Abstract
In this paper, the optimal power distribution of the front and rear motors for minimizing energy consumption of a 4WD EV is investigated. An optimal power distribution control is developed based on the mathematical energy consumption model of an EV. The objective function is defined while ignoring time. And, the time effect is applied by considering the objective function for every single driving point which consists of the vehicle driving force and velocity. From the optimization problem, the optimal torque distribution maps of the front and rear motors can be obtained for all vehicle driving force and velocity ranges. These maps can be expressed using a 3-dimensional map. If the vehicle driving force and velocity are determined, the optimal front and rear motor torques can be determined using these maps. These maps can distribute the front and rear motor torques for the entire velocity range. Thus, these maps can perform the optimal power (torque times speed) distribution of the front and rear motors for minimizing the energy consumption of the 4WD EV. The performance of the optimal power distribution is evaluated by comparing the energy consumption to that of simple power distribution control. For obtaining the energy consumption, a vehicle driving simulation is performed. For the simulation, the driving cycle is required, and the NEDC (New European Driving Cycle) is used. From the simulation results, it is found that the energy consumption of simple power distribution is 4.8 % larger than the optimal one. Thus, the optimal power distribution can minimize the 4WD EV energy consumption as the optimization objective function.
Similar content being viewed by others
References
Anwar, S., Reyhart, D. and Reyhart, D. (2011). Optimal control of an on-demand all-wheel drive system (ODAWD) for vehicle traction enhancement. Int. J. Vehicle Design 56, 1/2/3/4, 270–298.
Chen, B. and Kuo, C. (2014). Electronic stability control for electric vehicle with four in-wheel motors. Int. J. Automotive Technology 15, 4, 573–580.
Gu, J., Ouyang, M., Lu, D., Li, J. and Lu, L. (2013). Energy efficiency optimization of electric vehicle driven by inwheel motors. Int. J. Automotive Technology 14, 5, 763–772.
Hu, J., Huang, Y. and Hu, F. (2012). Development of traction control for front-wheel drive in-wheel motor electric vehicles. Int. J. Electric and Hybrid Vehicles 4, 4, 344–358.
Hu, J., Huang, Y. and Hu, F. (2013). Running performance of front-and-rear-wheel-independent-drive-type electric vehicle suitable for next-generation electric vehicles. Int. J. Power Electronics 5, 2, 95–114.
Ishihara, Y., Takagi, H. and Asao, K. (2011). Aerodynamic development of the newly developed electric vehicle. SAE Paper No. 2011-39-7230.
Kamachi, M. and Hosokawa, T. (2011). Study on practicality of electric vehicle i-MiEV under severe weather. SAE Paper No. 2011-39-7241.
Kim, D., Hwang, S. and Kim, H. (2008). Vehicle stability enhancement of four-wheel-drive hybrid electric vehicle using rear motor control. IEEE Trans. Vehicular Technology 57, 2, 727–735.
Kim, J., Kim, T., Min, B., Hwang, S. and Kim, H. (2011). Mode control strategy for a two-mode hybridelectric vehicle using electrically variable transmission (EVT) and fixed-gear mode. IEEE Trans. Vehicular Technology 60, 3, 793–803.
Ko, S., Ko, J., Lee, S., Cheon, J. and Kim, H. (2014). Vehicle velocity estimation using effective inertia for an in-wheel electric vehicle. Int. J. Automotive Technology 15, 5, 815–821.
Mutoh, N. (2009). front and rear wheel independent drive type electric vehicle (FRID EV) with compatible driving performance and safety. World Electric Vehicle Journal, 3, 1–10.
Montazeri-Gh, M. and Pourbafarani, Z. (2012). Simultaneous design of the gear ratio and gearshift strategy for a parallel hybrid electric vehicle equipped with AMT. Int. J. Vehicle Design 58, 2/3/4, 291–306.
Ngo, V., Navarrete, J., Hofman, T., Steinbuch, M. and Serrarens, A. (2013). Optimal gear shift strategies for fuel economy and driveability. Proc. Instn. Mech. Engrs., Part D: J. Automobile Engineering 227, 10, 1398–1413.
Palin, R., Johnston, V., Johnson, S., D’Hooge, A., Duncan, B. and Gargoloff, J. (2012). The aerodynamic development of the Tesla model S — Part 1: Overview. SAE Paper No. 2012-01-0177.
Sakai, S., Sado, H. and Hori, Y. (1999). Motion control in an electric vehicle with four independently driven inwheel motors. IEEE/ASME Trans. Mechatron. 4, 1, 9–16.
Zhao, Y. and Zhang, J. (2009)a). Yaw stability control of a four-independent-wheel drive electric vehicle. Int. J. Electric and Hybrid Vehicles 2, 1, 6–476.
Zhao, Y. and Zhang, J. (2009)b). Modelling and simulation of the electronic differential system for an electric vehicle with two-motor-wheel drive. Int. J. Vehicle Systems Modeling and Testing 4, 1/2, 117–131.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, J. Optimal power distribution of front and rear motors for minimizing energy consumption of 4-wheel-drive electric vehicles. Int.J Automot. Technol. 17, 319–326 (2016). https://doi.org/10.1007/s12239-016-0032-y
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12239-016-0032-y