Skip to main content
SpringerLink
Log in

Device for Limiting the Temperature at Chimney-Roof Penetration in Very Critical Chimney Operating Conditions

  • Published:
Fire Technology Aims and scope Submit manuscript

Abstract

In recent years, numerous roof fires have occurred due to the presence of a chimney, and also certified chimneys were involved. Chimneys installers and chimney producers are disoriented because the chimney certification does not guarantee safe installations, and also the performance of devices for limiting the roof temperature is uncertain. Results reported in this paper will help them to accomplish safe chimney installations. The paper describes the main features of a device to be installed at chimney-roof penetration for limiting flammable materials temperature and, consequently, the roof fires risk. The device is composed of elements made of insulating material to reduce the heat transfer from the chimney towards the roof, and elements made of conductive material to facilitate the heat transfer from the device itself towards the ambient. The features of the device have been investigated by means of 32 numerical simulations performed with a CFD code: in each numerical test a variable has been changed and the conditions that have determined the lowest roof temperature have been considered the most suitable. If compared to the temperature measured when only insulating material is installed at chimney-roof penetration, the conductive elements reduce the roof temperature of more than \(100^{\circ }\hbox {C}\). The optimal version of the device, that is, 100 mm thick and made of two conductive elements ensures a roof temperature lower than \(85^{\circ }\hbox {C}\) when the exhaust gas temperature in the chimney is \(1000^{\circ }\hbox {C}\) in steady conditions. In addition, the device avoids the formation of thermal bridges between indoor and external ambient, and it engenders heat recovery in indoor ambient.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10

Similar content being viewed by others

References

  1. Lawson DI, Fox LL, Webster CT (1952) The heating of panels by flue pipes. Department of Scientific and Industrial Research, London

    Google Scholar 

  2. Lawson DI, Simms DL (1952) The ignition of wood by radiation. Br J Appl Phys 3:288–292

    Article  Google Scholar 

  3. Fox LL, Whittaker D (1955) Some measurements of temperatures of metal flues of domestic heating appliances. J Inst Heat Vent Eng 23:183–192

    Google Scholar 

  4. Prefabricated metal chimneys, National bureau of standards, Fire research section, unpublished reports to federal public housing authority, district of Columbia Alley dwelling authority and others, 1941–1945

  5. Peacock RD (1986) Chimney fires: intensity and duration. Fire Technol 22:234–252. https://doi.org/10.1007/BF01043126

    Article  Google Scholar 

  6. Loftus JJ, Peacock RD (1985) Wall and ceiling protection for heating appliances. Fire Technol 21:213–229. https://doi.org/10.1007/BF01039975

    Article  Google Scholar 

  7. Voigt GQ (1933) Fire hazard of domestic heating installations. National Bureau of Standards (U.S.), Gaithersburg

    Book  Google Scholar 

  8. Kline LM, Witte H (1959) Performance of Type B gas vent for gas-fired appliance. Bull Res 51:192

    Google Scholar 

  9. Mc Guire JH (1969) Limiting safe temperature of combustible materials. Fire Technol 5:237–241

    Article  Google Scholar 

  10. Ministry of the Environment of Finland (2011) Finnish concern on fire safety risk due to CE marking of appliances fired by solid fuel and chimney products. Available at: http://www.spek.fi/loader.aspx?id=726bd049-4d9f-4e9b-8b7c-976674097ec3. Accessed 13 Mar 2019

  11. Leppänen P (2017) Fire safety of metal chimneys in real use. http://www.nuohoojat.fi/binary/file/-/fid/791. Accessed on 31 Oct 2018

  12. Dadone PN (2009) Analisi 00. Casi Verificatisi sul Territorio della Provincia di Brescia e Statistica delle Cause, Incendi tetto e Canne Fumarie Proceeding Conference, Brescia (in Italian)

