Abstract
The majority of OECD (Organisation for Economic Co-operation and Development) ready biodegradation test methods require a relatively high concentration of test substance. Such high dosage concentrations are unsuitable for screening of inhibitory or biocidal compounds. Unfortunately, the method with the lowest dosage concentration (Closed Bottle Test, 301D) also has the lowest biodegradation potential. Therefore, we have evaluated the ability of the Manometric Respirometry (301F) test method to study biodegradation of test substances at concentrations of a few mgl−1, using sodium acetate as a model substance. Results have been compared to those obtained from closed bottle tests (301D). Problems with using activated sewage as an inoculum have been demonstrated, as respirometry curves were biphasic, and the recorded biological oxygen demand (BOD) was higher than the calculated theoretical oxygen demand (ThOD). A consortium of bacteria isolated from activated sewage was used as an alternative inoculum. Using the alternative inoculum for respirometry tests, monophasic growth curves were observed with recorded BOD values at expected levels. Sensitivity thresholds for the respirometer tests were comparable to those in closed bottles, with biodegradation being detected at concentrations as low as 2.5 mgl-1 ThOD. Comparison of whole community carbon source utilisation profiles for both inocula (obtained using BIOLOG microplates) revealed their catabolic potential to be similar. Therefore, use of an activated sewage-derived inoculum is recommended as an alternative inoculum for respirometer-based biodegradation testing.
Similar content being viewed by others
References
Asano, Y., & Watanabe, S. (2001). Isolation of poly(3-hydroxybutyrate) (PHB)-degrading microorganisms and characterization of PHB-depolymerase from Arthrobacter sp. strain W6. Bioscience Biotechnology Biochemistry, 65, 1191–1194.
Blok, J., de Morsier, A., Gerike, P., Reynolds, L., & Wellens, H. (1985). Harmonisation of ready biodegradability tests. Chemosphere, 14, 1805–1820.
Bramucci, M., Kane, H., Chen, M., & Nagarajan, V. (2003). Bacterial diversity in an industrial wastewater bioreactor. Applied Microbiology Biotechnology, 62, 594– 600.
Bramucci, M.G., & Nagarajan, V. (2000). Industrial wastewater bioreactors: sources of novel microorganisms for biotechnology. Trends Biotechnol, 18, 501–505.
Carucci, A., Dionisi, D., Majone, M., Rolle, E., & Smurra, P. (2001). Aerobic storage by activated sludge on real wastewater. Water Research 35, 3833–3844
Fang, H.H.P., & Liu, Y. (2000). Intracellular polymers in aerobic sludge of sequencing batch reactors. Journal of Environmental Engineering, 126, 732–738.
Forney, L.J., Liu, W.-T., Guckert, J.B., Kumagai, Y., Namkung, E., Nishihara, T., & Larson, R. J. (2001). Structure of microbial communities in activated sludge: potential implications for assessing the biodegradability of chemicals. Ecotoxicology Environment Safety, 49, 40–53.
Gerike, P., & Fischer, W.K. (1979). A correlation study of biodegradability determinations with various chemicals in various tests. Ecotoxicology Environment Safety, 3, 159–173.
Gerike, P., & Fischer, W.K. (1981). A correlation study of biodegradability determinations with various chemicals in various tests II. Additional results and conclusions. Ecotoxicology Environment Safety, 5, 45–55.
Ginestet, P., Audic, J.-M., Urbain, V., & Block, J.-C. (1998). Estimation of nitrifying bacterial activities by measuring oxygen uptake in the presence of the metabolic inhibitors allylthiourea and azide. Applied Environment Microbiology, 64, 2266–2268.
van Ginkel, C.G., & Kolvenbach, M. (1991). Relation between the structure of quaternary alkyl ammonium salts and their biodegradability. Chemosphere, 23, 281–289.
Hales, S.G., Philpotts, C.J., & Gillard, C. (1996). A respirometer with improved sensitivity for ready biodegradation testing. Chemosphere, 33, 1247–1259.
van Heerden, J., Ehlers, M.M., & Cloete, T.E. (2001). BIOLOG for the determination of microbial diversity in activated sludge systems. Water Science Technology, 43, 83–90.
van Loosdrectht, M.C.M., Pot, M., & Heijnen, J.J. (1997). Importance of bacterial storage polymers in activated sludge processes. Water Science Technology, 35, 41–47
Kavanaugh, R.G., & Randall, C.W. (1994). Bacterial populations in a biological nutrient removal plant. Water Science Technology, 29, 25–34.
