrated science assessment for particulate matter. U.S. environmental protection agency, Washington, DC, EPA/600/R-08/139F, 2009.

  9. California Air Resource Board (2015). Evaluation of particulate matter filters in on-road heavy duty diesel vehicle applications. Http://www.arb.ca.gov/msprog/onrdiesel/documents/DPFEval.pdf

  10. U.S. Environmental Protection Agency: Clean Air Non-Road Diesel Rule. EPA420-F-04-032. (May 2004), (2004)

  11. Fino, D. Diesel emission control: catalytic filters for particulate removal. Science and Technology of Advanced Materials, 8:1-2, 93–100 (2007).

    Article  Google Scholar 

  12. Maricq, M.M.: Chemical characterization of particulate emissions from diesel engines: a review. J. Aerosol Sci. 38(11), 1079–1118 (2007)

    Article  Google Scholar 

  13. U.S. Environmental Protection Agency. Air Trends: Particulate Matter (PM2.5) Trends. https://www.epa.gov/air-trends/particulate-matter-pm25-trends

  14. Preble, C.V., Cados, T.E., Harley, R.A., Kirchstetter, T.W.: In-use performance and durability of particulate filters on heavy-duty trucks. Environ. Sci. Technol. 52(20), 11913–11921 (2018)

    Google Scholar 

  15. Liati, A., Scheriber, D., Eggenenschwiler, P.D., Dasilva, Y.A.R.: Metal particle emissions in the exhaust stream of diesel engines: an electron microscope study. Environmental science and technology. 47(24), 14495–14501 (2013)

    Article  Google Scholar 

  16. Aravelli, K., Heibel, A.: Improved lifetime pressure drop management for robust cordierite (RC) filters with asymmetric cell technology. SAE International. 2007-01-0920, (2007)

  17. Merkel, G.A., Cutler, W.A., Warren, C.J.: Thermal durability of wall-flow ceramic diesel particulate filters. SAE Paper. 2001-01-0190, (2001)

  18. Masoudi, M., Heibel, A., Then, P.M.: Predicting pressure drop of wall-flow diesel particulate filters – theory and experiment. SAE Technical Paper. 2000-01-0184, (2000)

  19. Kimura, K., Lynskey, M., Corrigan, E.R., Hickman, D.L., Wang, J., Fang, H.L., Chatterjee, S.: Real world study of diesel particulate filter ash accumulation in heavy-duty diesel trucks. SAE Paper. 2006-01-3527, (2006)

  20. Dou, D.: Application of diesel oxidation catalyst and diesel particulate filter for diesel engine powered non-road machines. Platinum Metals Rev. 56(3), 144–154 (2012)

    Article  Google Scholar 

  21. Sappock, A., Santiago, M., Vianna, T., Wong, V.W.: Characteristics and effects of ash accumulation on diesel particulate filter performance: rapidly aged and field aged results. SAE Paper. 2009-01-1086, (2009)

  22. Williams, A., Luecke, J., McCormick, R.L., Brezny, R., Geisselmann, A., Voss, K., Hallstrom, K., Leustek, M., Parsons, J., Abi-Akar, H.: Impact of biodiesel impurities on the performance and durability of DOC, DPF and SCR technologies. SAE International. 2011-01-1136, (2011)

  23. Bagi, S., Singh, N., Andrew, R.: Investigation into ash from field returned DPF units: composition, cleaning ability, and DPF performance recovery. SAE Paper. 2016-01-0928, (2016)

  24. California Code of Regulations, Title 13, Division 3. Air Resources Board, Chapter 14. “Verification Procedure, Warranty and in-Use Compliance Requirements for in-Use Strategies to Control Emissions from Diesel Engines”. Section 2706: h and l (5).

  25. Donaldson Company, Bloomington, MN. “LNF/LXF Muffler Owner’s Manual – P484796 Rev 4” (2010).

  26. Toops, T.J., Finney, C.E.A., Nafziger, E.J., Pihl, J.A.: Neutron imaging of advanced transportation technologies. In: ACE052. Department of Energy (2013)

    Google Scholar 

  27. Yang, K., Fox, J.T., Hunsicker, R.: Characterizing diesel particulate filter failure during commercial fleet use due to pinholes, melting, cracking and fouling. Emission control science and technol. 2(3), 145–155 (2016)

    Article  Google Scholar 

  28. Yang, K., Fox, J.T., Hunsicker, R.: Interaction of Na, K and Fe with porous cordierite at elevated temperatures. Journal of materials science. 52(7), 4025–4041 (2017)

    Article  Google Scholar 

  29. Yang, K., Fox, J.T., Hunsicker, R.: Interaction between Ca, Zn and porous cordierite substrate at elevated temperatures. Journal of Porous materials. 25(2), 463–475 (2018)

    Article  Google Scholar 

  30. Lopez-De Jesus, Y.M., Klink, W., Cotton, M.G., Markatou, P., Kozlov, A.: Effect of coolant exposure on diesel exhaust after treatment performance. SAE. 2012-01-1091,

  31. Sappock, A., Wong, V.: Ash effects on diesel particulate filter pressure drop sensitivity to and implications for regeneration frequency and DPF control. SAE Paper. 2010-01-0811,

Download references

Funding

This project was financed by a grant from the Commonwealth of Pennsylvania, Department of Community and Economic Development, through the Pennsylvania Infrastructure Technology Alliance (PITA).

Author information

Authors and Affiliations

  1. Department of Civil and Environmental Engineering, Lehigh University, 1 W. Packer Avenue, Bethlehem, PA, 18015, USA

    John T. Fox & Kun Yang

  2. Hunsicker Emissions Services LLC, Earlington, PA, USA

    Robert Hunsicker

Authors
  1. John T. Fox
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Kun Yang
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Robert Hunsicker
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to John T. Fox.

Ethics declarations

Conflict of Interest

On behalf of all the Lehigh authors, Fox and Yang, the corresponding author states that there is no conflict of interest.

On behalf of Robert Hunsicker, he owns Hunsicker Emissions Services LLC, which provides DPF cleaning services. This research aims to provide clarity of off-board cleaning to DPF users.

Additional information

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Fox, J.T., Yang, K. & Hunsicker, R. Diesel Particulate Filter Cleaning Effectiveness: Estimated Ash Loading, Quantified Particulate Removal, and Post-cleaning Filter Pressure Drop. Emiss. Control Sci. Technol. 6, 75–85 (2020). https://doi.org/10.1007/s40825-019-00149-8

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s40825-019-00149-8

Keywords

Search

Navigation