Skip to main content

Advertisement

SpringerLink
Log in

Numerical study of shrinkage cracking in concrete and concrete repair systems

  • Original Paper
  • Published:
International Journal of Fracture Aims and scope Submit manuscript

Abstract

The shrinkage cracking processes in a cement-based composite, which include crack initiation, propagation and coalescence, as well as diffusion-damage coupling, are numerically studied using a mesomechanical numerical model to better understand the shrinkage cracking growth mechanisms and the effects of cracks on moisture diffusion. This study analyzes the shrinkage crack initiation and growth processes in a repair layer of mortar, which is cast on the top of an old concrete substrate and initially saturated with water. The potential shrinkage crack development is driven by the associated drying process. The results illustrate the fracture infilling, saturation and delamination processes in the concrete repair system by decreasing the bond strength between the repair mortar and the substrate from 4 to 1 MPa. Large concrete repair system bond strengths cause cracks to initiate on the surface of the repaired mortar and propagate to the interface. However, debonding is observed at lower bond strengths. The numerical model is shown to be a viable tool for damage analyses under both mechanical loads and hygral gradients.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18

Similar content being viewed by others

References

  • Aldea CM, Shah SP, Karr A (1999) Effect of cracking on water and chloride permeability of concrete. J Mater Civ Eng 11:181–187

    Article  Google Scholar 

  • Bisschop J (2002) Drying shrinkage microcracking in cement-based materials. Ph.D., Delft University

  • Bolander JE, Berton S (2004) Simulation of shrinkage induced cracking in cement composite overlays. Cem Concr Compos 26:861–871

    Article  Google Scholar 

  • Chen D, Mahadevan S (2007) Cracking analysis of plain concrete under coupled heat transfer and moisture transport processes. J Struct Eng 133:400–410

    Article  Google Scholar 

  • Du X, Jin L (2014) Meso-scale numerical investigation on cracking of cover concrete induced by corrosion of reinforcing steel. Eng Fail Anal 39:21–33

    Article  Google Scholar 

  • Emberson NK, Mays GC (1990) Significance of property mismatch in the patch repair of structural concrete Part I: properties of repair systems. Mag Concr Res 42:147–160

    Article  Google Scholar 

  • Granger L, Torrenti JM, Acker P (1997) Thoughts about drying shrinkage: experimental results and quantification of structural drying creep. Mater Struct 30:588–598

    Article  Google Scholar 

  • Grasberger S, Meschke G (2004) Thermo-hygro-mechanical degradation of concrete: From coupled 3D material modelling to durability-oriented multifield structural analyses. Mater Struct 37:244–256

    Article  Google Scholar 

  • Higgins DD, Bailey JE (1976) A microstructural investigation of the failure behaviour of cement paste. In: Proceedings of conference in hydraulic cem pastes: their structure and properties, Sheffield, England

  • Hwang CL, Young JF (1984) Drying shrinkage of portland cement pastes I. Microcracking during drying. Cem Concr Res 14:585–594

    Article  Google Scholar 

  • Idiart A, Bisschop J, Caballero A, Lura P (2012) A numerical and experimental study of aggregate-induced shrinkage cracking in cementitious composites. Cem Concr Res 42:272–281

    Article  Google Scholar 

  • Idiart A, López C, Carol I (2011) Modeling of drying shrinkage of concrete specimens at the meso-level. Mater Struct 44:415–435

    Article  Google Scholar 

  • Jacobsen S, Marchand J, Boisvert L (1996) Effect of cracking and healing on chloride transport in OPC concrete. Cem Concr Res 26:869–881

    Article  Google Scholar 

  • Lange DA, Shin HC (2001) A computer-based design tool for analysis of bonded concrete overlays. Concr Sci Eng 3:189–194

    Google Scholar 

  • Lukovic M, Savija B, Schlangen E, Ye G, van Breugel K (2014) A modelling study of drying shrinkage damage in concrete repair systems. In: Structural faults and repair conference, London, UK, The Electrochemical Society

  • Martinola G, Wittmann FH (1995) Application of fracture mechanics to optimize repair mortar systems. In: Proceedings of fracture mechanics of concrete structures. F Wittmann, Aedificatio Publishers, pp 1481–1492

  • McDonald DB, Roper H (1993) Prediction of drying shrinkage of concrete from internal humidities and finite element techniques. In: BažantI ZP, Carol I (eds) Creep and shrinkage of concrete. E&FN Spon, London, pp 259–264

    Google Scholar 

  • Nakamura H, Srisoros W, Yashiro R, Kunieda M (2006) Time-dependent structural analysis considering mass transfer to evaluate deterioration process of RC structures. J Adv Concr Technol 4:147–158

