Abstract
A compact beam collimator for a laser diode (LD) bar fabricated by a simple method is presented. It consists of a single set of microlenses and a cylindrical lens, which are fabricated from SiO2 rods using a fiber-drawing tower. The principle and parameter optimization of this device are investigated numerically using ZEMAX software and illustrated experimentally for a specific LD bar. It is shown that the output beam is well collimated in both the fast-axis and slow-axis directions; the beam quality is greatly enhanced via the redistribution of intensity in the two directions and by eliminating the fill factor for the LD bar.
Similar content being viewed by others
References
Y. L. Zheng, X. D. Zeng, C. Q. Cao, and Z. J. Feng: Proc. SPIE 6782 (2007) 67823A.
R. Geng, F. Zhang, C. C. Wang, and S. S. Jian: J. Opt. Technol. 34 (2008) 728.
F. Zhang, C. C. Wang, R. Geng, Z. Tong, T. G. Ning, and S. S. Jian: Opt. Express 15 (2007) 17038.
D. M. Brown: Proc. SPIE 5175 (2003) 121.
Y. Y. Kong, X. D. Zeng, and Y. Y. An: J. Optoelectron. Laser 1 (2006) 406.
G. X. Zheng, C. L. Du, C. X. Zhou, and C. Y. Zheng: Opt. Eng. 44 (2005) 044203.
B. Jeffries and D. W. Coutts: J. Opt. Soc. Am. B 22 (2005) 2121.
B. Ehlers, K. M. Du, M. Baumann, H. G. Treusch, P. Loosen, and R. Poprawe: Proc. SPIE 3097 (1997) 639.
U. Fornahl, M. Revermann, and J. Meinschien: Proc. SPIE 6876 (2008) 68760X.
T. Possner, B. Messerschmidt, A. Kraeplin, B. Hoefer, and P. Schreiber: Proc. SPIE 3778 (1999) 88.
W. A. Clarkson and D. C. Hanna: Opt. Lett. 21 (1996) 375.
P. W. Milonni and J. H. Eberly: Lasers (Wiley, New York, 1988).
C. Liu, F. Zhang, C. C. Wang, Y. C. Lu, R. Geng, and S. S. Jian: Opt. Rev. 16 (2009) 529.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Geng, R., Lu, Y., Zhang, F. et al. Compact beam collimator for laser diode bar. OPT REV 17, 103–107 (2010). https://doi.org/10.1007/s10043-010-0019-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10043-010-0019-2