Abstract
SOI circuit exhibits excellent performance and rehabilitee but with the component miniaturization trend and the clock frequency increase, the self-heating phenomena that arise from the SOI structure itself must not be underestimated. In order to minimize this problem, several candidates have been identified to replace the buried silicon oxide (SiO2) by high thermal conductive dielectric layers such as HfO2, Si3N4, diamond or Al2O3. In order to elaborate a SOI structure using this kind of innovative buried dielectric, first of all, their direct bonding with silicon has to be studied. In this work, we investigate the bonding thermal behaviour of Si/Al2O3 and Al2O3/Al2O3 direct bonded structures: bondings are submitted to room temperature up to 900 °C annealing. Amorphous or crystallized Al2O3 thin films were used in this study. Bonding energies are measured in an anhydrous atmosphere and bonding defectivity is analysed using scanning acoustic microscope (SAM). With amorphous a-Al2O3 layer, for T > 200 °C, high bonding energy are obtained even if high defect density appeared when annealing temperature exceeded 400–500 °C. Spontaneous debonding phenomena even occurred for a-Al2O3/a-Al2O3 direct bonding. This defectivity, unobservable using infrared camera, may be explained by chemical or structural Al2O3 modification such as gases desorption, internal stress or crystallisation state. Bonding with crystallized Al2O3 film has been also characterized by infrared spectroscopy and complementary analysis. No high defect density is observed with crystallized Al2O3 layer. Based on these results, an Al2O3 bonding mechanism is proposed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Bresson N, Cristoloveanu S, Mazuré C, Letertre F, Iwai H (2005) Integration of buried insoluators with high thermal conductivity in SOI MOSFETs: thermal properties and short channel effects. Solid State Electr 49:1522–1528
Colonna JP, Bocquet M, Molas G, Rochat N, Blaise P, Grampeix H, Licitra C, Lafond D, Masoero L, Vidal V, Barnes JP, Veilllerot M, Yckache K (2011) Study of parasitic trapping in alumina used as blocking oxide for non volatile memories. J Vacuum Sci Tech B 29(1):01AE02-01AE02
De Beaumont (2007) Mise en Oeuvre de diélectriques thermiquement conducteurs dans la technologie de fabrication Smart-Cut de substrats silicium sur isolant. PhD thesis, University of Grenoble
El-Zein MS, Reifsnider KL (1988) Evaluation of GIC of a DCB Specimen Using an Anisotropic Solution. J Compo Tech Res 10(4):151–155
Ericsson P, Bengtsson S, Skarp J, Kanniainen T (1997) Bonded Al2O3-covered Si-wafers for highly thermally conductive SOI-materials. ECS PV 97(36):576
Fournel F, Moriceau H, Ventosa C, Libralesso L, Le Tiec Y, Signamarcheix T, Rieutord F (2008) Low temperature wafer bonding. ECS Trans 16(8):475–488
Fournel F, Continni L, Morales C, Da Fonseca J, Moriceau H (2012) Measurement of bonding energy in an anhydrous nitrogen atmosphere and its application to silicon direct bonding technology. J Appl Phys 111:104907
Jakschik S, Schroeder U, Hecht T, Gutsche M, Seidl H, Bartha JW (2003) Crystallization behavior of thin ALD-Al2O3 films. Thin Solid Films 425:216–220
Mazsara P, Goetz G, Caviglia A, Mckitterick JB (1988) Bonding of silicon wafers for silicon-on-insulator. J Appl Phys 64:4943
Moriceau H, Rayssac O, Aspar B, Ghyselen B (2003) The bonding energy control : an original way to debondable substrates. Electrochem Soc Proc 19:49–56
Puurunen RL, Saarilahti J, Kattelus H (2007) Implementing ALD layer in MEMS processing. Electrochem Soc 11(7):3–14
Puurunen RL, Sunni T, Ylivaara O, Kondo H, Ammar M, Ishida T, Fujita H, Bosseboeuf A, Zaima S, Kattelus H (2011) Direct wafer bonding of atomic layer deposited TiO2 and Al2O3 thin films. Transducers’11
Suni T, Riika L, Puurunen RL, Ylivaara O, Kattelus H, Henttinen K, Ishida T, Fujita H (2010) Bonding of ALD Alumina for advanced SOI substrat. ECS Trans 33(4):137–144
Ventosa C, Rieutord F, Libralesco F, Morales C, Fournel F, Moriceau H (2007) Hydrophilic low-temperature direct wafer bonding. J Appl Phy 104
Vermang B, Goverde H, Lorenz A, Uruena A, Vereecke G, Meersschaut J, Cornagliotti E, Rothschild A, John J, Poortmans J, Mertens R (2011) On the blistering of atomic layer deposited Al2O3 as Si surface passivation. Photovolt Spec Conf PVSC 37:003562–003567
Vincent S, Radu I, Landru D, Letertre F, Rieutord F (2009) A model of interface defect formation in silicon wafer bonding. Appl Phys Lett 94:101914
Yokoyama M, Iida R, Ikku Y, Kim S, Takagi H, Yasuda T, Yamada H, Ichikawa O, Fukuhara N, Hata M, Takenaka M, Takagi S (2013) Formation of III-V-on-Insulator structures on Si by direct wafer bonding. Semicond Sci Tech 28:2013
Zhang L, Jiang HC, Liu C, Dong JW, Chow P (2007) Annealing of Al2O3 thin films prepared by atomic layer deposition. J Phys D Appl Phys 40:3707–3713
Acknowledgments
The authors would like to thank to SOITEC for its financial support.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Beche, E., Fournel, F., Larrey, V. et al. Direct wafer bonding of amorphous or densified atomic layer deposited alumina thin films. Microsyst Technol 21, 953–959 (2015). https://doi.org/10.1007/s00542-015-2437-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00542-015-2437-3