Skip to main content

Advertisement

Log in

A novel tin ferrite/polymer composite use in photo-Fenton reactions

  • Original Paper
  • Published:
International Journal of Environmental Science and Technology Aims and scope Submit manuscript

Abstract

Novel SnFe2O4/polypyrrole composite photo-Fenton catalysts were prepared and characterized by XRD, SEM, EDS, UV–Vis, BET, AFM, and XPS. The effect of different proportions of ferrite and polymer in the composite was investigated on the degradation efficiency of tartrazine dye in terms of pH and H2O2 dosage. A response surface methodology was applied to determine the best conditions of the reactor. The 10 wt% SnFe2O4 composites presented higher activity being able to discolor 100% of the tartrazine dye solution (100 mL, 20 mg L−1) by photo-Fenton process in 60 min under the following conditions: 0.1 g of SFO-10-PPy, pH 3, 3.4 × 10−5 mol L−1 of H2O2, and visible radiation. This enhanced performance is associated with a decrease in the bandgap energy and electron–hole recombination rate, which was efficient in a charge carrier transport. In this way, it enables the generation of radicals ·OH and O ·2 , by which it was possible to elucidate a possible mechanism for degradation. In addition, the composite can be used for eight recycles with high physicochemical stability. In general, due to the fact that the composite presented intrinsic properties, high catalytic activity, simple preparation, and good reuse, the supported catalyst showed potential to become a highly efficient and environmentally friendly catalyst for the treatment of wastewater containing organic pollutants.

Graphic abstract

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

Similar content being viewed by others

References

Download references

Acknowledgements

The authors gratefully acknowledge the financial support provided by CAPES/FAPERGS (Brazilian Federal Agency for Support and Evaluation of Graduate Education), Bolsista CAPES/BRASIL Nº 88887.195036/2018-00 and 88882.427561/2019-01.

Funding

The authors gratefully acknowledge the financial support provided by CAPES/FAPERGS (Brazilian Federal Agency for Support and Evaluation of Graduate Education), Scholarship holder CAPES/BRASIL Nos. 88887.195036/2018-00 and 88882.427561/2019-01.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to S. Silvestri.

Ethics declarations

Conflict of interest

The authors declare no conflict of interest.

Additional information

Editorial responsibility: Samareh Mirkia.

Electronic supplementary material

Below is the link to the electronic supplementary material.

Supplementary material 1 (DOCX 2581 kb)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Leichtweis, J., Silvestri, S., Vieira, Y. et al. A novel tin ferrite/polymer composite use in photo-Fenton reactions. Int. J. Environ. Sci. Technol. 18, 1537–1548 (2021). https://doi.org/10.1007/s13762-020-02944-1

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13762-020-02944-1

Keywords

Navigation