The high-temperature reliability of active metal brazed copper (AMC) on Si3N4 ceramic substrates used for fabricating SiC high-temperature power modules was investigated under harsh environments. The AMC substrate underwent isothermal storage at 300°C for up to 3000 h and a thermal cycling test at −40°C to 300°C for up to 3000 cycles. During isothermal storage at 300°C, the AMC substrate exhibited high reliability, characterized by very little deformation of the copper (Cu) layer, low crack growth, and low oxidation rate of the Cu layer. Under thermal cycling conditions at −40°C to 300°C, no detachment of the Cu layer was observed even after the maximum 3000 cycles of the experiment. However, serious deformation of the Cu layer occurred and progressed as the number of thermal cycles increased, thus significantly roughening the surface of the Cu metallized layer. The cyclic thermal stress led to a significant increase in the crack growth and oxidation of the Cu layer. The maximum depth of the copper oxides reached up to 5/6 of the Cu thickness. The deformation of the Cu layer was the main cause of the decrease of the bond strength under thermal cycling conditions. The shear strength of the SiC chips bonded on the AMC substrate with a Au-12 wt.%Ge solder decreased from the original 83 MPa to 14 MPa after 3000 cycles. Therefore, the cyclic thermal stress destroyed the Cu oxides and enhanced the oxidation of the Cu layer.
Similar content being viewed by others
References
N. Chasserio, S. Guillemet-Fritsch, T. Lebey, and S. Dagdag, J. Electron. Mater. 38, 164 (2009).
W.W. Sheng and P.R. Colino, Power Electronic Modules: Design and Manufacture (New York: CRC Press, 2005).
K. Sheng and Q. Guo, ECS Trans. 50, 179 (2013).
R.A.R. Young, D. Clark, J.D. Cormack, A.E. Murphy, D.A. Smith, and R.F. Thompson, Mater. Sci. Forum 740–742, 1065 (2013).
R. Kirschman, High Temperature Electronics (New York: IEEE Press, 1999).
F.Q. Lang, H. Yamaguchi, and H. Sato, International Conference and Exhibition on High Temperature Electronics (HiTEN2011), Oxford, UK, July 2011, pp. 139–144.
P. McCluskey, Reliability of power electronics under thermal loading. 7th International Conference on Integrated Power Electronics Systems (CIPS2012), March 2012, Nuremberg, Germany, paper 04.1.
Y. Zhou, H. Hyuga, D. Kusano, Y. Yoshizawa, and K. Hirao, Adv. Mater. 23, 4563 (2011).
I. Sichert, G. Boehm, D. Brunner, A. Poenike, and J. Schilm, 44th International Symposium on Microelectronics (IMAPS2011) (Long Beach, CA, 2011), pp. 777–784.
F. Huet, M.-A. Di Forte-Poisson, M. Calligaro, J. Olivier, F. Wyczisk, and J. Di Persio, J. Electron. Mater. 28, 1440 (1999).
Y.F. Zhu, K. Mimura, and M. Ishiki, Mater. Trans. 43, 2173 (2002).
K. Mimura, J.W. Lim, M. Ishiki, Y.F. Zhu, and Q. Jiang, Metall. Mater. Trans. A 37, 1231 (2006).
A.A. Ogwu, T.H. Darma, and E. Bouquerel, J. Achiev. Mater. Manuf. Eng. 24, 172 (2007).
C. Lu, C.L. Chu, C.Y. Lai, and Y.H. Wang, Thin Solid Films 517, 4408 (2009).
F.Q. Lang, H. Yamaguchi, H. Nakagawa, and H. Sato, Proceedings of 2012 International Conference in Advanced Manufacturing for Multifunctional Miniaturized Devices, May 2012, Wuhan, China, pp. 37–38.
K. Gupta, J.P. Marton, and J. Shewchun, J. Electrochem. Soc. 121, 118 (1974).
D.J. Siconlfi and Frankenthal, J. Electrochem. Soc. 136, 2475 (1989).
J.Y. Song and J. Yu, Thin Solid Films 415, 167 (2002).
Y.D. Jeon, IEEE Trans. Compon. Packag. Technol. 25, 169 (2002).
Y. Takaku, K. Makino, K. Watanabe, I. Ohnuma, R. Kainuma, Y. Yamada, Y. Yagi, I. Nakagawa, T. Atsumi, and K. Ishida, J. Electron. Mater. 38, 54 (2009).
Acknowledgements
This work was supported by the New Energy and Industrial Technology Development Organization (NEDO) Project, Development of Next-Generation Power Electronics. This work was mainly conducted at the Advanced Power Electronics Research Center (ADPERC), National Institute of Advanced Industrial Science and Technology (AIST).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lang, F., Yamaguchi, H., Nakagawa, H. et al. Cyclic Thermal Stress-Induced Degradation of Cu Metallization on Si3N4 Substrate at −40°C to 300°C. J. Electron. Mater. 44, 482–489 (2015). https://doi.org/10.1007/s11664-014-3357-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-014-3357-1