Calcium requirement of wheat in saline and non-saline conditions

Abstract

Supplemental calcium (Ca²⁺) is used in hydroponic studies on salinity to lessen the potential for Ca²⁺ deficiency. However, the Ca²⁺ concentration and the sodium (Na⁺): Ca²⁺ ratio used vary considerably. The implications of using a wide range of Na⁺: Ca²⁺ ratios for studies of salinity tolerance in wheat are not known. Also, despite the risk of development of Ca²⁺ deficiency under salinity stress, there are few reliable reports on the critical level of Ca²⁺ which can be used to diagnose Ca²⁺ deficiency in wheat. Two experiments were conducted to examine Ca²⁺ requirements of wheat under saline and non-saline conditions and to derive a critical level for Ca²⁺. Four bread wheat genotypes (Triticum aestivum L.) and a durum wheat genotype [Triticum turgidum subsp. durum) (Desf.) Husn.] with known differences in salinity tolerance were grown at 100 mM NaCl for four weeks with varying levels of external Ca²⁺ which resulted in Na⁺:Ca²⁺ ratios of 30, 20, 15, 5 and 2. The critical Ca²⁺ concentration was defined in a second experiment by growing the same wheat genotypes at seven levels of Ca²⁺ (0.05, 0.1, 0.2, 0.5, 1, 2 and 10 mM) under non-saline conditions. When grown at 100 mM NaCl salinity tolerance was greatest when the Na⁺:Ca²⁺ ratio ranged from 5 to 15. Growing plants at lower or higher Na⁺:Ca²⁺ ratios induced nutrient imbalances and additional osmotic stress which reduced the growth of plants. Transient Ca²⁺ deficiency occurred at high Na⁺:Ca²⁺ ratios and low Mg²⁺ occurred at the lowest Na⁺:Ca²⁺ ratio. Adding NaCl raised the tissue Na⁺ concentration and reduced the Ca²⁺ concentration and the most appropriate Na⁺:Ca²⁺ ratio in the solution was that which resulted in tissue Ca²⁺ concentrations similar to those of non-salinised plants. The critical level of Ca²⁺ in the youngest fully emerged leaf blades was 15–23 mmol kg^-1 DW (600–900 mg kg^-1 DW).