Abstract
The flow pattern behaviour of falling liquid film over three horizontal cylinders was evaluated. These flows can take three forms: discrete droplets, individual jets, and continuous sheet, and special attention is paid to the effects of the physical properties and geometrical parameters of the first two forms (droplets and jets) because these forms are more important in heat-transfer behaviour and less research has been published for these forms. The flow modes and experimental results were successfully compared with previous experimental literatures, and also the effects of liquid flow rate, tube diameter, and tube spacing on departure site spacing, in both drop and jet modes, were evaluated in the low Galileo number and high viscosity fluid (cooking oil), to help developing criteria for determining falling film modes and their transitions, and to understand the heat transfer characteristics associated with each mode.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
MITROVIC J. Influence of tube spacing and flow rate on heat transfer from a horizontal tube to a falling liquid film [C]// Proceedings of the 8th International Heat Transfer Conference. San Francisco, 1986: 1949–1956.
HU X, JACOBI A M. The intertube falling film: Part I-Flow characteristics, mode transitions, and hysteresis [J]. Heat Transfer, 1996, 118: 616–625.
HU X, JACOBI A M. Departure-site spacing for liquid droplets and jets falling in thin-film heat exchangers [J]. ACRC CR9, 1997, Urbana, IL61801. 217: 333–3115.
LIENHARD J H, WONG P T Y. The dominant useable wavelength and minimum heat flux during film boiling on a horizontal cylinder [J]. Heat Transfer, 1964, 86: 220–226.
BELLMAN R, PENNINGTON R H. Effects of surface tension and viscosity on Taylor instability [J]. Appl Math, 1954, 12: 151–162.
YUNG D, LORENTZ J, GANIC E N. Vapor/liquid interaction and entrainment in falling film evaporators [J]. Heat Transfer, 1980, 102: 20–25.
TAGHAVI K, DHIR V K. Taylor instability in boiling, melting and condensation or evaporation [J]. Heat Mass Transfer, 1980, 23: 1433–1445.
AMBRUSTER R, MITROVIC J. Heat transfer in falling film on a horizontal tube [C]// Proceedings of the National Heat Transfer Conference, 1995: 13–21.
HU X, JACOBI A M. The intertube falling film: Part 2-Mode effects on sensible heat transfer to a falling liquid film [J]. Heat Transfer, 1996, 118: 626–633.
MOHAMED A M I. Flow behaviour of liquid falling film on a horizontal rotating tube [J]. Experimental Thermal and Fluid Science, 2007, 31: 325–332.
TANG J, LU Z, B. Yu-Chi. Droplet spacing of falling film flow on horizontal tube bundles [C]// Proceedings of the 18th International Congress of Refrigeration. Montreal, 1991: 474–478.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Chung, Hs., Wusiman, K., Kim, Ss. et al. Liquid film falling behaviour on horizontal circular cylinder. J. Cent. South Univ. Technol. 19, 1353–1358 (2012). https://doi.org/10.1007/s11771-012-1149-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11771-012-1149-4