To develop their previous results, the authors demonstrated that the structural-type phases Th2Ni17 and Th2Zn17 may be represented as the densest helical packing of tetrablock chains as linear 7-vertex unions of four tetrahedrons over faces. It was concluded that the tetrablock can be used as a universal building unit, including more complex structural types of Frank–Kasper phases than those considered in our previous works.
Similar content being viewed by others
References
A. L. Talis, A. A. Everstov, V. S. Kraposhin, and N. D. Simich-Lafitsky, “Assembly of structural types of Frank–Kasper phases Cr3Si, MgCu2, and MgZn2 from a universal building unit,” Metalloved. Term. Obrab. Met., No. 11, 3 – 7 (2020).
A. L. Talis, A. A. Everstov, V. S. Kraposhin, and N. D. Simich-Lafitsky, “Presentation of structural types of copper, diamond, and tungsten based on a universal building unit,” Metalloved. Term. Obrab. Met., No. 12, 3 – 8 (2020).
V. S. Kraposhin, A. Y. Talis, “Non-crystallographic symmetries of the crystal structure of cementite and its transformations,” in: V. M. Schastlivtsev (ed.), Cementite in Carbon Steels, Multi-Authored Monograph [in Russian], Izd-vo UMC UPI, Ekaterinburg (2017), Chapter 2, pp. 42 – 79 (ISBN: 978-5-8295-0534-9).
K. H. J. Buschow, “Intermetallic compounds of rare earth elements and Ni, Co, or Fe,” Phys. Stat. Sol., 7(a), 199 – 210 (1971).
V. S. Kraposhin, Investigation of the Magnetic Properties of the SmCo5 compound and the Technology of Manufacturing Permanent Magnets from this Compound, Author’s Abstract of Candidate’s Thesis [in Russian], Moscow (1973).
I. N. Buryakov, A. V. Kamynin, A. A. Everstov, et al., “Microstructure of Sm2Fe17 intermetallic ingot and its homogenization,” Metalloved. Term. Obrab. Met., No. 10, 23 – 27 (2016).
A. L. Talis, “Regularities in the structure of gas hydrates and structures determined by the 8-dimensional lattice E8,” Dokl. Akad. Nauk, 390(2), 172 – 177 (2003).
This work was supported by the Russian Foundation for Basic Research (grant No. 19-02-00085). The symmetry regularities in the structure of close-packed tetrahedral structures were established with the support of the Ministry of Science and Higher Education of the Russian Federation using the electronic scientific resources of the A. N. Nesmeyanov Institute of Elementorganic Compounds of the Russian Academy of Sciences (construction of structural models as geometric implementations of mathematical constructions) and N. E. Bauman Moscow State Technical University (comparison of models with experimental data and computer simulation).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 6, pp. 47 – 51, June, 2022.
Rights and permissions
Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Talis, A.L., Kraposhin, V.S. & Everstov, A.A. Assembly of Structural-Type R2T17 from a Universal Building Unit. Met Sci Heat Treat 64, 338–342 (2022). https://doi.org/10.1007/s11041-022-00811-z
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-022-00811-z