Abstract
Hard rocks can be excavated difficultly by some mechanical miners such as roadheaders. Tunnel boring machines (TBMs) can excavate hard rocks, but the cost is high due to low advance rate and high tool wear. The difficulties in hard rock excavation can be overcome by exposing hard rocks to microwave energy while cutting. This study investigates influence of mineralogy on the microwave assisted cutting of igneous rocks. The normal and cutting forces were measured during the cutting tests, and the specific energy values were calculated. The optimum specific energy (SEopt.) values reduce quite steadily with the increasing microwave power. The SEopt. of some tested crystalline rocks first increases at the low power (3 kW) and then decreases at the high power (6 kW). The losses in the SEopt. range from 22.5 to 38.7% at the power of 6 kW. The equations were also developed for the estimation of the SEopt. loss. Concluding remark is that the same rock types may be affected differently by microwave energy because of the different mineral types and percentages, and thus they behave diversely under cutting tests. The derived equations will be useful for the prediction of the SEopt. loss due to the microwave treatment.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Balci C, Bilgin N, Copur H, Tumac D (2016) Development of a portable linear rock cutting machine for selection of mechanical miners by investigating the cuttability of some rocks. Project report, The Scientific and Technological Research Council of Turkey, Project No. 216M003. (in Turkish)
Bisai R, Palaniappan SK, Pal SK (2020) Influence of individual and combined pre-treatment on the strength properties of granite and sandstone. Arab J Geosci. 3:7. https://doi.org/10.1007/s12517-019-5009-5
Chang, S-H, Lee C, Kang T-H, Ha T, Choi S-W (2017) Effect of hardfacing on wear reduction of pick cutters under mixed rock conditions. Geomech Eng 13(1):141–159. https://doi.org/10.12989/gae.2017.13.1.141
Chen TT, Dutrizac JE, Haque KE, Wyslouzil W, Kashyap S (1984) The relative transparency of minerals to microwave radiation. Can Metall Quart 23(3):349–351. https://doi.org/10.1179/cmq.1984.23.3.349
Chen YL, Wang SR, Ni J, Azzam R, Fernandez-Steeger TM (2017) An experimental study of the mechanical properties of granite after high temperature exposure based on mineral characteristics. Eng Geol 220:234–242. https://doi.org/10.1016/j.enggeo.2017.02.010
Comakli R, Balci C, Copur H, Tumac D (2021) Experimental studies using a new portable linear rock cutting machine and verification for disc cutters. Tunn Undergr Spc Tech 108:103702. https://doi.org/10.1016/j.tust.2020.103702
Feng XT, Lu GM, Li YH, Zhang XW (2019) Cutter head for microwave presplitting type hard-rock tunnel boring machine. United States Patent No. 10,428,654 B2. https://patents.google.com/patent/US10428654B2/en
Hartlieb P, Grafe B (2017) Experimental study on microwave assisted hard rock cutting of granite. BHM Berg- und Hüttenmännische Monatshefte 162(2):77–81. https://doi.org/10.1007/s00501-016-0569-0
Hartlieb P, Grafe B, Shepel T, Malovyk A, Akbari B (2017) Experimental study on artificially induced crack patterns and their consequences on mechanical excavation processes. Int J Rock Mech Min Sci 100:160–169. https://doi.org/10.1016/j.ijrmms.2017.10.024
Hassani F, Nekoovaght P (2011) The development of microwave assisted machineries to break hard rocks. In: Proceedings of The 28th International Symposium on Automation and Robotics in Construction, Seoul- Kore, pp. 678–684. https://doi.org/10.22260/ISARC2011/0127
Hassani F, Nekoovaght PM, Gharib N (2016) The influence of microwave irradiation on rocks for microwave assisted underground excavation. J Rock Mech Geotech Eng 8:1–15. https://doi.org/10.1016/j.jrmge.2015.10.004
