Abstract
This paper presents data and analysis related to the compression and the breakdown of a tumbling motion after radial disruption in a simple geometry of the compression chamber of a model engine with large optical access. The disruption is a round jet injection perpendicular to the vorticity tube. Two configurations of injection are selected. They correspond respectively to a straight jet that competes with the tumble and an inclined jet that adds angular momentum to the large-scale rotating motion. The ratio between the angular momentum brought by the spray and the initial angular momentum of the tumble is of the order of 30% and is representative of the direct-injection engine situation at moderate rotation rate. The injection is performed at bottom dead centre (BDC) in a well-defined and well-known tumbling motion. The data are obtained in the symmetry plane of a square chamber by using particle image velocimetry (PIV) and planar laser induced fluorescence (PLIF). A calibration is made in order to take account of acetone fluorescence yield during compression. The analysis of the injection phase at BDC shows that the mean topology of the flow after both injections differs significantly and that the vorticity tube is significantly distorted only in the vicinity of the injection plane. Strong transverse mean flows are detected by analysing the divergence of the mean velocity field. Although a mean rotation is still observed after injection during the compression phase, the authors show that no strong vortex core is evident. An important consequence of this finding, confirmed by the evolution of the global in-plane mean and fluctuating kinetic energy in the symmetry plane is that no vortex breakdown occurs during the compression after the injection event. Therefore, the global fluctuating kinetic energy at the end of the compression is much lower after an injection. During the first half of the compression, an inhomogeneous distribution of the jet fluid in the chamber is detected by the PLIF measurements. The transport of the jet fluid clearly results from both in-plane and out-of-plane motions triggered by the injection jet. This spatial repartition depends strongly on the injection strategy and can be very difficult to control accurately from cycle to cycle. The mixture is more homogeneous at top dead centre (TDC) with a low value of the spatial variance of the mean concentration field.
Similar content being viewed by others
References
Arcoumanis C, Hu Z, Whitelaw JH (1990) Tumbling motion: a mechanism for turbulence enhancement in spark-ignition engines. SAE paper 900060
Arcoumanis C, Whitelaw JH (1987) Fluid mechanics of internal combustion engines—a review. Proc Inst Mech Eng 201:57–74
Bazile R, Stepowki D (1995) Measurement of vaporized and liquid fuel concentration fields in a burning spray jet of acetone using planar laser induced fluorescence. Exp Fluids 20:1–9
Borée J, Marc D, Bazile R, Lecordier B (1999) On the behaviour of a large scale tumbling vortex flow submitted to a compression. In: Proceedings of the European Series in Applied and industrial mathematics (ESAIM): http://www.emath.fr/Maths/Proc, vol 7
Borée J, Maurel S, Bazile R (2002) Disruption of a compressed vortex. Phys Fluids 14:2543–2556
Devesa A, Moreau J, Poinsot T, Helie J (2004) Large eddy simulations of jet/vortex interaction in a GDI model engine flow. SAE F&L Spring paper 20040111997, Toulouse, 8–10 June 2004
Fincham AM, Spedding GR (1997) Low cost, high resolution DPIV for measurement of turbulent fluid flow. Exp Fluids 23:449–462
Fogleman M, Lumley J, Rempfer D, Haworth D (2004) Applications to the proper orthogonal decompositions to data sets of internal combustion engines flows. Journal of Turbulence 5:023
Gosman AD, Tsui YY, Vafidis C (1985) Flow in a model engine with a shrouded valve. A combined experimental and computational study. SAE paper 850498
Grudno AD, Trautwein SE, Wassenberg HJ, Adomeit G (1994) Spatially resolved determination of the turbulent flame speed from CH band emission measurements under engine conditions. SAE paper 940685
Haworth DC, El Tahry SH, Huebler MS, Chang S (1990) Multidimensional port-and-cylinder flow calculation for two-and-four-valves-per-cylinder engines: influence of intake configuration on flow structure. SAE paper 900257
Heywood JB (1988) Internal combustion engines fundamentals. McGraw-Hill, New York
Hill PG, Zhang D (1994) The effects of swirl and tumble on combustion in spark-ignition engines. Prog Energy Combust Sci 20:373–429
Keffer JF, Baines WD (1967) The round turbulent jet in a cross wind. J Fluid Mech 15:481–497
Kloeker JJ, Krause E, Kuwahara K (1992) Vortical structures and turbulent phenomena in a piston engine model. In: Proceedings of the 13th International Conference on Numerical methods in fluid dyanamics, Rome, 6–10 July 1992
Lecordier B (1997) Etude de l’interaction de la propagation d’une flamme prémélangée avec le champ aérodynamique par association de la tomographie laser et de la vélocimétrie par image de particules. Faculté des Sciences de l’Université de Rouen
Lozano A (1992) Laser excited luminescent tracers for planar concentration measurements in gaseous jets. PhD thesis, Stanford University
Lumley JL (1999) Engines. An introduction. Cambridge University Press, Cambridge
Lumley JL (2001) Early work on fluid mechanics in the IC engine. Ann Rev Fluid Mech 33:319–338
Marc D (1998) Etude expérimentale de la compression d’un écoulement de rouleau—situation modèle de l’aérodynamique interne des moteurs à pistons. PhD thesis, I.N.P. Toulouse No. 1423
Maurel S (2001) Etude par imagerie laser de la génération et de la rupture d’un écoulement tourbillonnaire compressé. Situation modèle pour la validation de simulations aux grandes échelles dans les moteurs. PhD thesis, I.N.P. Toulouse
Moreau J (2003) Turbulence et mélange dans une situation modèle de l’interaction entre un jet d’injection directe et une aérodynamique modèle de type tumble. PhD thesis, I.N.P. Toulouse
Moreau J, Borée J, Bazile R, Charnay G (2003) Modification of an experimental model tumbling flow by direct injection. SAE paper 2003-01-0064
Namazian M, Hansen S, Lyford-Pike E, Sanchez-Barsse J, Rife J, Heywood J (1980) Schlieren visualisation of the flow and density fields in the cylinder of a spark ignition engine. SAE paper 800044
Thurber MC (1999) Acetone laser-induced fluorescence for temperature and multiparameter imaging in gaseous flow. PhD thesis, Stanford University
Westerweel J, Dabiri D, Gharib M (1997) The effect of a discrete window offset on the accuracy of cross-correlation analysis of digital PIV recording. Exp Fluids 23:20–28
Zhao FQ (1997) A review of mixture preparation and combustion strategies for DISI gasoline engine. SAE paper 970627
Acknowledgement
This work was carried out under A.R.C. “Moteur Propres et Economes” supported by CNRS Ecotech, Renault, PSA Peugeot–Citroen and ADEME. The technical support of G. Couteau, M. Marchal, E. Cid and S. Cazin is greatly acknowledged.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Moreau, J., Boree, J., Bazile, R. et al. Destabilisation of a compressed vortex by a round jet. Exp Fluids 37, 856–871 (2004). https://doi.org/10.1007/s00348-004-0869-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00348-004-0869-0