Abstract
Designing a computerized metrological support system is considered, which incorporates not only metrological considerations on measuring instruments but also the computerized choice of production preparation facilities. Representations are considered for information on measuring instruments that allow one to integrate the metrological system in a unified CALS system for the organization.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Yu. M. Solomentsev et al., An Information Processing System for Engineering CALS Technology [in Russian], Nauka, Moscow (2003).
M. N. Selivanov, Izmer. Tekh., No. 6, 11 (1987).
GOST R ISO 10303, Systems for Automating and Integrating Production: Presentation of Data on Workpieces and Data Exchange [in Russian].
OMG Unified Modeling Language Specification, March 2003, Version 1.5, formal/03-03-01.
GOST 8.051-81, The State System of Measurements: Errors Allowed in Measuring Linear Dimensions up to 500 mm [in Russian].
Additional information
__________
Translated from Izmeritel’naya Tekhnika, No. 6, pp. 22–26, June, 2006.
Rights and permissions
About this article
Cite this article
Pashkin, E.A. Designing a computerized metrological production support system based on cals technologies. Meas Tech 49, 557–561 (2006). https://doi.org/10.1007/s11018-006-0149-x
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11018-006-0149-x