Abstract
Fly ash–lime–gypsum bricks are an environmentally friendly and energy-efficient alternative to burnt clay bricks. Nowadays, the scarcity of fly ash and lime adversely affects the production of fly ash bricks. To mitigate this, the current study examines incinerated paper mill sludge ash as a supplement to fly ash and lime. In the current study, in blend 1, coal fly ash is replaced by incinerated paper mill sludge ash (2.5–30 wt%), and in blend 2, lime is completely replaced by incinerated paper mill sludge ash (2.5–15 wt%). Based on Indian standards, bricks were tested for compressive strength, water absorption, weight density, percentage voids, efflorescence, drying shrinkage, dynamic modulus of elasticity, and impact energy. Before developing bricks, the materials have to be examined by X-ray diffraction, X-ray fluorescence, Fourier transform infrared spectroscopy, thermogravimetry differential thermal analysis, and scanning electron microscope techniques. Results from X-ray diffraction showed that higher replacement of incinerated paper mill sludge ash does not produce any phase transformation and merely improves porosity, which reduces weight. Higher replacement of incinerated paper mill sludge ash leads to a reduction in strength and a higher water requirement. The study found that incorporating incinerated paper mill sludge ash at replacement 2.5–15 wt% in blend 1 and 2.5–5 wt% in blend 2 satisfied the building brick requirements. By incorporating incinerated paper mill sludge ash into bricks, the brick industry can produce sustainable bricks that utilize resources effectively.
Graphical Abstract
Graphical abstract illustrating the reuse of incinerated paper mill sludge ash in the manufacturing of building bricks to minimize the demand for fly ash and lime. The visual shows the drawbacks of paper mill sludge in land dumping, the suggested methodology for reusing incinerated paper mill sludge ash to minimize environmental degradation, improved sustainability through waste utilization, its benefits, and the characterization of bricks.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Data availability
The datasets produced and analyzed in this study are available upon reasonable request from the corresponding author.
References
ASTM C618:2012 Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete
ASTM C62–08:2010 Standard specification for building brick (solid masonry units made from clay or shale). American Society for Testing and Materials, USA
ASTM C642:2021 Standard test method for density, absorption, and voids in hardened concrete, 2021st edn. American Society for Testing and Materials, USA
Balaguera A, Carvajal GI, Albertí J, Fullana-i-Palmer P (2018) Life cycle assessment of road construction alternative materials: a literature review. Resour Conserv Recycl 132:37–48. https://doi.org/10.1016/j.resconrec.2018.01.003
Basumajumdar A, Das AK, Bandyopadhyay N, Maitra S (2005) Some studies on the reaction between fly ash and lime. Bull Mater Sci 28:131–136. https://doi.org/10.1007/BF02704232
Chin WQ, Lee YH, Amran M et al (2022) A sustainable reuse of agro-industrial wastes into green cement bricks. Materials 15:1713. https://doi.org/10.3390/ma15051713
Cicek T, Tanrıverdi M (2007) Lime based steam autoclaved fly ash bricks. Constr Build Mater 21:1295–1300. https://doi.org/10.1016/j.conbuildmat.2006.01.005
Coates J (2006) Interpretation of infrared spectra, a practical approach. In: Meyers RA (ed) Encyclopedia of analytical chemistry. Wiley, Chichester, UK
CSE analysis (2021) CSE analysis; data sourced from CEA’s annual ash reports 2010-11 to 2020-21
Deviatkin I, Kujala A, Horttanainen M (2015) Deinking sludge utilization possibilities: technical, economic, and environmental assessments. LUT-Univ 4:112–120
Dondi M, Marsigli M, Fabbri B (1997) Recycling of industrial and urban wastes in brick production: a review. Tile Brick Int 13:218–225
Frías M, Rodríguez O, Sánchez de Rojas MI (2015) Paper sludge, an environmentally sound alternative source of MK-based cementitious materials. Rev Constr Build Mater 74:37–48. https://doi.org/10.1016/j.conbuildmat.2014.10.007
Furlani E, Brückner S, Minichelli D, Maschio S (2008) Synthesis and characterization of ceramics from coal fly ash and incinerated paper mill sludge. Ceram Int 34:2137–2142. https://doi.org/10.1016/j.ceramint.2007.08.002
Gencel O, Koksal F, Ozel C, Brostow W (2012) Combined effects of fly ash and waste ferrochromium on properties of concrete. Constr Build Mater 29:633–640. https://doi.org/10.1016/j.conbuildmat.2011.11.026
Goel G, Kalamdhad AS (2017) An investigation on use of paper mill sludge in brick manufacturing. Constr Build Mater 148:334–343. https://doi.org/10.1016/j.conbuildmat.2017.05.087
Goel G, Vasić MV, Katiyar NK et al (2021) Potential pathway for recycling of the paper mill sludge compost for brick making. Constr Build Mater 278:122384. https://doi.org/10.1016/j.conbuildmat.2021.122384
Goñi S, Guerrero A, Luxán MP, Macı́as A (2003) Activation of the fly ash pozzolanic reaction by hydrothermal conditions. Cem Concr Res 33:1399–1405. https://doi.org/10.1016/S0008-8846(03)00085-1
Grau F, Choo H, Hu J, Jung J (2015) Engineering behavior and characteristics of wood ash and sugarcane bagasse ash. Materials 8:6962–6977. https://doi.org/10.3390/ma8105353
Gupta T, Chaudhary S, Sharma RK (2016) Mechanical and durability properties of waste rubber fiber concrete with and without silica fume. J Clean Prod 112:702–711. https://doi.org/10.1016/j.jclepro.2015.07.081
Indian paper industry: out of the woods (2016) CARE rating on Credit Perspective: Paper Industry, http://www.careratings.com
IS 1077:1992 Common burnt clay building bricks specifications. Bureau of Indian Standards, New Delhi, India.
