Abstract
To address the issue of a pin sliding against a boundary film, we calculate the pressure-dependent shear strength of a bilayer of potassium chloride sandwiched between tungsten carbide (WC) slabs using first-principles, density functional theory (DFT) calculations. It has been shown experimentally that the shear strength S of a KCl film on metal substrates varies with pressure P as S = S 0 + αP, and S 0 = 65 ± 5 MPa and α = 0.14 ± 0.02. Calculations are performed for KCl in contact with the (1\( \bar{1} \)00) and (10\( \bar{1} \)0) faces of WC which have almost square surface unit cells. The effect of pressure is mimicked by varying the distance between the outermost layers of the WC slabs. The DFT calculations confirm that the shear strength depends on pressure and yield average values of S 0 of 70 ± 10 MPa for the WC(1\( \bar{1} \)00) and 51 ± 13 MPa for the WC(10\( \bar{1} \)0) faces, in reasonable agreement with experiment. Since the calculations were performed for a KCl slab in registry with the WC slabs, the agreement with experiment suggests that the atoms at the interface between the tip and film are also in registry. In addition, the calculated and experimental shear strengths are much lower than the shear modulus of KCl, indicating that shear occurs between the tip and film surface without forming a transfer film, in agreement with previous experimental measurements.
Similar content being viewed by others
References
Koskilinna, J.O., Linnolahti, M., Pakkanen, T.A.: Friction paths for cubic boron nitride: an ab initio study. Tribol. Lett. 27(2), 145–154 (2007). doi:10.1007/s11249-007-9210-4
Koskilinna, J.O., Linnolahti, M., Pakkanen, T.A.: Friction coefficient for hexagonal boron nitride surfaces from ab initio calculations. Tribol. Lett. 24(1), 37–41 (2006). doi:10.1007/s11249-006-9120-x
Neitola, R., Ruuska, H., Pakkanen, T.A.: Ab initio studies on nanoscale friction between graphite layers: effect of model size and level of theory. J. Phys. Chem. B 109(20), 10348–10354 (2005). doi:10.1021/jp044065q
Matsuzawa, N.N., Kishii, N.: Theoretical calculations of coefficients of friction between weakly interacting surfaces. J. Phys. Chem. A 101(51), 10045–10052 (1997). doi:10.1021/jp9717204
Liang, T., Sawyer, W.G., Perry, S.S., Sinnott, S.B., Phillpot, S.R.: First-principles determination of static potential energy surfaces for atomic friction in MoS2 and MoO3. Phys. Rev. B 77(10), 104105 (2008)
Smith, G.S., Modine, N.A., Waghmare, U.V., Kaxiras, E.: First-principles study of static nanoscale friction between MoO3 and MoS2. J. Comput. Aided Mater. Des. 5(1), 61–71 (1998). doi:10.1023/a:1008666530448
Tománek, D., Zhong, W.: Palladium–graphite interaction potentials based on first-principles calculations. Phys. Rev. B 43(15), 12623–12625 (1991)
Tománek, D., Zhong, W., Thomas, H.: Calculation of an atomically modulated friction force in atomic-force microscopy. Europhys. Lett. 15(8), 887 (1991)
Garvey, M., Furlong, O.J., Weinert, M., Tysoe, W.T.: Shear properties of potassium chloride films on iron obtained using density functional theory. J. Phys. Condens. Matter. 23(26), 265003 (2011). doi:10.1088/0953-8984/23/26/265003
Garvey, M., Weinert, M., Tysoe, W.T.: On the pressure dependence of shear strengths in sliding, boundary-layer friction. Tribol. Lett. 44(1), 67–73 (2011). doi:10.1007/s11249-011-9827-1
