Skip to main content
Log in

Design and Development of Rogowski Coil Sensors for Eddy Currents Measurement on Toroidal Vessel

  • Original Research
  • Published:
Journal of Fusion Energy Aims and scope Submit manuscript

Abstract

In tokamak, eddy currents are produced due to change in plasma positions during plasma instabilities that result into generation of electromagnetic forces on interaction with the induced currents. Measurement of this current is essential to design a mechanical structure that can withstand this force. Principle objective of this paper is the development of Rogowski coil sensor to measure eddy currents on a toroidal vessel. The paper presents an elaborative and practical construction technique of a Rogowski coil. The calibration method for the Rogowski coil is also presented. Rogowski coils as an eddy currents diagnostics are tested and experiments to measure induced currents on the toroidal vessel are performed using the coils. Experimental values of eddy currents are compared with the ANSYS simulation results.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  1. J.D. Ramboz, Machinable Rogowski coil, design, and calibration. IEEE Trans. Instrum. Meas. 45(2), 511–515 (1996)

    Article  Google Scholar 

  2. D.A. Ward, J.L.T. Exon, Using Rogowski coils for transient current measurements. Eng. Sci. Educ. J. 2(3), 105–113 (1993)

    Article  Google Scholar 

  3. Y. Liu, F. Lin, Q. Zhang, H. Zhong, Design and construction of a Rogowski coil for measuring wide pulsed current. IEEE Sens. J. 11(1), 123–130 (2011)

    Article  Google Scholar 

  4. C.D.M. Oates, A.J. Buenett, C. James, The design of high performance Rogowski coils. In International conference on power electronics, machines and drives, Conf. Publ. No. 487, ALSTOM Research and Technology Centre, UK, pp. 568–573 (2002)

  5. E. Abdi-Jalebi, R. McMohan, High performance low-cost Rogowski transducers and accompanying circuitry. IEEE Trans. Instrum. Meas. 56(3), 753–759 (2007)

    Article  Google Scholar 

  6. E. Abdi-Jalebi, R. McMohan, Simple and practical construction of tion of high-performance, low-cost Rogowski transducers and accompanying circuitry for research applications. IMTC-Instrum. Meas. Tech. Conference, 17–19 May 2005

  7. J.D. Ramboz, D.E. Destefan, R.S. Stant, The verification of Rogowski coil linearity from 200 A to greater than 100 kA using ratio methods. IEEE Instrum. Meas. Tech. Conference, vol. 45, No. 2 (May 2002)

  8. K.-W. Lee, J.-N. Park, S.-H. Kang, Y.-S. Lee, G.-H. Ham, Y.-M. Jang, K.-J. Lim, Geometrical effects in the current measurement by Rogowski sensor

  9. http://rocoil.co.uk

Download references

Acknowledgments

The authors are grateful and indebted to Institute for Plasma Research. Special thanks to Dr. P.K. Kaw for the opportunity to work on this project work. Lastly we are grateful to all those, who have contributed directly or indirectly towards the project.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to H. K. Patel.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Prakash, N.R., Flora, K., Babu, R. et al. Design and Development of Rogowski Coil Sensors for Eddy Currents Measurement on Toroidal Vessel. J Fusion Energ 32, 263–267 (2013). https://doi.org/10.1007/s10894-012-9562-0

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10894-012-9562-0

Keywords

Navigation