Skip to main content
Log in

Pressure stimulated electrical emissions from cement mortar used as failure predictors

  • Original Paper
  • Published:
International Journal of Fracture Aims and scope Submit manuscript

Abstract

The electrical signals emitted during the application of uniaxial compressive mechanical stress upon cement mortar specimens are observed and discussed in this paper. This work discusses the electrical signals that are detected when the specimens are excited by a stepwise uniaxial stress increase from a low level (σ L ) to a higher level (σ H ) at a fast or slow rate and consequently remain at a high pressure regime for a long time. When maintaining constant mechanical stress for a long time, creep phenomena are evident in the specimen and the corresponding electrical emissions are recorded and analyzed. The characteristics of the electrical signal give clear information regarding the breaking stress (σ F ) of the material. The electrical emission recordings are of great interest when the applied σ H is located in the vicinity of the failure stress; the emitted electrical current increases greatly due to the sequential formation and propagation of cracks that occurs in this stress region. Thus, by correlating the strain rate variations to the electrical emissions this methodology can be used to predict failure due to compressive stress in cement mortars.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Abbreviations

PSC:

Pressure stimulated currents

CBM:

Cement based materials

LRSS:

Low rate step stress

ARSS:

Abrupt rate step stress

FVS:

Failure vicinity stress

References

  • Anastasiadis C, Triantis D, Stavrakas I, Vallianatos F (2004) Pressure stimulated currents (PSC) in marble samples after the application of various stress modes before fracture. Ann Geophys 47: 21–28

    Google Scholar 

  • Anastasiadis C, Stavrakas I, Triantis D, Vallianatos F (2007a) Correlation of pressure stimulated currents in rocks with the damage variable. Ann Geophys 50: 1–6

    Google Scholar 

  • Anastasiadis C, Triantis D, Hogarth CA (2007b) Comments on the phenomena underlying pressure stimulated currents (PSC) in dielectric rock materials. J Mater Sci 42: 2538–2542

    Article  CAS  Google Scholar 

  • Aydin A, Prance RJ, Prance H, Harland CJ (2009) Observation of pressure stimulated voltages in rocks using an electric potential sensor. Appl Phys Lett 95: 124102–124104

    Article  Google Scholar 

  • Brady BT, Rowell GA (1986) Laboratory investigation of the electrodynamics of rock fracture. Nature 321: 448–492

    Article  Google Scholar 

  • Eccles D, Sammonds PR, Clint OC (2005) Laboratory studies of electrical potential during rock failure. Int J Rock Mech Min Sci 42: 933–949

    Article  Google Scholar 

  • Enomoto J, Hashimoto H (1990) Emission of charged particles from indentation fracture of rocks. Nature 346: 641–643

    Article  CAS  Google Scholar 

  • Hadjicontis V, Mavromatou C (1994) Transient electric signals prior to rock failure under uniaxial compression. Geophys Res Lett 21: 1687–1690

    Article  Google Scholar 

  • Kosmatka SH, Kerkhoff B, Panarese WC (2002) Design and control of concrete mixtures, 14th edn. Portland Cement Association, Portland

  • Kyriazopoulos A, Anastasiadis C, Triantis D, Brown CJC (2011) Non-destructive evaluation of cement-based materials from pressure-stimulated electrical emission. Constr Build Mat 25: 1980–1990

    Article  Google Scholar 

  • Kyriazopoulos A (2009) Mechanical stress induced electrical emissions in cement based materials. PhD thesis, School of Engineering and Design, Brunel University

  • Lavrov A (2005) Fracture-induced Physical Phenomena and memory Effects in Rocks: A Review. Strain 41: 135–149

    Article  Google Scholar 

  • Stavrakas I, Anastasiadis C, Triantis D, Vallianatos F (2003) Piezo stimulated currents in marble samples: precursory and concurrent—with—failure signals. Nat Hazards Earth Syst Sci 3: 243–247

    Article  Google Scholar 

  • Stavrakas I, Triantis D, Agioutantis Z, Maurigiannakis S, Saltas V, Vallianatos F (2004) Pressure stimulated currents in rocks and their correlations with mechanical properties. Nat Hazards Earth Syst Sci 4: 563–567

    Article  Google Scholar 

  • Sun M, Liu Q, Li Z, Hu Y (2000) A study of piezoelectric properties of carbon fiber reinforced concrete and plain cement paste during dynamic loading. Cem Concr Res 30: 1593–1595

    Article  CAS  Google Scholar 

  • Sun M, Liu Q, Li Z, Wang E (2002) Electrical emission in mortar under low compressive loading. Cem Concr Res 32: 47–50

    Article  CAS  Google Scholar 

  • Sun M, Li Z, Song X (2004) Piezoelectric effect of hardened cement paste. Cem Concr Compos 26: 717–720

    Article  CAS  Google Scholar 

  • Takeuchi A, Nagahama H (2001) Voltage changes induced by stick-slip of granites. Geophys Res Lett 28: 3365–3367

    Article  CAS  Google Scholar 

  • Triantis D, Stavrakas I, Anastasiadis C, Kyriazopoulos A, Vallianatos F (2006a) An analysis of pressure stimulated currents (PSC), in marble samples under mechanical stress. Phys Chem Earth 31: 234–239

    Article  Google Scholar 

  • Triantis D, Anastasiadis C, Stavrakas I, Kyriazopoulos A (2006b), The ascertainment of the presence of damage processes using the pressure stimulated current (PSC) technique on marble and cement samples. In: Proceedings of the 9th ECNDT, Berlin, 25–29 September 2006, Tu.1.6.2

  • Triantis D, Anastasiadis C, Vallianatos F, Kyriazis P, Nover G (2007) Electric signal emissions during repeated abrupt uniaxial compressional stress steps in amphibolite from KTB drilling. Nat Hazards Earth Syst Sci 7: 149–154

    Article  Google Scholar 

  • Triantis D, Anastasiadis C, Stavrakas I (2008) The correlation of electrical charge with strain on stressed rock samples. Nat Hazards Earth Syst Sci 8: 1243–1248

    Article  Google Scholar 

  • Vallianatos F, Tzanis A. (1998) Electric current generation associated with the deformation rate of a solid: preseismic and coseismic signals. Phys Chem Earth 23: 933–938

    Article  Google Scholar 

  • Vallianatos F, Triantis D, Tzanis A, Anastasiadis C, Stavrakas I (2004) Electric earthquake precursors: from laboratory results to field observations. Phys Chem Earth 29: 339–351

    Article  Google Scholar 

  • Varotsos P, Alexopoulos K (1986) Thermodynamics of point defects and their relation with bulk properties. North- Holland, Amsterdam

    Google Scholar 

  • Varotsos P, Sarlis N, Lazaridou M, Kapiris P (1998) Transmission of stress induced electric signals in dielectric media. J Appl Phys 83(1): 60–70

    Article  CAS  Google Scholar 

  • Yoshida S, Clint OC, Sammonds PR (1998) Electric potential changes prior to shear fracture in dry and saturated rocks. Geophys Res Lett 25: 1577–1580

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to D. Triantis.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Triantis, D., Stavrakas, I., Kyriazopoulos, A. et al. Pressure stimulated electrical emissions from cement mortar used as failure predictors. Int J Fract 175, 53–61 (2012). https://doi.org/10.1007/s10704-012-9701-7

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10704-012-9701-7

Keywords

Navigation