Abstract
This paper visually demonstrates water entry of horizontal hydrophobic circular cylinders, 12 mm in diameter and 300 mm long, by three types of coating of a water-repellent material; (a) perfectly coated, (b) right half surface coated, and (c) stripe coated. After the entry of the cylinder into water, the hydrophobic surface of the cylinder forms an air cavity behind it, whereas the hydrophilic surface is perfectly wetted. As a result, the resulting cavities are found to independently grow and break off from the cylinder even for the Type (c).
Graphical abstract
Similar content being viewed by others
References
Cointe R, Armand JL (1987) Hydrodynamic impact analysis of a cylinder. ASME J Offshore Mech Arctic Eng 109:237–243
Greenhow M (1988) Water-entry and -exit of a horizontal circular cylinder. Appl Ocean Res 10:191–198
Lin MC, Shieh LD (1997) Simultaneous measurements of water impact on a two-dimensional body. Fluid Dyn Res 19:125–148
Oliver JM (2007) Second-order Wagner theory for two-dimensional water-entry problems at small deadrise angles. J Fluid Mech 572:59–85
Ueda Y, Uemura T, Iguchi M (2011) Entry of inclined hydrophobic and hydrophilic circular cylinders into water. J Vis 14:7–9
Ueda Y, Iguchi M (2011) Rupture of cavity film due to water entry of horizontal superhydrophobic circular cylinders. ISIJ Int (Submitted)
Wagner H (1932) Über stoß- und gleitvorgänge an der oberfläche von flüssigkeiten. Z Angew Math Mech 12:193–215
Zhang Y, Zou Q, Greaves D, Reeve D, Hunt-Raby A, Graham D, James P, Lv X (2010) A level-set immersed boundary method for water entry and exit. Commun Comput Phys 8:265–288
Zhu X, Faltinsen OM, Hu C (2007) Water entry and exit of a horizontal circular cylinder. ASME J Offshore Mech Arctic Eng 129:253–264
Acknowledgments
The present authors would express their sincere thanks to Photron Ltd., for providing the high-speed camera of FASTCAM SA5 model.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ueda, Y., Iguchi, M. Water entry of stripe-coated hydrophobic circular cylinders. J Vis 15, 33–35 (2012). https://doi.org/10.1007/s12650-011-0106-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12650-011-0106-x