Abstract
The stress intensity factor threshold (KI0) is related to the stress level at which cracks start to grow stably, causing the weakening of porcelain prostheses during their use. The values of KI0 of seven dental porcelains (with and without reinforcing leucite crystal, KAlSi2O6) stored in air (22 °C, 60% relative humidity) and artificial saliva (37 °C) were determined by measuring the crack growth velocity of radial cracks generated at the corner of Vickers indentations. The results of KI0 were correlated with the leucite content, fracture toughness (KIc), and chemical composition of the porcelains. It was observed that KI0 increased with the increase of leucite content (only for the leucite-based porcelains) and with the increase of KIc. The increase in Al2O3 content or the decrease in the alkali oxide (K2O and Na2O) content of the material’s glassy matrix tended to increase the KI0 values. Storage media (air and saliva) did not significantly affect the KI0 of porcelains tested, indicating that the control parameter of KI0 value was not the water content of the storage media.
Similar content being viewed by others
References
P. F. CESAR, H. N. YOSHIMURA, W. G. MIRANDA JUNIOR and C. Y. OKADA, J. Dent. 33 (2005) 721
D. R. HASELTON, A. M. DIAZ-ARNOLD and S. L. HILLIS, J. Prosthet. Dent. 83 (2000) 396
J. R. KELLY, J. A. TESK and J. A. SORENSEN, J. Dent. Res. 74 (1995) 1253
E. A. MCLAREN and S. N. WHITE, J. Prosthet. Dent. 83 (2000) 216
J. Y. THOMPSON, K. J. ANUSAVICE, A. NAMAN and H. F. MORRIS, J. Dent. Res. 73 (1994) 1824
M. L. MYERS, J. W. ERGLE, C. W. FAIRHURST and R. D. RINGLE, J. Dent. Res. 73 (1994) 136
B. R. LAWN, in “Fracture of brittle solids.” (W. A. Davis and I. M. Ward, Cambrige University Press, 1993)
C. OLAGNON, J. CHEVALIER and V. PAUCHARD, J. Eur. Ceram. Soc. 26 (2006) 3051
S. M. WIEDERHORN, J. Am. Ceram. Soc. 50 (1967) 407
A. H. DE AZA, J. CHEVALIER, G. FANTOZZI, M. SCHEHL and R. TORRECILLAS, Biomaterials 23 (2002) 937
K. T. WAN, S. LATHABAI and B. R. LAWN, J. Eur. Ceram. Soc. 6 (1990) 259
T. A. MICHALSKE and B. C. BUNKER, J. Appl. Phys. 56 (1984) 2686
R. MARX, F. JUNGWIRTH and P. WALTER, BioMed. Eng. OnLine 3 (2004) 1
C. KOCER and R. COLLINS, J. Am. Ceram. Soc. 84 (2001) 2585
G. R. ANSTIS, P. CHANTIKUL, B. R. LAWN and D. B. MARSHALL, J. Am. Ceram. Soc. 64 (1981) 533
K. WAN, N. AIMARD, S. LATHABAI, R. HORN and B. LAWN, J. Mater. Res. 5 (1990) 172
H. N. YOSHIMURA, P. F. CESAR, W. G. MIRANDA JR., C. C. GONZAGA and C. Y. OKADA, J. Am. Ceram. Soc. 88 (2005) 1680
J. CHEVALIER, S. DEVILLE, G. FANTOZZI, J. BARTOLOME, C. PECHARROMAN, J. MOYA, L. DIAZ and R. TORRECILLAS, Nano. Lett. 5 (2005) 1297
I. L. DENRY, J. R. MACKERT JR., J. A. HOLLOWAY and S. F. ROSENSTIEL, J. Dent. Res. 75 (1996) 1928
R. H. DOREMUS, in “Glass Science” (New York, 1994) p. 339
B. MCGRAIL, J. ICENHOWER, D. SHUH, P. LIU, J. DARAB, D. BAER, S. THEVUTHASEN, V. SHUTTHANANDAN, M. ENGELHARD, C. BOOTH and P. NACHIMUTHU, J. Non-Cryst. Solids 296 (2001) 10
J. GUIN and S. WIEDERHORN, J. Non-Cryst. Solids 316 (2003) 12
Acknowledgments
The authors acknowledge the Brazilian agencies FAPESP and CNPq for the financial support of the present research.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yoshimura, H.N., Cesar, P.F., Soki, F.N. et al. Stress intensity factor threshold in dental porcelains. J Mater Sci: Mater Med 19, 1945–1951 (2008). https://doi.org/10.1007/s10856-007-3290-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10856-007-3290-4