Friction

pp 1–14 | Cite as

Oil-soluble ionic liquids as antiwear and extreme pressure additives in poly-α-olefin for steel/steel contacts

Open Access
Research Article

Abstract

To enhance the lubricating and extreme pressure (EP) performance of base oils, two types of oil-soluble ionic liquids (ILs) with similar anion albeit dissimilar cations were synthesized. The physical properties of the prepared ILs were measured. The anticorrosion properties of ILs were assessed by conducting corrosion tests on steel discs and copper strips, which revealed the remarkable anticorrosion properties of the ILs in comparison with those of the commercial additive zinc dialkyldithiophosphate (ZDDP). The tribological properties of the two ILs as additives for poly-α-olefin-10 (PAO10) with various mass concentrations were investigated. The tribological test results indicate that these ILs as additives are capable of reducing friction and wear of sliding contacts remarkably as well as enhance the EP performance of blank PAO10. Under similar test conditions, these IL additives exhibit higher lubricating and anti-wear (AW) performances than those of ZDDP based additive package in PAO10. Subsequently, X-ray photoelectron spectroscopy (XPS) and energy dispersive spectrometer (EDS) were conducted to study the lubricating mechanism of the two ILs. The results indicate that the formation of tribochemical film plays the most crucial role in enhancing the lubricating and AW behavior of the mixture lubricants.

Keywords

anti-wear extreme pressure ionic liquids lubricating mechanism 

Notes

Acknowledgements

The authors acknowledge the financial support from the National Natural Science Foundation of China (NSFC, Nos. 51675512, 51227804, and 51305428), Natural Science Foundation of Gansu Province (No. 1606RJZA051), and the National Key Basic Research and Development (973) Program of China (No. 2013CB632301).

