Abstract
Accurate measurement of elastic constants in resonant ultrasound spectroscopy (RUS) depends on a perfect matching in the calculated and measured mode frequencies of free vibration of the solid specimen under study. Calculation of these frequencies requires estimated values of the elastic constants of the material. The present work proposes and demonstrates a method to derive initial guess values of the essential parameters for an isotropic and homogeneous material from the acquired RUS spectra itself. Specimen samples are prepared in the shape of rectangular parallelepiped having nearly same cross-sectional dimension but with different lengths. For particular compression (shear) mode corresponding to length l, the frequency f is inversely proportional to l. The slope m of f versus 1/l plot equals half of the compression (shear) velocity and this in turn gives an estimate of \( c_{11} \) (\( c_{44} \)). With these parameters as the input guess parameters, RUS fitting method is executed to find out the best fit results. \( c_{44} \) obtained in this way is a good estimate close to its actual value. Further refinement of the parameter values is achieved by identifying volume oscillation mode frequencies for various sample lengths from the best fit frequency table of RUS output. The slope m of f versus 1/l plot for these modes corresponds to the bulk modulus (K). \( c_{11} \) calculated from K and \( c_{44} \) is a better estimate and a second step fitting method with these parameters as the input values gives final output values with improved accuracy. Elastic constants of commercially available specimens of aluminum, copper, lead, steel and brass are measured in this method assuming macroscopic homogeneity. Results are compared and found to be in good agreement with available literature values.
Similar content being viewed by others
References
Holland, R.: Resonant properties of piezoelectric ceramic rectangular parallelepipeds. J. Acoust. Soc. Am. 43, 988 (1968)
Demarest Jr., H.: Cube resonance method to determine the elastic constants of solids. J. Acoust. Soc. Am. 49, 768–775 (1971)
Ohno, I.: Free vibration of a rectangular parallelepiped crystal and its application to determination of elastic constants of orthorhombic crystals. J. Phys. Earth 24, 355–379 (1976)
Migliori, A., Visscher, W.M., Brown, S.E., Fisk, Z., Cheong, S.-W., Alten, B., Ahrens, E.T., Kubat-Martin, K.A., Maynard, J.D., Huang, Y., Kirk, D.R., Gillis, K.A., Kim, H.K., Chan, M.H.W.: Elastic constants and specific-heat measurements on single crystals of La2CuO4. Phys. Rev. B 41, 2098–2102 (1990)
Visscher, W.M., Migliori, A., Bell, T.M., Reinert, R.A.: On the normal modes of free vibration of inhomogeneous and anisotropic elastic objects. J. Acoust. Soc. Am. 90, 2154–2162 (1991)
Migliori, A., Sarrao, J.: Resonant Ultrasound Spectroscopy. Wiley, New York (1997)
Maynard, J.: The use of piezoelectric film and ultrasound resonance to determine the complete elastic tensor in one measurement. J. Acoust. Soc. Am. 91, 1754–1762 (1992)
Stekel, A., Sarrao, J.L., Bell, T.M., Lei, M., Leisure, R.G., Visscher, W.M., Migliori, A.: Method for identification of the vibrational modes of a rectangular parallelepiped. J. Acoust. Soc. Am. 92(2) Pt 1, 663–668 (1992)
Ogi, H., Sato, K., Asada, T., Hirao, M.: Complete mode identification for resonance ultrasound spectroscopy. J. Acoust. Soc. Am. 112(6), 2553–2557 (2002)
Migliori, A., Maynard, J.D.: Implementation of a modern resonant ultrasound spectroscopy system for the measurement of the elastic moduli of small solid specimens. Rev. Sci. Instrum. 76, 121301–121307 (2005)
Ogi, H., Takashima, K., Ledbetter, H., Dunn, M.L., Shimoike, G., Hirao, M., Bowen, P.: Elastic constants and internal friction of an SiC-fibre-reinforced Ti-alloy-matrix crossply composite: measurement and theory. Acta Mater. 47, 2787–2796 (1999)
Ulrich, T.J., McCal, K.R., Guyer, R.A.: Determination of elastic moduli of rock samples using resonant ultrasound spectroscopy. J. Acoust. Soc. Am. 111(4), 1667–1674 (2002)
Voigt, W.: Lehrbuch der Krystallphysik, p. 962. B G Teubner, Leipzig (1928)
Reuss, A.: Berechnung der Fliessgrenze von Mischkristallen auf Grund der Plastizitätsbedingung für Einkristalle. Z Angew Math Mech 9, 49–58 (1929)
Hill, R.: The elastic behaviour of a crystalline aggregate. Proc. Phys. Soc. Lond. A 65, 349–354 (1952)
Hashin, Z., Shtrikman, S.: On some variational principles in anisotropic and nonhomogeneous elasticity. J. Mech. Phys. Solids 10, 335–342 (1962)
Hashin, Z., Shtrikman, S.: A variational approach to the theory of the elastic behaviour of polycrystals. J. Mech. Phys. Solids 10, 343–352 (1962)
Simons, S.G., Wang, H.: Single Crystal Elastic Constants and Calculated Aggregate Properties: A Handbook, 2nd edn. MIT Press, Cambridge (1971)
Lee, S.S., Min, U.-S., Ahn, B.: Elastic constants determination of thin cold-rolled stainless steels by dynamic elastic modulus measurements. J. Mater. Sci. 33, 687–692 (1998)
Ledbetter, H.M.: Monocrystal-polycrystal elastic constants of a stainless steel. Phys. Stat. Sol. (a) 85, 89–96 (1984)
Acknowledgement
The author is indebted to Dr. Jishnu Basu, Mr. Sudipta Barman, and Mr. Supriyo Barman for sample preparation and to Mrs. Papia Mondal and Mrs. Sankari Chakraborty for necessary technical help.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Pal, B. Estimation and Determination of Isotropic Elastic Constants in Resonant Ultrasound Spectroscopy. J Nondestruct Eval 39, 23 (2020). https://doi.org/10.1007/s10921-020-0664-8
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10921-020-0664-8