Avoid common mistakes on your manuscript.
The U-W phase diagram in [Massalski2] was redrawn from [1988Pan], which was based on [1950Sch], [1972Ack], and [1985Sar]. The data of [1972Ack] are preferred and weighted most heavily. Because the data points given in [1972Ack] were given only for the range <12.5 at.% W, the phase diagram above 12.5 at.% W was drawn by speculation.
Figure 1 shows the U-W phase diagram calculated by [2008Wan]. In this calculation, the data points reported by [1986Cha] were also used, in addition to those shown in the evaluation by [1988Pan]. The (W) liquidus is higher in the diagram of [2008Wan] than that in the diagram of [1988Pan], up to ∼250 °C higher at ∼60 at.% W.
References
C.H. Schramm, P. Gordon, and A.R. Kaufmann, “The Alloy Systems Uranium-Tungsten, Uranium-Tantalum, and Tungsten-Tantalum.” Trans. AIME. 188, pp. 195-204 (1950)
R.J. Ackermann and E.G. Rauh, “Measurements of Solubilities and Derived Thermodynamic Properties of Tungsten and Tantalum in Liquid Thorium and Uranium.” High Temp. Sci. 4, pp. 496-505 (1972)
A. Saroja, Y.J. Bhatt, and S.P. Garg, “Determination of Thermodynamic Properties of Liquid Th-Mo, U-Mo, Th-Ta, U-Ta, Th-W, and UW Alloys from Their Diagrams.” J. Less-Common Met. 114, pp. 291-297 (1985)
M.S. Chandrasekharaiah, S.R. Dharwadkar, and D. Das, “High-Temperature Phase Diagrams of Re-U, Ta-U, and W-U.” Z. Metallkd. 77(8), pp. 509-514 (1986)
S. Pandian, S.V. Nagender Naidu, and P. Rama Rao, “The W-U (Tungsten-Uranium) System. J. Alloy Phase Diagrams. 4(3), pp. 148-153 (1988)
J. Wang, X.J. Liu, and C.P. Wang, “Thermodynamic Calculation of Phase Equilibria of the U-Ta and U-W Systems.” J. Nucl. Mater. 380, pp. 105-110 (2008)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Okamoto, H. U-W (Uranium-Tungsten). J. Phase Equilib. Diffus. 30, 415 (2009). https://doi.org/10.1007/s11669-009-9540-z
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11669-009-9540-z