Abstract
Horizontal drains, used independently or as part of a more complex remediation scheme, are frequently installed to mitigate the effects of increased groundwater in slope stabilization projects. Due to a general trial and error approach to their design, the need for improved design practices has been recognized. The procedures established by Crenshaw and Santi in 2004 made some advances in this direction, but did not account for slopes with drains that were not horizontal or for sloping low-permeability layers underneath the slide mass. Furthermore, the method outlined by Crenshaw and Santi is time-consuming and requires some trial and error calculations to achieve convergence. Therefore, the method has been modified to account for nonhorizontal elements, and a horizontal drain spreadsheet has been developed to streamline the design for projects where horizontal drains will be installed. The horizontal drain spreadsheet may be used to: (1) predict a conservative piezometric profile in a drained slope for use in slope stability analyses, (2) predict piezometric heads in any single piezometer in a drainage field, and (3) predict drain spacing for design purposes. This document explains the revisions to Crenshaw and Santi’s procedures and provides instructions for applying the method. The instructions may be used for hand calculations, but are specifically intended for use with the horizontal drain spreadsheet. The spreadsheet may be used for slopes composed of silty or clayey sands, silts, and silty or sandy clays.
Similar content being viewed by others
References
Cook D (2009) Improvements in horizontal drain design. Ph.D. thesis, Department of Geology and Geological Engineering, Colorado School of Mines
Cook DI, Santi PM, Higgins JD (2008a) Horizontal landslide drain design: state-of-the-art and suggested improvements. Environ Eng Geosci XIV(4):241–250
Cook DI, Santi PM, Higgins JD, Short RD (2008b) Field-scale measurement of groundwater profiles in a drained slope. Environ Eng Geosci XIV(3):167–182
Cornforth DH (2005) Landslides in practice: investigation, analysis, and remedial/preventative options in soils. Wiley, Hoboken
Crenshaw BA (2003) Water table profiles in the vicinity of horizontal drains. M. Eng. thesis. Department of Geology and Geological Engineering, Colorado School of Mines
Crenshaw BA, Santi PM (2004) Water table profiles in the vicinity of horizontal drains. Environ Eng Geosci X(3):191–201
Hooghoudt SB (1940) Bijdragen tot de kennis van eenige natuurkundige grootheden van den grond, 7, Algemeene beschouwing van het probleem van de detail ontwatering en de infiltratie door middle van parallel loopende drains, greppels, slooten, en kanalen. Versl Landbouwkd Onderz 46:515–707
Luthin JN (1966) Drainage engineering. Wiley, New York
Prellwitz RW (1978) Analysis of parallel drains for highway cut-slope stabilization. In: Humphrey CB (ed) Proceedings of the sixteenth annual engineering geology and soils engineering symposium. Idaho Transportation Department, Division of Highways, Boise, pp 153–180
Royster DL (1980) Horizontal drains and horizontal drilling: an overview. Transp Res Rec 783:16–20
Santi PM, Elifrits CD, Liljegren JA (2001a) Design and installation of horizontal wick drains for landslide stabilization. Transp Res Rec 1757:58–66
Santi PM, Elifrits CD, Liljegren JA (2001b) Draining in a new direction. Civ Eng ASCE 2001:A10–A16
Santi PM, Crenshaw BA, Elifrits CD (2003) Demonstration projects using wick drains to stabilize landslides. Environ Eng Geosci IX(4):339–350
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Cook, D.I., Santi, P.M. & Higgins, J.D. Prediction of piezometric surfaces and drain spacing for horizontal drain design. Landslides 9, 547–556 (2012). https://doi.org/10.1007/s10346-012-0337-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10346-012-0337-5