Skip to main content
Log in

Laminar flow heat transfer studies in a twisted square duct for constant wall heat flux boundary condition

  • Published:
Sadhana Aims and scope Submit manuscript

Abstract

The problem of fluid flow and heat transfer was studied for flow inside twisted duct of square cross-section. Three-dimensional numerical solutions were obtained for steady fully developed laminar flow and for uniform wall heat flux boundary conditions using commercially available software. Reynolds number range considered was 100–3000. Twist ratio used are 2.5, 5, 10 and 20. Fluids considered are in Prandtl number range of 0.7–20. Product of friction factor and Reynolds number is found to be a function of Reynolds number and maximum values are observed for a twist ratio of 2.5 and Reynolds number of 3000. Maximum Nusselt number is observed for the same values along with Prandtl number of 20. Correlations for friction factor and Nusselt number are developed involving swirl parameter. Local distribution of friction factor ratio and Nusselt number across a cross-section is presented. Based on constant pumping power criteria, enhancement factor is defined to compare twisted ducts with straight ducts. Selection of twisted square duct is presented in terms of enhancement factor. It is found that twisted duct performs well in the laminar region for range of parameters studied. Heat transfer enhancement for Reynolds number of 3000 and Prandtl number of 0.7 for twist ratio of 2.5, 5, 10, and 20 is 20%, 17.8%, 16.1% and 13.7%, respectively. The results are significant because it will contribute to development of energy efficient compact size heat exchangers.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15

Similar content being viewed by others

References

  • Bishara F 2010 Numerical simulation of fully developed Laminar flow and Heat transfer in Isothermal Helically Twisted tubes with Elliptical cross-section, M.S. Thesis, University of Cincinnati, Cleveland state, USA

  • Chang K S, Choi J S and Kim J S 1988 Laminar fluid flow in a Twisted Elliptic tube. KSME J. 2(1): 44–51

  • Incropera F P and Dewitt D P 1996 Fundamentals of heat and mass transfer, fourth edition, John Wiley and Sons, pp. 419–481

  • Manglik R M and Bergles A E 1993 Heat transfer and pressure drop correlations for twisted - tape inserts in isothermal flows. J. Heat Transfer 115: 881–889

  • Masliyah J H and Nandakumar K 1981a Steady laminar flow through twisted pipes – fluid flow in square tubes. ASME J. Heat Transfer 103(4): 785–790

  • Masliyah J H and Nandakumar K 1981b Steady laminar flow through twisted pipes – heat transfer in square tubes. ASME J. Heat Transfer 103(4): 791–795

  • Todd L 1977 Some comments on steady laminar flow through twisted pipes. J. Eng. Mathematics 11: 29–48

  • Xu C G and Fan D N 1986 Some remarks on the helical Cartesian coordinates system and its application. ASME J. Heat Transfer 108: 483–486

  • Yang S, Zhang L and Xu H 2011 Experimental study on convective heat transfer and flow resistance characteristics of water flow in Twisted Elliptical tubes. Appl. Thermal Eng. 31(14–15): 2981–2991

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to S V PRABHU.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

BHADOURIYA, R., AGRAWAL, A. & PRABHU, S.V. Laminar flow heat transfer studies in a twisted square duct for constant wall heat flux boundary condition. Sadhana 40, 467–485 (2015). https://doi.org/10.1007/s12046-015-0345-y

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12046-015-0345-y

Keywords

Navigation