IS 12894:2002 Pulverized fuel ash-lime bricks. Bureau of Indian Standards, New Delhi
IS 13311 (Part 1):1992 Non-destructive testing of concrete - methods of test. Bureau of Indian Standards, New Delhi, India
IS 2720 (part II): 1973 Methods of test for soils part II determination of water content. Bureau of Indian Standards, New Delhi, India.
IS 3495 (Parts 1 to 4):1992 Methods of tests of burnt clay building bricks. Bureau of Indian Standards, New Delhi
IS 3812 (Part-1):2003 Specification for pulverized fuelash. Bureau of Indian Standards, New Delhi
IS 383:2016 Coarse and fine aggregate for concrete-specification. Bureau of Indian Standards, New Delhi, India
IS 4139:1989 Calcium silicate bricks. Bureau of Indian Standards, New Delhi, India.
IS 456:2000 Indian standard plain and reinforced concrete code of practice. Bureau of Indian Standards, New Delhi
IS 712:1984 Specification for building limes. Bureau of Indian Standards, New Delhi, India
Lind EE, Grahn M (2011) Directional genetic selection by pulp mill effluent on multiple natural populations of three-spined stickleback (Gasterosteus aculeatus). Ecotoxicology 20:503–512. https://doi.org/10.1007/s10646-011-0639-8
Munir MJ, Kazmi SMS, Wu Y-F et al (2018) Thermally efficient fired clay bricks incorporating waste marble sludge: an industrial-scale study. J Clean Prod 174:1122–1135. https://doi.org/10.1016/j.jclepro.2017.11.060
Raut SP, Sedmake R, Dhunde S et al (2012) Reuse of recycle paper mill waste in energy absorbing light weight bricks. Constr Build Mater 27:247–251. https://doi.org/10.1016/j.conbuildmat.2011.07.053
Rezaee Javan A, Seifi H, Xu S et al (2017) The impact behaviour of plate-like assemblies made of new interlocking bricks: an experimental study. Mater Des 134:361–373. https://doi.org/10.1016/j.matdes.2017.08.056
Saxena R, Siddique S, Gupta T et al (2018) Impact resistance and energy absorption capacity of concrete containing plastic waste. Constr Build Mater 176:415–421. https://doi.org/10.1016/j.conbuildmat.2018.05.019
Searle AB, Grimshaw RW (1959) The chemistry and physics of clays and other ceramic materials
Shivasakthivadivelan RA (2022) (2022) Study on the properties of innovative green brick subjected to varying temperature and time. Int J Coal Prep Util. https://doi.org/10.1080/19392699.2022.2064456
Siddique S, Shrivastava S, Chaudhary S, Gupta T (2018) Strength and impact resistance properties of concrete containing fine bone china ceramic aggregate. Constr Build Mater 169:289–298. https://doi.org/10.1016/j.conbuildmat.2018.02.213
Singh SK, Kulkarni S, Kumar V, Vashistha P (2018) Sustainable utilization of deinking paper mill sludge for the manufacture of building bricks. J Clean Prod 204:321–333. https://doi.org/10.1016/j.jclepro.2018.09.028
Sutcu M, del Coz Díaz JJ, Álvarez Rabanal FP et al (2014) Thermal performance optimization of hollow clay bricks made up of paper waste. Energy Build 75:96–108. https://doi.org/10.1016/j.enbuild.2014.02.006
Xu Y, Li JX, Kan LL (2014) Study on composite cementitious material prepared by calcinating phosphogypsum. Bull Chin Ceram Soc 33:953–958
Zhang WS, Zhang JT, Ye JY et al (2019) Structure and activity of dicalcium silicate. J Chin Ceram Soc 368:146–152
Zmamou H, Leblanc N, Levacher D, Kubiak J (2021) Recycling of high quantities of wastepaper sludge ash for production of blended cements and alternative materials. Environ Technol Innov 23:101524. https://doi.org/10.1016/j.eti.2021.101524
Acknowledgements
Not Applicable.
Funding
Not Applicable.
Author information
Authors and Affiliations
Contributions
Balaji Govindan was involved in the conceptualization, methodology, investigation, and writing—original draft. Vidhya Kumarasamy contributed to the supervision, resources and corrected and reviewed the manuscript.
Corresponding author
Ethics declarations
Conflict of interest
The authors declare no conflict of interest.
Ethical approval
This article does not contain any studies with human participants or animals performed by any authors.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Supplementary Information
Below is the link to the electronic supplementary material.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Govindan, B., Kumarasamy, V. Sustainable utilization of incinerated paper mill sludge ash for the manufacture of building bricks. Clean Techn Environ Policy 25, 2655–2673 (2023). https://doi.org/10.1007/s10098-023-02515-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10098-023-02515-1