Abstract
The Khimti headrace tunnel experienced instability related to tunnel deformations in several tunnel stretches through mica schist and schistose mica gneiss rock mass. The monitored convergence pattern indicated that the tunnel deformation continued for a long period of time after excavation. This paper aims to analyze plastic deformation behavior of the selected four headrace tunnel sections with considerable deformation where extensive deformation monitoring was conducted. The Convergence Law proposed by Sulem et al. (Int J Rock Mech Min Sci Geomech 24(3):145–154, 1987a) for estimating long-term time-dependent deformation, and the convergence confinement method proposed by Carranza-Torres and Fairhurst (Tunn Undergr Space Technol 15(2):187–213, 2000) for estimating tunnel convergences have been used as analytical tools for the assessment. The achieved results are compared, and similarities and differences are discussed. In addition, the results are also verified by three-dimensional (3D) numerical modeling. The achieved results indicated a fairly good match between measured, back-calculated and numerically modeled results. However, one should note that such calculations are highly sensitive to the accuracy and reliability of the estimated input parameters.
Similar content being viewed by others
References
Barla G, Bonini M, Debernardi D et al (2008) Time dependent deformations in squeezing tunnels. The 12th international conference of international association for computer methods and advances in geomechanics, Goa, India
Carranza-Torres C (2004) Elasto-plastic solution of tunnel problems using the generalized form of the Hoek-Brown failure criterion. Int J Rock Mech Min Sci 41(3):480–481
Carranza-Torres C, Fairhurst C (2000) Application of the convergence–confinement method of tunnel design to rock-masses that satisfy the Hoek-Brown failure criterion. Tunn Undergr Space Technol 15(2):187–213
Civil Construction Consortium (CCC), SA-HH JV (2002) Construction Report. Khimti 1 Hydropower Project, Nepal
Crowder JJ, Bawden WF (2004) Review of post-peak parameters and behavior of rock masses: current trends and research.” Rocnews, fall (2004). http://www.rockscience.com
Goel RK, Jethwa JL, Paithankar AG (1995) Indian experience with Q and RMR systems. Tunn Undergr Space Technol 10:97–109
Grimstad E, Barton N (1993) Updating of the Q-system for NMT. Proceedings of the international symposium on sprayed concrete—modern use of wet mix sprayed concrete for underground support, Fagernes, Norwegian Concrete Association, Oslo, Norway
Hermanstad E, Hovelsen M (1998) Khimti Hydropower Project, Nepal—analysis of engineering geology, tunnelling methods and rock support. Diploma Thesis, Norwegian University of Science and Technology, Trondheim, Norway
Hoek E, Diederichs MS (2006) Empirical estimation of rock mass modulus. Int J Rock Mech Min Sci 43:203–215
Hoek E, Marinos P (2000) Predicting tunnel squeezing problems in weak and heterogeneous rockmasses. Tunn Tunn Int Part 1, 32(11):45–51 and Part 2, 32(12):33–36
Hoek E, Carranza-Torres C, Corkum B et al (2002) Hoek-Brown failure criterion—2002 edn. In: Proceedings North American Rock Mechanics Society Meeting, Toronto, Canada
Itasca (2009) FLAC3D User’s manual. http://www.itascacg.com
Jimenez R, Recio D (2011) A linear classifier for probabilistic prediction of squeezing conditions in Himalayan tunnels. Eng Geol 121:101–109
Nasseri MHB, Rao KS, Ramamurthy T (2003) Anisotropic strength and deformational behavior of Himalayan schists. Int J Rock Mech Min Sci 40:3–23
Nepal KM (1999) A review of in situ testing of rock mechanical parameters in hydropower projects of Nepal. J Nepal Geol Soc 19:1–8
Oreste P (2009) The convergence–confinement method: roles and limits in modern geomechanical tunnel design. Am J Appl Sci 6(4):757–771
Panet M (1995) Le calcul des tunnels par la méthode convergence–confinement. Presses de I’ENPC, Paris
Panet M (2001) Recommendations on the convergence confinement method. Association Française des Travaux en Souterrains (AFTES), Version 1, France
Panthi KK (2006) Analysis of engineering geological uncertainties analysis related to tunnelling in himalayan rock mass conditions. Doctoral Thesis at NTNU 2006:41, Department of Geology and Mineral Resources Engineering, Norwegian University of Science and Technology, Norway
Panthi KK (2012) Evaluation of rock bursting phenomena in a tunnel in the Himalayas. Bull Eng Geol Environ 71:761–769. doi:10.1007/s10064-012-0444-5
Panthi KK, Nilsen B (2007) Uncertainty analysis of tunnel squeezing for two tunnel cases from Nepal Himalaya. Int J Rock Mech Min Sci 44:67–76
Shrestha GL (2005) Stress induced problems in Himalaya tunnels with special reference to squeezing. Doctoral Thesis, Department of Geology and Mineral Resources Engineering, Norwegian University of Science and Technology, Norway
Singh B, Jethwa JL, Dube AK, Singh B (1992) Correlation between observed support pressure and rock mass quality. Tunn Undergr Space Technol 7(1):59–74
Sulem J, Panet M, Guenot A (1987a) Closure analysis in deep tunnels. Int J Rock Mech Min Sci Geomech 24(3):145–154
Sulem J, Panet M, Guenot A (1987b) Analytical solution for time dependent displacements in a circular tunnel. Int J Rock Mec Min Sci Geomech 24(3):155–164
Vlachopoulos N, Diederichs MS (2009) Improved longitudinal displacement profiles for convergence confinement analysis of deep tunnels. Rock Mech Rock Eng 42:131–146
Vu TM, Sulem J, Subrin D (2013) Anisotropic closure in squeezing rocks: the example of Saint-Martin-la-Porte access gallery. Rock Mech Rock Eng 46:231–246
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Shrestha, P.K., Panthi, K.K. Analysis of the plastic deformation behavior of schist and schistose mica gneiss at Khimti headrace tunnel, Nepal. Bull Eng Geol Environ 73, 759–773 (2014). https://doi.org/10.1007/s10064-013-0533-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10064-013-0533-0