  13. Hakala VM (2013) Fire investigations, thematic investigation 3: chimney and fireplace as causes of fire, p 14 (in Finnish)

  14. International partnership for the investigation of fires, explosions and other major incidents. www.burgoynes.com. Accessed 13 Mar 2019

  15. EN 1859 (2013) Chimneys–metal chimneys—test methods, Milano

  16. Neri M, Leppänen P, Bani S, Pentti M, Pilotelli M (2016) Experimental and computational study of the temperatures field around a chimney roof penetration. Fire Technol. https://doi.org/10.1007/s10694-015-0540-8

    Article  Google Scholar 

  17. Neri M, Luscietti D, Bani S, Fiorentino A, Pilotelli M (2015) Chimneys in wooden roofs: a 3D steady numerical model for the prediction of the temperatures. ASME-ATI-UIT 2015 conference paper, Napoli (Italy)

  18. Leppänen P, Neri M, Luscietti D, Bani S, Pentti M, Pilotelli M (2016) Comparison between European chimney test results and actual installations. J Fire Sci 35:62–79. https://doi.org/10.1177/0734904116680222

    Article  Google Scholar 

  19. Neri M (2015) Experimental and numerical analysis of heat transfer in chimney roof penetration in relation to the overheating of flammable materials. University of Brescia, PhD Thesis. https://doi.org/10.13140/RG.2.2.25776.76808

  20. Neri M, Pilotelli M (2018) Data on temperature-time curves measured at chimney-roof penetration. Data Brief 20:306–315. https://doi.org/10.1016/j.dib.2018.08.017

    Article  Google Scholar 

  21. Leppänen P, Inha T, Pentti M (2015) An experimental study on the effect of design flue gas temperature on the fire safety of chimneys. Fire Technol 51:847–86. https://doi.org/10.1007/s10694-014-0415-4

    Article  Google Scholar 

  22. Leppänen P, Malaska M, Inha T, Pentti M (2017) Experimental study on fire safety of chimneys in real use and actual site conditions. J Build Eng 14:41–54. https://doi.org/10.1016/j.jobe.2017.09.014

    Article  Google Scholar 

  23. Neri M, Luscietti D, Fiorentino A, Pilotelli M (2013) Study of the heat transfer between chimney and roof by means of design of experiments (DOE). In: Proceedings of 31st UIT heat transfer conference, Como, Italy

  24. Neri M, Luscietti D, Luscietti D, Fiorentino A, Pilotelli M (2018) Statistical approach to estimate the temperature in chimney roof penetration. Fire Technol 54:395–417. https://doi.org/10.1007/s10694-017-0689-4

    Article  Google Scholar 

  25. Neri M, Luscietti D, Bani S, Fiorentino A, Pilotelli M (2015) Analysis of the temperatures measured in very thick and insulating roofs in the vicinity of a chimney. J Phys Conf Ser 655:1–11. https://doi.org/10.1088/1742-6596/655/1/012019

    Article  Google Scholar 

  26. Neri M, Luscietti D, Fiorentino A, Pilotelli M (2015) Experimental analysis of chimneys in wooden roofs. Fire Technol 52:1939–1955. https://doi.org/10.1007/s10694-015-0525-7

    Article  Google Scholar 

  27. Leppänen P, Neri M, Mäkinen J (2015) Heat release caused by the smouldering combustion of the binder of rockwool. J Struct Mech 48:68–82

    Google Scholar 

  28. Polonini LF, Petrocelli D, Parmigiani SP, Lezzi AM (2018) Experimental study of PM emissions from wood pellet stoves with innovative burning pots. In: Proceedings of EUBCE 2018: 26th European biomass conference and exhibition, Copenhagen. https://doi.org/10.5071/26thEUBCE2018-IBO.16.2

  29. Polonini LF, Petrocelli D, Parmigiani SP, Lezzi AM (2017) Analysis of combustion conditions for CO and PM emissions in wood pellet stoves: an experimental study. In: Proceedings of SET 2017: 16th international conference on sustainable energy technologies, Bologna, Italy

