Subfilter-Scale Modelling Using Transport Equations: Large-Eddy Simulation of the Moderately Convective Atmospheric Boundary Layer

Abstract

We perform large-eddy simulation (LES) of a moderately convective atmospheric boundary layer (ABL) using a prognostic subfilter-scale (SFS) model obtained by truncating the full conservation equations for the SFS stresses and fluxes. The truncated conservation equations contain production mechanisms that are absent in eddy-diffusivity closures and, thus, have the potential to better parametrize the SFS stresses and fluxes. To study the performance of the conservation-equation-based SFS closure, we compare LES results from the surface layer with observations from the Horizontal Array Turbulence Study (HATS) experiment. For comparison, we also show LES results obtained using an eddy-diffusivity closure. Following past studies, we plot various statistics versus the non-dimensional parameter, Λ _w /Δ, where Λ _w is the wavelength corresponding to the peak in the vertical velocity spectrum and Δ is the filter width. The LES runs are designed using different domain sizes, filter widths and surface fluxes, in order to replicate partly the conditions in the HATS experiment. Our results show that statistics from the different LES runs collapse reasonably and exhibit clear trends when plotted against Λ _w /Δ. The trends exhibited by the production terms in the modelled SFS conservation equations are qualitatively similar to those seen in the HATS data with the exception of SFS buoyant production, which is underpredicted. The dominant production terms in the modelled SFS stress and flux budgets obtained from LES are found to approach asymptotically constant values at low Λ _w /Δ. For the SFS stress budgets, we show that several of these asymptotes are in good agreement with their corresponding theoretical values in the limit Λ _w /Δ → 0. The modelled SFS conservation equations yield trends in the mean values and fluctuations of the SFS stresses and fluxes that agree better with the HATS data than do those obtained using an eddy-diffusivity closure. They, however, underpredict considerably the level of SFS anisotropy near the wall when compared to observations, which could be a consequence of the shortcomings in the model used for the pressure destruction terms. Finally, we address the computational cost incurred due to the use of additional prognostic equations.