Abstract
A study on Ultra-High-Performance Fiber-Reinforced Concrete (UHPFRC) required accurate continuous displacement measurements to fully understand specimen compressive and split tensile behavior. From uniaxial compressive testing, load, and displacement data was acquired to develop specimen specific stress–strain diagrams from which the modulus of elasticity and strain at ultimate capacity of the material were found. Thus, a device suitable to measure the displacement and crack width opening was required during testing to gain knowledge of the behavior of UHPFRC subjected to compressive and tensile loads. The device normally used to measure average displacement is typically not used for ultimate strain conditions because of the potential LVDT damage from the often explosive compression failure of concrete specimens. Hence, this study investigated the use of Local Deformation Transducers (LDTs), which consists of strain gages attached at mid-length on a narrow strip of highly flexible and resilient material. Data collected from these gages corresponded well with UHPFRC test data collected from other institutions using more complex methods and proved to be a reliable source of measuring displacements with the intent of identifying modulus of elasticity, and concrete strains at first crack, and ultimate capacity for an UHPFRC.
Similar content being viewed by others
References
ASTM, C469/C469M-10 Standard Test Method for Static Modulus of Elasticity and Poisson’s Ratio of Concrete in Compression, ASTM International, West Conshohocken (2012).
ASTM, C39/C39M-12 Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens, ASTM International, West Conshohocken (2012).
ASTM, C496/C496M-11 Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens (2012), West Conshohocken: ASTM International.
Besuelle, P., and Desrues, J., An Internal Insturmentation for Axial and Radial Strain Measurements in Triaxial Test, Geotechnical Testing Journal 24(2):193–199 (2001).
Goto, S., Tatsuoka, F., Shibuya,S., Kim, Y.S., and Sato, T., A Simple Gauge for Local Small Strain Measurements in the Laboratory. Soils and Foundations (1991). 31(1)169–180.
Hoque, E., Sato, T., and Tatsuoka, F., Performance Evalulation of LDT’s for Use in Triaxial Tests, Geotechnical Testing Journal 20(2):149–167 (1997).
Kollmorgen, G.A., Impact of Age and Size on the Mechanical Behavior of an Ultra High Performance Concrete, Thesis, Civil and Environmental Engineering, Michigan Technological University, Houghton (2004).
SETRA, Ultra High Performance Fiber-Reinforced Concrete—Interim Recommendations (Bentons Fibres a Ultra-Hautes Performacnes - Recommandations Provioires), AFGC (Association Francaise de Genie Civil), France (2002).
Peuse, E.J., Impact of Age at Thermal Treament on the Mechanical Properties of an Ultra-High Performance Concrete, Thesis, Civil and Environmental Engineering, Michigan Technological University, Houghton (2008).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ahlborn, T., Kollmorgen, G. & Hansen, M. A Method of Measuring the Displacement of an Ultra-High-Performance Fiber-Reinforced Concrete by Means of Unbound Gages. Exp Tech 40, 27–33 (2016). https://doi.org/10.1007/s40799-015-0002-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40799-015-0002-8