  30. Polonini LF, Petrocelli D, Parmigiani SP, Lezzi AM (2019) Influence on CO and PM emissions of an innovative burner pot for pellet stoves: an experimental study. Energies 12:590

    Article  Google Scholar 

  31. Setchkin NP (1949) A method and apparatus for determining the ignition characteristics of plastics. Research Paper RP2052, Part of the Journal of Research of the National Bureau of Standards, U. S. Department of Commerce, National Bureau of Standards

  32. Graf SH (1949) Ignition temperatures of various papers, woods, and fabrics. Bulletin No. 26, Engineering Experiment Station, Oregon State System of Higher Education, Oregon State College

  33. Maclean JD (1951) Effect of heat on properties and serviceability of wood: experiments on thin wood specimens, Madison

  34. Maclean JD (1951) Rate of disintegration of wood under different heating conditions. American Wood-Preserves Association, Birmingham

    Google Scholar 

  35. Italian Association of Polystirene, Fire safety of buildings made with EPS, vol 15. http://www.aipe.biz/. Accessed on 30 Oct 2018

  36. Catalog of devices for reducing the temperature at chimney-roof penetration. https://www.schiedel.com/it/prodotti/sistemi-per-efficienza-energetica-legna-e-pellet/passaggi-tetto-in-legno/. Accessed on the 31 Oct 2018

  37. Catalog of devices for reducing the temperature at chimney-roof penetration. https://www.landinispa.com/camini/. Accessed on the 31 Oct 2018

  38. Catalog of devices for reducing the temperature at chimney-roof penetration. https://www.stabile.it/news/attraversamento-passaggio-tetto-canna-fumaria/. Accessed on 31 Oct 2018

  39. Catalog of devices for reducing the temperature at chimney-roof penetration. https://www.gbd.it/it/prodotti/altre-applicazioni/attraversamento-tetto.html. Accessed on 31 Oct 2018

  40. Lantschner N (2009) La Mia Casa Clima. Raetia Edition, Bolzano (in Italian)

  41. Neri M, Pilotelli M, Luscietti D, Bani S (2017) Dispositivo isolante per canne fumarie installate in strutture edilizie, IT201700004959. http://www.uibm.gov.it/bancadati/search.php. Accessed on 21 Feb 2019

  42. Sparrow EM, Gregg JL (1956) Laminar free convection heat transfer from the outer surface of a vertical circular cylinder. Trans ASME, 78

  43. BS EN 1443 (2003) Chimneys. General requirements

  44. UNI 6946 (2007) Building components and building elements—thermal resistance and thermal transmittance—calculation method

  45. Whitaker S (1972) Forced convection heat transfer correlations for flow in pipes, past flat plates, single cylinders, single spheres, and for flow in packed beds and tube bundles. AIChE J 18:361–371. https://doi.org/10.1002/aic.690180219

    Article  Google Scholar 

  46. Incropera FP, De Witt DP (1985) Introduction to heat transfer, 2nd edn. Wiley, New York

    Google Scholar 

  47. https://www.teknowool.com/. Accessed on 8 Jan 2019

Download references

Author information

Authors and Affiliations

  1. University of Brescia, Via Branze 38, Brescia, Italy

    M. Neri & M. Pilotelli

Authors
  1. M. Neri
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. M. Pilotelli
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to M. Neri.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Appendix

Appendix

See Table 3.

Table 3 Heat Flux Through the Device Boundary. Segments Refer to Fig. 5
Full size table

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Neri, M., Pilotelli, M. Device for Limiting the Temperature at Chimney-Roof Penetration in Very Critical Chimney Operating Conditions. Fire Technol 55, 1937–1965 (2019). https://doi.org/10.1007/s10694-019-00837-5

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10694-019-00837-5

Keywords

Search

Navigation