References

  1. [1]
    Holmberg K, Andersson P, Erdemir A. Global energy consumption due to friction in passenger cars. Tribol Int 47: 221–234 (2012)CrossRefGoogle Scholar
  2. [2]
    Yu Q, Huang G, Cai M, Zhou F, Liu W. In situ zwitterionic supramolecular gel lubricants for significantly improved tribological properties. Tribol Int 95: 55–65 (2016)CrossRefGoogle Scholar
  3. [3]
    Sgroi M F, Asti M, Gili F, Deorsola F A, Bensaid S, Fino D, Kraft G, Garcia I, Dassenoy F. Engine bench and road testing of an engine oil containing MoS2 particles as nanoadditive for friction reduction. Tribol Int 105: 317–325 (2017)CrossRefGoogle Scholar
  4. [4]
    Nicholls M A, Do T, Norton P R, Kasrai M, Bancroft G M. Review of the lubrication of metallic surfaces by zinc dialkyl-dithiophosphates. Tribol Int 38: 15–39 (2005)CrossRefGoogle Scholar
  5. [5]
    Singh Y. Tribological behavior as lubricant additive and physiochemical characterization of Jatropha oil blends. Friction 3(4): 320–332 (2015)CrossRefGoogle Scholar
  6. [6]
    Cai M, Liang Y, Zhou F, Liu W. A novel imidazolium salt with antioxidation and anticorrosion dual functionalities as the additive in poly(ethylene glycol) for steel/steel contacts. Wear 306(1-2): 197–208 (2013)CrossRefGoogle Scholar
  7. [7]
    Huang G, Yu Q, Ma Z, Cai M, Liu W. Probing the lubricating mechanism of oil-soluble ionic liquids additives. Tribol Int 107: 152–162 (2017)CrossRefGoogle Scholar
  8. [8]
    Song Z, Liang Y, Fan M, Zhou F, Liu W. Lithium-based ionic liquids as novel lubricant additives for multiply alkylated cyclopentanes (MACs). Friction 1(3): 222–231 (2013)CrossRefGoogle Scholar
  9. [9]
    Liu W, Y C, Gong Q, Wang H, Wang P. Tribological Performance of Room-Temperature Ionic Liquids as Lubricant. Tribol Lett 13(2): 81–85 (2001)CrossRefGoogle Scholar
  10. [10]
    Cai M, Liang Y, Yao M, Xia Y, Zhou F, Liu W. Imidazolium ionic liquids as antiwear and antioxidant additive in poly(ethylene glycol) for steel/steel contacts. ACS Appl Mater Inter 2(3): 870–876 (2010)CrossRefGoogle Scholar
  11. [11]
    Qu J, Truhan J J, Dai S, Luo H, Blau P J. Ionic liquids with ammonium cations as lubricants or additives. Tribol Lett 22(3): 207–214 (2006)CrossRefGoogle Scholar
  12. [12]
    Fan M, Liang Y, Zhou F, Liu W. Dramatically improved friction reduction and wear resistance by in situ formed ionic liquids. RSC Adv 2(17): 6824–6830 (2012)CrossRefGoogle Scholar
  13. [13]
    Fan X, Xia Y, Wang L. Tribological properties of conductive lubricating greases. Friction 2(4): 343–353 (2014)CrossRefGoogle Scholar
  14. [14]
    Zhou F, Liang Y, Liu W. Ionic liquid lubricants: designed chemistry for engineering applications. Chem Soc Rev 38(9): 2590–2599 (2009)CrossRefGoogle Scholar
  15. [15]
    Liu W, Ye C, Gong Q, Wang H, Wang P. Tribological Performance of Room-Temperature Ionic Liquids as Lubricant. Tribol Lett 13(2): 81–85 (2002)CrossRefGoogle Scholar
  16. [16]
    Pisarova L, Totolin V, Gabler C, Dörr N, Pittenauer E, Allmaier G, Minami I. Insight into degradation of ammoniumbased ionic liquids and comparison of tribological performance between selected intact and altered ionic liquid. Tribol Int 65: 13–27 (2013)CrossRefGoogle Scholar
  17. [17]
    Kronberger M, Pagano F, Pejakovic V, Igartua A, Urbistondo E, Kalin M. Miscibility and tribological investigations of ionic liquids in biodegradable esters. Lubr Sci 26(7–8): 463–487 (2014)CrossRefGoogle Scholar
  18. [18]
    Westerholt A, Weschta M, Bösmann A, Tremmel S, Korth Y, Wolf M, Schlücker E, Wehrum N, Lennert A, Uerdingen M, Holweger W, Wartzack S, Wasserscheid P. Halide-free synthesis and tribological performance of oil-miscible ammonium and phosphonium-based ionic liquids. ACS Sustain Chem Eng 3(5): 797–808 (2015)CrossRefGoogle Scholar
  19. [19]
    Qu J, Bansal D G, Yu B, Howe J Y, Luo H, Dai S, Li H, Blau P J, Bunting B G, Mordukhovich G, Smolenski D J. Antiwear performance and mechanism of an oil-miscible ionic liquid as a lubricant additive. ACS Appl Mater Inter 4(2): 997–1002 (2012)CrossRefGoogle Scholar
  20. [20]
    Yu B, Bansal D G, Qu J, Sun X, Luo H, Dai S, Blau P J, Bunting B G, Mordukhovich G, Smolenski D J. Oil-miscible and non-corrosive phosphonium-based ionic liquids as candidate lubricant additives. Wear 289: 58–64 (2012)CrossRefGoogle Scholar
  21. [21]
    Wang H, Lu Q, Ye C, Liu W, Cui Z. Friction and wear behaviors of ionic liquid of alkylimidazolium hexafluorophosphates as lubricants for steel/steel contact. Wear 256(1–2): 44–48 (2004)CrossRefGoogle Scholar
  22. [22]
    Han Y, Qiao D, Zhang L, Feng D. Study of tribological performance and mechanism of phosphonate ionic liquids for steel/aluminum contact. Tribol Int 84: 71–80 (2015)CrossRefGoogle Scholar