Hu Q, Shou Z, Zeng J, He L, Tang H, Li B, Chen S, Lu X (2019) Comparative study on the deterioration of granite under microwave irradiation and resistance-heating treatment. Frattura Integr Strutt 50:638–648. https://doi.org/10.3221/IGF-ESIS.50.54
ISRM (2007) The complete ISRM suggested methods for rock characterization, testing and monitoring: 1974–2006. Suggested Methods Prepared by the Commission on Testing Methods, International Society for Rock Mechanics, R. Ulusay and J.A. Hudson (eds.), Compilation Arranged by the ISRM Turkish National Group, Ankara, Turkey, Kozan Ofset
Kahraman S, Canpolat AN, Fener M (2020) The influence of microwave treatment on the compressive and tensile strength of igneous rocks. Int J Rock Mech Min Sci 129:104303. https://doi.org/10.1016/j.ijrmms.2020.104303
Kim K-Y, Jo S-A, Ryu H-W, Cho G-C (2020) Prediction of TBM performance based on specific energy. Geomech Eng 22(6):489–496. https://doi.org/10.12989/gae.2020.22.6.489
Lindroth DP, Morrell RJ, Blair JR (1991) Microwave assisted hard rock cutting. United States Patent No. 5,003,144. https://patents.google.com/patent/US5003144A/en
Lu G, Li Y, Hassani F, Zhang X (2017) The influence of microwave irradiation on thermal properties of main rock-forming minerals. Appl Therm Eng 112:1523–1532. https://doi.org/10.1016/j.applthermaleng.2016.11.015
Lu G, Feng X, Li Y, Hassani F, Zhang X (2019) Experimental investigation on the effects of microwave treatment on basalt heating, mechanical strength, and fragmentation. Rock Mech Rock Eng 52:2535–2549. https://doi.org/10.1007/s00603-019-1743-y
Lu G, Feng X, Li Y, Zhang X (2020) Influence of microwave treatment on mechanical behaviour of compact basalts under different confining pressures. J Rock Mech Geotech Eng 12(2):213–222. https://doi.org/10.1016/j.jrmge.2019.06.009
Motlagh PN (2009) An investigation on the influence of microwave energy on basic mechanical properties of hard rocks. MSc Thesis, Concordia University. https://spectrum.library.concordia.ca/976521/
Motlagh PN (2015) Physical and mechanical properties of rocks exposed to microwave irradiation: potential application to tunnel boring. PhD. Thesis, McGill University. https://escholarship.mcgill.ca/concern/theses/xg94hs56k
Nejati H, Hassani F, Radziszewski P (2012) Experimental investigating of fracture toughness reduction and fracture development in basalt specimens under microwave illumination. In: Proceedings of the 13th ASCE Aerospace Division Conf. on Engineering, Science, Construction, and Operations in Challenging Environments, California, pp. 325–334. https://ascelibrary.org/doi/10.1061/9780784412190.036
Rostami J, Ozdemir L, Neil DM (1994) Performance prediction: a key issue in mechanical hard rock mining. Min Eng 11:1263–1267
Rostami J (2016) Performance prediction of hard rock tunnel boring machines (TBMs) in difficult ground. Tunn Undergr Sp Tech 57:173–182. https://doi.org/10.1016/j.tust.2016.01.009
Peinsitt T, Kuchar F, Moser P, Kargl H, Restner U, Sifferlinger N (2008) Microwave heating of rocks with different water content In: Proceedings of the Microwave Technology in Minerals Eng,neering (Microwave Technology 08), Cape Town, pp. 1–9
Peinsitt T, Kuchar F, Hartlieb P, Moser P, Kargl H, Restner U, Sifferlinger NA (2010) Microwave heating of dry and water saturated basalt, granite and sandstone. Int J Mining Miner Eng 2:18–29. https://doi.org/10.1504/IJMME.2010.031810
Pomeroy CD (1963) Breakage of coal by wedge action: factors affecting breakage by any given shape of tool. Colliery Guardian November 21: 642–648; November 28: 672–677