Garvey, M., Weinert, M., Tysoe, W.T.: On the film thickness dependence of shear strengths in sliding, boundary-layer friction. Wear 274–275, 281–285 (2011)
Gao, F., Kotvis, P.V., Tysoe, W.T.: The friction, mobility and transfer of tribological films: potassium chloride and ferrous chloride on iron. Wear 256(11–12), 1005–1017 (2004). doi:10.1016/j.wear.2003.06.002
Gao, F., Kotvis, P.V., Tysoe, W.T.: The frictional behavior of thin halide films on iron. Tribol. Trans. 47(2), 208–217 (2004). doi:10.1080/05698190490431894
Gao, F., Kotvis, P.V., Tysoe, W.T.: The frictional properties of thin inorganic halide films on iron measured in ultrahigh vacuum. Tribol. Lett. 15(3), 327–332 (2003). doi:10.1023/a:1024833807985
Gao, F., Wu, G., Stacchiola, D., Kaltchev, M., Kotvis, P.V., Tysoe, W.T.: The tribological properties of monolayer KCl films on iron in ultrahigh vacuum: modeling the extreme-pressure lubricating interface. Tribol. Lett. 14(2), 99–104 (2003). doi:10.1023/a:1021752203606
Gao, F., Furlong, O., Kotvis, P.V., Tysoe, W.T.: Pressure dependence of shear strengths of thin films on metal surfaces measured in ultrahigh vacuum. Tribol. Lett. 31(2), 99–106 (2008). doi:10.1007/s11249-008-9342-1
Tabor, D.: The Hardness of Metals. Clarendon Press, Oxford (1951)
Wu, G., Gao, F., Kaltchev, M., Gutow, J., Mowlem, J.K., Schramm, W.C., Kotvis, P.V., Tysoe, W.T.: An investigation of the tribological properties of thin KCl films on iron in ultrahigh vacuum: modeling the extreme-pressure lubricating interface. Wear 252(7–8), 595–606 (2002). doi:10.1016/s0043-1648(02)00009-1
Bridgman, P.W.: Shearing phenomena at high pressures, particularly in inorganic compounds. Proc. Am. Acad. Arts Sci. 71, 387–460 (1937)
Briscoe, B.J., Evans, D.C.B.: The shear properties of Langmuir–Blodgett layers. Proc. R. Soc. Lond. A Math. Phys. Sci. 380(1779), 389–407 (1982). doi:10.1098/rspa.1982.0048
Sutcliffe, M.J., Taylor, S.R., Cameron, A.: Molecular asperity theory of boundary friction. Wear 51(1), 181–192 (1978). doi:10.1016/0043-1648(78)90065-0
Singer, I.L., Bolster, R.N., Wegand, J., Fayeulle, S., Stupp, B.C.: Hertzian stress contribution to low friction behavior of thin MoS2 coatings. Appl. Phys. Lett. 57(10), 995–997 (1990)
Schwarz, U.D., Allers, W., Gensterblum, G., Wiesendanger, R.: Low-load friction behavior of epitaxial C60 monolayers under Hertzian contact. Phys. Rev. B 52(20), 14976 (1995)
Briscoe, B.J., Smith, A.C.: The influence of dynamic loading on sliding friction. Nature 278(5706), 725–726 (1979)
Riedo, E., Gnecco, E., Bennewitz, R., Meyer, E., Brune, H.: Interaction potential and hopping dynamics governing sliding friction. Phys. Rev. Lett. 91(8), 084502 (2003)
Furlong, O.J., Manzi, S.J., Pereyra, V.D., Bustos, V., Tysoe, W.T.: Kinetic Monte Carlo theory of sliding friction. Phys. Rev. B 80(15) (2009). doi:10.1103/PhysRevB.80.153408
Mikulski, P.T., Harrison, J.A.: Packing-density effects on the friction of n-alkane monolayers. J. Am. Chem. Soc. 123(28), 6873–6881 (2001). doi:10.1021/ja010189u
Gao, G.T., Mikulski, P.T., Harrison, J.A.: Molecular-scale tribology of amorphous carbon coatings: effects of film thickness, adhesion, and long-range interactions. J. Am. Chem. Soc. 124(24), 7202–7209 (2002). doi:10.1021/ja0178618
He, G., Robbins, M.O.: Simulations of the kinetic friction due to adsorbed surface layers. Tribol. Lett. 10(1–2), 7–14 (2001). doi:10.1023/a:1009030413641
