Abstract
A thermodynamic and kinetic model of the converter steelmaking process was developed allowing the analysis of the influence of the technological parameters, such as the amount and addition time of a charge material on the chemical composition of the crude steel. The process of the manganese ore addition to the converter to increase the final content of manganese in the crude steel was simulated. The optimal technological parameters for the enhancement of manganese yield were determined.
Zusammenfassung
Ein thermodynamisches und kinetisches Modell wurde zur Simulation des Sauerstoffblaskonverter Verfahrens entwickelt, womit der Einfluss der technologischen Parameter, wie die Menge und der Zeitpunkt zur Beschickung der Zuschlagsstoffe, auf die Zusammensetzung des Rohstahls untersucht werden kann. Das Verfahren des Einsatzes von Manganerz in den Sauerstoffblaskonverter, um den Endgehalt vom Mangan im Rohstahl zu erhöhen, wurde simuliert. Die optimalen technologischen Parameter zur Steigerung der Manganausbeute wurden bestimmt.
Similar content being viewed by others
References
Barao, C.D.; Malynowskij, A.; da Silva, C. A.: The 6th European Oxygen Steelmaking Conference, Stockholm, Sweden, 2011
Chen, Z.; Xiong, W.; Jiang, X.; Li, G.; Xu, Y.: The 6th European Oxygen Steelmaking Conference, Stockholm, Sweden, 2011
Ohguchi, S.; Robertson, D.G.C.; Deo, B.; Grieveson, P.; Jeffes, J.H.E.: Simultaneous dephosphorization and desulfurization of molten pig iron, Ironmaking and Steelmaking, 11 (1984), no. 4, pp. 202–213
Pahlevani, F.; Kitamura, S.; Shibata, H.; Maruoka, N.: Simulation of steel refining process in converter. Steel Research International, 81 (2010), no. 8, pp. 617–622.
Lytvynyuk, Y.; Schenk, J.; Hiebler, M.; Mizelli, H.: The 6th European Oxygen Steelmaking Conference, Stockholm, Sweden, 2011
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lytvynyuk, Y., Schenk, J., Hiebler, M. et al. Application of Thermodynamic and Kinetic Model for Converter Steelmaking to Optimize Manganese Yield in Crude Steel. Berg Huettenmaenn Monatsh 158, 457–458 (2013). https://doi.org/10.1007/s00501-013-0194-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00501-013-0194-0