  23. [23]
    Wang Z, Xia Y, Liu Z. The rheological and tribological properties of calcium sulfonate complex greases. Friction 3(1): 28–35 (2014)CrossRefGoogle Scholar
  24. [24]
    Li J, Zhang C, Deng M, Luo J. Investigations of the superlubricity of sapphire against ruby under phosphoric acid lubrication. Friction 2(2): 164–172 (2014)CrossRefGoogle Scholar
  25. [25]
    Bonhôte P, Dias A-P, Papageorgiou N, Kalyanasundaram K, Grältzel M. Hydrophobic, Highly Conductive Ambient- Temperature Molten Salts. Inorg Chem 35(5): 1168–1178 (1996)CrossRefGoogle Scholar
  26. [26]
    Fröba A P, Kremer H, Leipertz A. Density, refractive index, interfacial tension, and viscosity of ionic liquids [EMIM][EtSO4], [EMIM][NTf2], [EMIM][N(CN)2], and [OMA][NTf2] in dependence on temperature at atmospheric pressure. J Phys Chem B 112(39): 12420–12430 (2008)CrossRefGoogle Scholar
  27. [27]
    Huang G, Yu Q, Cai M, Zhou F, Liu W. Highlighting the effect of interfacial interaction on tribological properties of supramolecular gel lubricants. Adv Mater Interfaces 3(3): 1500489 (2016)CrossRefGoogle Scholar
  28. [28]
    Ilanko A K, Vijayaraghavan S. Wear behavior of asbestosfree eco-friendly composites for automobile brake materials. Friction 4(2): 144–152 (2016)CrossRefGoogle Scholar
  29. [29]
    Cartigueyen S, Mahadevan K. Wear characteristics of copperbased surface-level microcomposites and nanocomposites prepared by friction stir processing. Friction 4(1): 39–49 (2016)CrossRefGoogle Scholar
  30. [30]
    Yu Q, Fan M, Li D, Song Z, Cai M, Zhou F, Liu W. Thermoreversible Gel Lubricants through Universal Supramolecular Assembly of a Nonionic Surfactant in a Variety of Base Lubricating Liquids. ACS Appl Mater Inter 6(18): 15783–91574 (2014)CrossRefGoogle Scholar
  31. [31]
    Lin Y C, So H. Limitations on use of ZDDP as an antiwear additive in boundary lubrication. Tribol Int 37: 25–33 (2004)CrossRefGoogle Scholar
  32. [32]
    Ito K, Martin J-M, Minfray C, Kato K. Low-friction tribofilm formed by the reaction of ZDDP on iron oxide. Tribol Int 39: 1538–1544 (2006)CrossRefGoogle Scholar
  33. [33]
    Li J, Xu X, Wang Y, Ren T. Tribological studies on a novel borate ester containing benzothiazol-2-yl and disulfide groups as multifunctional additive. Tribol Int 43: 1048–1053 (2010)CrossRefGoogle Scholar
  34. [34]
    Xiong S, Sun J, Xu Y, Yan X. QSPR Models for the Prediction of Friction Coefficient and maximum non-seizure load of lubricants. Tribol Lett 60(1) (2015)Google Scholar
  35. [35]
    Minfray C, Mogne T L, Lubrecht A A, Martin J M. Experimental simulation of chemical reactions between ZDDP tribofilms and steel surfaces during friction processes. Tribol Lett 21(1): 65–76 (2006)CrossRefGoogle Scholar
  36. [36]
    Spikes H. The history and mechanisms of ZDDP. Tribol Lett 17(3): 469–489 (2004)CrossRefGoogle Scholar
  37. [37]
    Zhou X, Yang H, Wang F. [BMIM]BF4 ionic liquids as effective inhibitor for carbon steel in alkaline chloride solution. Electrochim Acta 56(11): 4268–4275 (2011)CrossRefGoogle Scholar
  38. [38]
    Qu J, Luo H, Chi M, Ma C, Blau P J, Dai S, Viola M B. Comparison of an oil-miscible ionic liquid and ZDDP as a lubricant anti-wear additive. Tribol Int 71: 88–97 (2014)CrossRefGoogle Scholar
  39. [39]
    Qu J, Barnhill W C, Luo H, Meyer III H M, Leonard D N, Landauer A K, Kheireddin B, Gao H, Papke B L, Dai S. Synergistic effects between phosphonium-alkylphosphate ionic liquids and zinc dialkyldithiophosphate (ZDDP) as lubricant additives. Adv Mater 27(32): 4767–4774 (2015)CrossRefGoogle Scholar
  40. [40]
    Cai M, Liang Y, Zhou F, Liu W. Anticorrosion imidazolium ionic liquids as the additive in poly(ethylene glycol) for steel/Cu-Sn alloy contacts. Faraday Discuss 156: 147–157 (2012)CrossRefGoogle Scholar
  41. [41]
    Yin Z, Kasrai M, Fuller M, Bancroft G M, Fyfe K, Tan K H. Application of soft x-ray absorption spectroscopy in chemical characterization of antiwear films generated by ZDDP Part I: The effects of physical parameters. Wear 202(2): 172–191 (1997)CrossRefGoogle Scholar
  42. [42]
    Jiménez A-E, Bermúdez M-D. Ionic liquids as lubricants for steel-aluminum contacts at low and elevated temperatures. Tribol Lett 26(1): 53–60 (2006)CrossRefGoogle Scholar

Copyright information

© The author(s) 2017

Open Access: This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.

Authors and Affiliations

  1. 1.State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical PhysicsChinese Academy of SciencesLanzhouChina
  2. 2.University of Chinese Academy of SciencesBeijingChina

Personalised recommendations