Abstract
The influence of homogeneous surfactant and homogeneous polymer solutions on the performance of microbubble skin friction reduction was investigated on an axisymmetric body. Carbon dioxide was injected into water, homogeneous surfactant (Aerosol OT) solutions, and homogeneous dilute polymer (Polyethylene oxide) solutions. Integrated skin friction measurements were obtained at two freestream velocities as a function of gas injection rate and polyethylene-oxide concentration. A moderate (50%) decrease in surface tension had little to no effect on the drag reducing characteristics of microbubble injection. At similar gas injection rates, microbubble injection exhibited more drag reduction in the polymer solutions than obtained with microbubble injection into water. However, the increased drag reduction obtained with polymer additives was no more than a multiplicative factor related to the baseline levels of drag reduction achieved by the individual methods, and suggests the mechanism for microbubble skin friction reduction acts independently of the polymer drag reduction.
Similar content being viewed by others
Author information
Authors and Affiliations
Additional information
Received: 17 April 1998 / Accepted: 12 October 1998
Rights and permissions
About this article
Cite this article
Fontaine, A., Deutsch, S., Brungart, T. et al. Drag reduction by coupled systems: microbubble injection with homogeneous polymer and surfactant solutions. Experiments in Fluids 26, 397–403 (1999). https://doi.org/10.1007/s003480050303
Issue Date:
DOI: https://doi.org/10.1007/s003480050303