Abstract
To satisfy the needs of the high deep-width ratio and thickness of a planar micromotor’s stator windings, a process method to produce an electromagnetic planar micromotor with AZ4903 is proposed. Optimum relationships, such as the desired rotation speed vs. thickness of the coating process, and the temperature vs. time of pre-baking, are obtained. The appropriate time of lithography and development are also achieved. The thickness of the produced windings is 40 μm with ideal perpendicularity. Finally, stators and rotors are fabricated. The rotation speed and pull-out torque of the micromotor are tested. The experiment proved that the micromotor worked with a steady speed and a low ripple of pull-out torque.
Similar content being viewed by others
References
Carol L, Anthony R F, Theoeore, et al. A high-power MEMS electric induction motor. Journal of Microelectromechanical Systems, 2004, 13(3): 465–471
Gilles P A, Delamare J, Cugat O, et al. Design of a permanent magnet planar synchronous micromotor. IEEE Industry Applications Society, 2000, 1: 223–227
Daniel J S, Trifon M L, Chong H A. A universal electromagnetic interconnection microactuator using magnetic interconnection concepts. Journal of Microelectromechanical System, 2000, 9(4): 460–468
Neugebauer T C, Perreault D J, Lang J H, et al. A six-phase multilevel inverter for MEMS electrostatic induction micromotors. IEEE Transactions on Circuits-II: Express Briefs, 2004, 51(2): 49–56
Nakamatsu K I, Keiichiro W, Katsuhiko T, et al. Bilayer resist method for room-temperature nanoimprint lithography. Microprocesses and Nanotechnology, 2004, 43(6): 4050–4053
Chad B, Rafiqul I, Helge L. Ultra-thick lithography for advanced packaging and MEMS. Proceedings of SPIE, 2002, 4690: 270–276
Liu Zhongan. Optimization of photolithography process parameters. Semiconductor Optoelectronics, 2001, 1: 52–54
Author information
Authors and Affiliations
Corresponding author
Additional information
__________
Translated from J Tsinghua Univ (Sci & Tech) 2005, 45(8): 1062–1065 [译自: 清华大学学报(自然科学版)]
Rights and permissions
About this article
Cite this article
Guo, Z., Wu, Y., Meng, Y. et al. Application of AZ4903 to production of stator windings. Front. Mech. Eng. China 3, 76–80 (2008). https://doi.org/10.1007/s11465-008-0010-9
Issue Date:
DOI: https://doi.org/10.1007/s11465-008-0010-9