Matsuzawa, Y., & Mino, T. (1991). Role of glycogen as an intracellular carbon reserve of activated sludge in the competitive growth of filamentous and non-filamentous bacteria. Water Science Technology, 23, 899–905.
OECD. (1981). Guidelines for testing chemicals, section III: Degradation and accumulation.
OECD. (1993). OECD guideline for testing chemicals, “ready biodegradability”.
Pagga, U. (1997). Testing biodegradability with standardized methods. Chemosphere, 35, 2953–2972.
Painter, H.A., & King, E.F. (1985). A respirometric method for the assessment of ready biodegradability: results of a ring test. Ecotoxicology Environment Safety, 9, 6–16.
Paixão, S.M., Baeta-Hall, L., & Anselmo, A.M. (2000). Evaluation of two commercial microbial inocula as seed in a 5-day biochemical oxygen demand test. Water Environment Research, 72, 282–284.
Paixão, S.M., Santos, P., Baeta-Hall, L., Tenreiro, R., & Anselmo, A.M. (2003). Alternative inocula as activated sludge surrogate culture for a toxicity test. Environment Toxicology, 18, 37–44.
Powers, E.M. (1995). Efficiency of the RYU nonstaining KOH technique for rapidly determining Gram reactions of food-borne and waterborne bacteria and yeasts. Applied Environment Microbiology, 61, 3756–3758.
Ramsay, B.A., Lomaliza, K., Chavarie, C., Dube, B., Bataille, P., & Ramsay, J.A. (1990). Production of poly-(beta-hydroxybutyric-co-beta-hydroxyvaleric) acids. Applied Enrivonment Microbiology, 56, 2093–2098.
Reuschenbach, P., Pagga, U., & Strotmann, U. (2003). A critical comparison of respirometric biodegradation tests based on OECD 301 and related test methods. Water Research, 37, 1571–1582.
Reynolds, L., Blok, J., de Morsier, A., Gerike, P., Wellens, H., & Bontinck, W.J. (1987). Evaluation of the toxicity of substances to be assessed for biodegradability. Chemosphere, 16, 2259–2277.
Saito, Y., & Doi, Y. (1994). Microbial synthesis and properties of poly(3-hydroxybutyrate-co-4-hydroxybutyrate) in Comamonas acidovorans. International Journal of Biological Macromolecules, 16, 99–104.
Schembri, M.A., Woods, A.A., Bayly, R.C., & Davis, J.K. (1995). Identification of a 13-kDa protein associated with the polyhydroxyalkanoic acid granules from Acinetobacter spp. FEMS Microbiology Letter, 15, 277–283.
Smalla, K., Wachtendorf, U., Heuer, H., Liu, W.-T., & Forney, L.J. (1998). Analysis of BIOLOG GN substrate utilisation patterns by microbial communities. Applied Environment Microbiology, 64, 1220–1225.
Strotmann, U.J., Geldern, A., Kuhn, A., Gendig, C., & Klein, S. (1999). Evaluation of a respirometric test method to determine the heterotrophic yield coefficient of activated sludge bacteria. Chemosphere, 38, 3555–3570.
Struijs, J., Stoltenkamp-Wouterse, M.J., & Dekkers, A.L.M. (1995). A rationale for the appropriate amount of inoculum in ready biodegradability tests. Biodegradation, 6, 319–327.
Tabka, H., Seignez, C., Adler, N., Pulgarin, C., & Péringer, P. (1993). Inoculumstandardization for biodegradability tests. Biotechnology Techniques, 7, 217–222.
Wieczorek, R., Pries, A., Steinbuchel, A., & Mayer, F. (1995). Analysis of a 24-kilodalton protein associated with the polyhydroxyalkanoic acid granules in Alcaligenes eutrophus. Journal of Bacteriology, 177, 2425–2435.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
O’Malley, L.P. Evaluation and Modification of the OECD 301F Respirometry Biodegradation Test Method with Regard to Test Substance Concentration and Inoculum. Water Air Soil Pollut 177, 251–265 (2006). https://doi.org/10.1007/s11270-006-9163-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11270-006-9163-5