Harrison, J.A., Gao, G., Schall, J.D., Knippenberg, M.T., Mikulski, P.T.: Friction between solids. Philos. Trans. R. Soc. Lond. A 366(1869), 1469–1495 (2008). doi:10.1098/rsta.2007.2169
Mikulski, P.T., Herman, L.A., Harrison, J.A.: Odd and even model self-assembled monolayers: links between friction and structure. Langmuir 21(26), 12197–12206 (2005). doi:10.1021/la052044x
Hirano, M., Shinjo, K.: Atomistic locking and friction. Phys. Rev. B 41(17), 11837–11851 (1990)
Müser, M.H.: Structural lubricity: role of dimension and symmetry. Europhys. Lett. 66(1), 97–103 (2004). doi:10.1209/epl/i2003-10139-6
Müser, M.H., Robbins, M.O.: Conditions for static friction between flat crystalline surfaces. Phys. Rev. B 61(3), 2335–2342 (2000)
Peyrard, M., Aubry, S.: Critical behaviour at the transition by breaking of analyticity in the discrete Frenkel–Kontorova model. J. Phys. C 16(9), 1593 (1983)
Zhong, Y., Zhu, H., Shaw, L.L., Ramprasad, R.: The equilibrium morphology of WC particles—a combined ab initio and experimental study. Acta Mater. 59(9), 3748–3757 (2011). doi:10.1016/j.actamat.2011.03.018
Kong, X.-S., You, Y.-W., Xia, J.H., Liu, C.S., Fang, Q.F., Luo, G.N., Huang, Q.-Y.: First principles study of intrinsic defects in hexagonal tungsten carbide. J. Nucl. Mater. 406(3), 323–329 (2010). doi:10.1016/j.jnucmat.2010.09.002
Gaston, N., Hendy, S.: Hydrogen adsorption on model tungsten carbide surfaces. Catal. Today 146(1–2), 223–229 (2009). doi:10.1016/j.cattod.2008.10.050
Marinelli, F., Jelea, A., Allouche, A.: Interactions of H with tungsten carbide surfaces: an ab initio study. Surf. Sci. 601(2), 578–587 (2007). doi:10.1016/j.susc.2006.10.044
Juslin, N.: Analytical interatomic potential for modeling nonequilibrium processes in the W–C–H system. J. Appl. Phys. 98(12), 123520 (2005)
Wyckoff, R.W.G.: Crystal Structures. Interscience Publishers, New York (1963)
Weinert, M., Wimmer, E., Freeman, A.J.: Total-energy all-electron density functional method for bulk solids and surfaces. Phys. Rev. B 26(8), 4571 (1982)
Wimmer, E., Krakauer, H., Weinert, M., Freeman, A.J.: Full-potential self-consistent linearized-augmented-plane-wave method for calculating the electronic structure of molecules and surfaces: O2 molecule. Phys. Rev. B 24(2), 864 (1981)
Perdew, J.P., Burke, K., Ernzerhof, M.: Generalized gradient approximation made simple. Phys. Rev. Lett. 77(18), 3865 (1996)
Tomlinson, G.A.: A molecular theory of friction. Philos. Mag. 7, 905 (1929)
Gao, F., Furlong, O., Kotvis, P., Tysoe, W.: Tribological properties of films formed by the reaction of carbon tetrachloride with iron. Tribol. Lett. 20(2), 171–176 (2005). doi:10.1007/s11249-005-8313-z
Bauer, E.: Epitaxy of metals on metals. Appl. Surf. Sci. 11–12, 479–494 (1982). doi:10.1016/0378-5963(82)90094-0
Filleter, T., Paul, W., Bennewitz, R.: Atomic structure and friction of ultrathin films of KBr on Cu(100). Phys. Rev. B 77(3), 035430 (2008)
Acknowledgments
This work was supported by the National Science Foundation under grant number CMMI 0826151.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Garvey, M., Weinert, M. & Tysoe, W.T. Pressure Dependence of the Shear Strengths of the Tungsten Carbide–Potassium Chloride Interface. Tribol Lett 50, 105–113 (2013). https://doi.org/10.1007/s11249-013-0109-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11249-013-0109-y