Qin Y, Tian H, Xu N-X, Chen Y (2020) Physical and mechanical properties of granite after high‑temperature treatment. Rock Mech Rock Eng 53:305–322. https://doi.org/10.1007/s00603-019-01919-0
Saiang C, Miskovsky K (2012) Effect of heat on the mechanical properties of selected rock types- a laboratory study. In: The proceedings of the 12th ISRM International Congress on Rock Mechanics, Beijing, China, p.815–820. https://onepetro.org/isrmcongress/proceedings-abstract/CONGRESS12/All-CONGRESS12/ISRM-12CONGRESS-2011–141/100235
Santamarina C (1989) Rock excavation with microwaves; a literature review. In: The proceedings of the 1989 ASCE Foundation Engineering, Evanston, Illinois. pp. 459–473. https://cedb.asce.org/CEDBsearch/record.jsp?dockey=0060982
Satish H, Ouellet J, Raghavan V, Radziszewski P (2006) Investigating microwave assisted rock breakage for possible space mining applications. Min Techn 115(1):34–40. https://doi.org/10.1179/174328606X101902
Satish H (2005) Exploring microwave assisted rock breakage for possible space mining applications. MSc Thesis, McGill University. https://escholarship.mcgill.ca/concern/theses/pz50gw73f
Shao S, Ranjith PG, Wasantha PLP, Chen BK (2015) Experimental and numerical studies on the mechanical behaviour of Australian Strathbogie granite at high temperatures: an application to geothermal energy. Geothermics 54:96–108. https://doi.org/10.1016/j.geothermics.2014.11.005
Shepel T, Grafea B, Hartliebb P, Drebenstedt C, Malovyk A (2018) Evaluation of cutting forces in granite treated with microwaves on the basis of multiple linear regression analysis. Int J Rock Mech Min Sci 107:69–74. https://doi.org/10.1016/j.ijrmms.2018.04.043
Sygała A, Bukowska M, Janoszek T (2013) High temperature versus geomechanical parameters of selected rocks–the present state of research. J Sustain Min 12:45–51. https://doi.org/10.7424/jsm130407
Walkiewicz JW, Kazonich G, McGill SL (1988) Microwave heating characteristics of minerals and compounds. Miner Metall Proc 39:39–42. https://doi.org/10.1007/BF03449501
Xu XL, Zhang ZZ (2018) Acoustic emission and damage characteristics of granite subjected to high temperature. Adv Mater Sci Eng 8149870. https://doi.org/10.1155/2018/8149870
Yin T, Shu R, Li X, Wang P, Liu X (2016) Comparison of mechanical properties in high temperature and thermal treatment granite. Trans Nonferrous Met Soc China 26:1926–1937. https://doi.org/10.1016/S1003-6326(16)64311-X
Zeng J, Hu O, Chen Y, Shu X, Chen S, He L, Tang H, Lu X (2019) Experimental investigation on structural evolution of granite at high temperature induced by microwave irradiation. Miner Petrol 113:745–754. https://doi.org/10.1007/s00710-019-00681-z
Zheng YL, Zhang QB, Zhao J (2017) Effect of microwave treatment on thermal and ultrasonic properties of gabbro. Appl Therm Eng 127:359–369. https://doi.org/10.1016/j.applthermaleng.2017.08.060
Zhang G, Dang W, Herbst M, Song Z (2020) Complex analysis of rock cutting with consideration of rock tool interaction using distinct element method (DEM). Geomech Eng 20(5):421–432. https://doi.org/10.12989/gae.2020.20.5.421
Acknowledgements
The authors thank E-BERK Company for providing the mini disc cutter. This study is also a part of PhD thesis of Faraz S. Sarbangholi.
Funding
The authors thank the Scientific and Technological Research Council of Turkey (TUBITAK) for the support of the project (Project No. 315M061).
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare no competing interests.
Rights and permissions
About this article
Cite this article
Kahraman, S., Sarbangholi, F.S., Balci, C. et al. The effect of mineralogy on the microwave assisted cutting of igneous rocks. Bull Eng Geol Environ 81, 62 (2022). https://doi.org/10.1007/s10064-021-02561-3
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10064-021-02561-3