    Article  Google Scholar 

  • Picandet V, Khelidj A, Bellegou H (2009) Crack effects on gas and water permeability of concretes. Cem Concr Res 39:537–547

    Article  Google Scholar 

  • Qiao D, Nakamura H, Yamamoto Y, Miura T (2015) Evaluation method of tensile behavior of corroded reinforcing bars considering radius loss. J Adv Concr Technol 13:135–146

    Article  Google Scholar 

  • Sadouki H, van Mier JG (1997) Meso-level analysis of moisture flow in cement composites using a lattice-type approach. Mater Struct 30:579–587

    Article  Google Scholar 

  • Sadouki H, van Mier JGM (1997) Simulation of hygral crack growth in concrete repair systems. Mater Struct 30:518–526

    Article  Google Scholar 

  • Samaha HR, Hover KC (1992) Influence of microcracking on the mass transport properties of concrete. ACI Mater J 89:416–424

    Google Scholar 

  • Schlangen E, Koenders EAB, van Breugel K (2007) Influence of internal dilation on the fracture behaviour of multi-phase materials. Eng Fract Mech 74:18–33

    Article  Google Scholar 

  • Shin HC, Lange DA (2004) Effects of shrinkage and temperature in bonded concrete overlays. ACI Mater J 101:358–364

    Google Scholar 

  • Shin KJ, Choi YC, Lee KM (2015) Meso-scale numerical investigation of tensile and shrinkage behaviours of concrete. Mater Res Innov 19:S1-139–S131-142

    Article  Google Scholar 

  • Tang SB, Tang CA (2015) Crack propagation and coalescence in quasi-brittle materials at high temperatures. Eng Fract Mech 134:404–432

    Article  Google Scholar 

  • Tang SB, Tang CA, Liang ZZ, Zhang YB, Li LC (2012) Numerical study of the influence of material structure on effective thermal conductivity of concrete. Heat Transf Eng 33:732–747

    Article  Google Scholar 

  • Tang SB, Yu QL, Li H, Yu CY, Bao CY, Tang CA (2013) Mesomechanical model of moisture diffusion and shrinkage cracking in building material—model development. Constr Build Mater 47:511–529

    Article  Google Scholar 

  • Theiner Y, Hofstetter G (2012) Evaluation of the effects of drying shrinkage on the behavior of concrete structures strengthened by overlays. Cem Concr Res 42:1286–1297

    Article  Google Scholar 

  • Torrenti JM, Granger L, Diruy M, Genin P (1999) Modeling concrete shrinkage under variable ambient conditions. ACI Mater J 96:35–39

    Google Scholar 

  • Van Mier JGM (1997) Fracture processes of concrete: assessment of material parameters for fracture models. CRC Press, Boca Raton

    Google Scholar 

  • Wittmann X, Sadouki H, Wittmann FH (1989) Numerical evaluation of drying test data. In: Transactions of the 10th international conference on structural mechanics in reactor technology, pp 71–79

  • Zhou J, Ye G, Schlangen E, van Breugel K (2008) Modelling of stresses and strains in bonded concrete overlays subjected to differential volume changes. Theor Appl Fract Mec 49:199–205

    Article  Google Scholar 

Download references

Acknowledgments

This project was financially supported by the National Basic Research Program of China (973 Program, Grant No. 2014CB047100), the National Natural Science Foundation of China (51474046 and U1562103), which are greatly appreciated. Moreover, the authors would like to thank the two anonymous reviewers for their constructive suggestion and comments, which have greatly helped the authors to improve this paper.

Author information

Authors and Affiliations

  1. School of Civil Engineering, Dalian University of Technology, Dalian, 116024, China

    S. B. Tang, T. H. Ma, C. A. Tang, X. Huang & H. Zhang

  2. ARC Centre of Excellence for Geotechnical Science and Engineering, Civil, Surveying and Environmental Engineering, The University of Newcastle, Callaghan, NSW, 2308, Australia

    S. Y. Wang

  3. College of Civil Engineering, Shaoxing University, Shaoxing, 312000, China

    C. Y. Bao

Authors
  1. S. B. Tang
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. S. Y. Wang
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. T. H. Ma
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. C. A. Tang
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. C. Y. Bao
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. X. Huang
    View author publications

    You can also search for this author in PubMed Google Scholar

  7. H. Zhang
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to S. B. Tang.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Tang, S.B., Wang, S.Y., Ma, T.H. et al. Numerical study of shrinkage cracking in concrete and concrete repair systems. Int J Fract 199, 229–244 (2016). https://doi.org/10.1007/s10704-016-0108-8

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10704-016-0108-8

Keywords

Search

Navigation